scholarly journals Effect of Selected Components on Combustion of Methane

2021 ◽  
Vol 71 (2) ◽  
pp. 61-68
Author(s):  
Chríbik Andrej ◽  
Minárik Matej ◽  
Polóni Marián

Abstract Article discusses the effect of various gases on the combustion of methane in LGW 702 combustion engine intended for use in cogeneration unit. The measured results were evaluated for internal, performance and economic parameters of the combustion engine the ideal operating parameters can be set. The aim of the study was to assess the effect of combustible carbon monoxide and carbon dioxide and nitrogen on the parameters.

2014 ◽  
Vol 16 (29) ◽  
pp. 15289-15298 ◽  
Author(s):  
Pei-Hsing Huang ◽  
Shang-Chao Hung ◽  
Ming-Yueh Huang

We report a multi-component liquid–vapor adsorption study that allowed us to predict the ideal adsorption conditions and to explore the fundamental interaction and adsorption behaviors for formaldehyde, carbon dioxide, carbon monoxide, and water mixtures in GR slit pores.


2018 ◽  
Vol 216 ◽  
pp. 03001 ◽  
Author(s):  
Evgeny Ivanayskiy ◽  
Aleksei Ishkov ◽  
Aleksandr Ivanayskiy ◽  
Iakov Ochakovskii

The paper studies the influence of shielding gas on the composition and the structure of weld joint metal of 30MnB5 steel applied in essential parts of automobiles and tractors. The welding was performed in inert, oxidizing and reducing atmospheres. It was established that TIG welding with argon used as shielding gas did not provide the required mechanical properties when using conventional welding materials. Carbon dioxide during MAG welding caused partial burning of alloying elements. Carbon monoxide used as shielding gas was proved to form reducing atmosphere enabling to obtain chemical composition close to the base metal composition. Metallographic examinations were carried out. The obtained results provided full-strength weld, as well as the required reliability and durability of welded components and joints.


Author(s):  
Douglas P Harrison ◽  
Zhiyong Peng

Hydrogen is an increasingly important chemical raw material and a probable future primary energy carrier. In many current and anticipated applications the carbon monoxide impurity level must be reduced to low-ppmv levels to avoid poisoning catalysts in downstream processes. Methanation is currently used to remove carbon monoxide in petroleum refining operations while preferential oxidation (PROX) is being developed for carbon monoxide control in fuel cells. Both approaches add an additional step to the multi-step hydrogen production process, and both inevitably result in hydrogen loss. The sorption enhanced process for hydrogen production, in which steam-methane reforming, water-gas shift, and carbon dioxide removal reactions occur simultaneously in the presence of a nickel-based reforming catalyst and a calcium-based carbon dioxide sorbent, is capable of producing high purity hydrogen containing minimal carbon monoxide in a single processing step. The process also has the potential for producing pure CO2 that is suitable for subsequent use or sequestration during the sorbent regeneration step. The current research on sorption-enhanced production of low-carbon monoxide hydrogen is an extension of previous research in this laboratory that proved the feasibility of producing 95+% hydrogen (dry basis), but without concern for the carbon monoxide concentration. This paper describes sorption-enhanced reaction conditions – temperature, feed gas composition, and volumetric feed rate – required to produce 95+% hydrogen containing low carbon monoxide concentrations suitable for direct use in, for example, a proton exchange membrane fuel cell.


The spectrum of the flame of carbon monoxide burning in air and in oxygen at reduced pressure has been photographed on plates of high contrast which display the band spectrum clearly above the continuous background. Greater detail has been obtained than has been recorded previously and new measurements are given. The structure of the spectrum has been studied systematically. It is shown that the bands occur in pairs with a separation of about 60 cm. -1 , this separation being due probably to the rotational structure. Various wave-number differences are found to occur frequently, and many of the strong bands are arranged in arrays using intervals of 565 and 2065 cm. -1 . The possible origin of the spectrum is discussed. The choice of emitter is limited to a polyatomic oxide of carbon, of which carbon dioxide is the most likely. The spectrum of the suboxide C 3 O 2 shows some resemblance to the flame bands, but this molecule is improbable as the emitter on other grounds. A peroxide C0 3 is also a possibility, but no evidence for the presence of this has been obtained from experiments on the slow combustion of carbon monoxide. Carbon dioxide in gaseous or liquid form is transparent through the visible and quartz ultra-violet, and the flame bands are not obtained from CO 2 in discharge tubes. Comparison with the Schumann-Runge bands of oxygen shows that it is possible that the flame bands may form part of the absorption band system of CO 2 which is known to exist below 1700 A if there is a big change in shape or size of the molecule in the two electronic states. The electronic energy levels of CO 2 are discussed. Since normal CO 2 is not built up from normal CO and oxygen, an electronic rearrangement of the CO 2 must occur after the combustion process. Mulliken has suggested that the molecule in the first excited electronic state, corresponding to absorption below 1700 A, may have a triangular form. The frequencies obtained from the flame bands are compared with the infra-red frequencies of CO 2 . The 565 interval may be identified with the transverse vibration v 2 , indicating that the excited electronic state is probably triangular in shape. The 2065 interval cannot, however, be identified with the asymmetric vibration v 3 with any certainty. If the excited electronic state of CO 2 is triangular, then molecules formed during the combustion by transitions from this level to the ground state may be “vibrationally activated”. This is probably the reason for many of the peculiarities of the combustion of carbon monoxide.


Sign in / Sign up

Export Citation Format

Share Document