Improved unsteady aerodynamics and flutter for NACA 0012 airfoil at angle of attack

1988 ◽  
Author(s):  
L. HUTTSELL ◽  
F. EASTEP
2019 ◽  
Vol 11 ◽  
pp. 175682931989060
Author(s):  
Dilek Funda Kurtulus

The present paper aims to investigate numerically small amplitude oscillation of NACA 0012 airfoil at Re = 1000. The airfoil is sinusoidally pitching around the quarter chord point with 1° pitch amplitude about a mean angle of attack. The computations are performed for mean angles of attack ranging from 0° to 60° and for pitching frequencies of 1 Hz and 4 Hz. The effect of the mean angle of attack and pitching frequency on the instantaneous forces as well as the vortex structure is investigated in comparison with the non-oscillatory conditions. It was shown that airfoil oscillations at the investigated conditions change the amplitude of oscillation of the aerodynamic loads. The instantaneous drag coefficient is always positive for pitching airfoil at 1 Hz. In the meantime, there are time intervals where instantaneous drag coefficient becomes negative for pitching motion at 4 Hz for mean angles of attack from 3° to 36°.


2015 ◽  
Vol 758 ◽  
pp. 13-19 ◽  
Author(s):  
Erwin ◽  
Slamet Wiyono ◽  
Erny Listijorini ◽  
Rina Lusiani ◽  
Tresna P. Soemardi

Use of NACA 0012 at the Sultan Wind Turbine prototype provide value coefficient power turbine at wind speed 5.5 m / s by 0017 , wind speed 6.1 m / s at 0.015 , wind speed 7.7 m / s at 0.016 , wind speed 6.5 m / s for 0018 and wind speed 6.2 m / s by 0017 . Where the value of the highest efficiency obtained at a speed of 6.5 m / s at 0.018 . This result is not as expected to generate sufficient energy.The next development carried out investigations on some kind of airfoil, from investigations obtained by using Qblade software that NACA 6612 has a value of 1.78 CL at 15 degrees angle of attack is the largest of all the airfoil .In this research, NACA 6612 will be simulated with a variable chord length, angle of attack, and wind speed, of these three variables will be created which will map graphics 3d sliding value of the ratio of the 3 variables, this graph will give recommendations most optimum combination of variables to types are mapped wind speed throughout the year, to produce optimum power.Optimum combination of NACA 6612 with wind speed varied from 2-7 m/s is chord length 30 cm and angle of attack 7 degree.


Aerospace ◽  
2019 ◽  
Vol 6 (3) ◽  
pp. 33
Author(s):  
Sidaard Gunasekaran ◽  
Grant Ross

The use of flexible inverted piezo embedded Polyvinylidene Difluoride (PVDF) as a simultaneous energy harvester and as a wake sensor is explored. The oscillation amplitude (characterized by voltage output) and oscillation frequency of the piezo-embedded PDVF was quantified in the wake of a 2D NACA 0012 model and SD7003 model at a Reynolds number of 100,000 and 67,000, respectively. The performance of the sensor was also quantified in the freestream without the presence of the wing. In order to quantify the sensor response to angle of attack and downstream distance, the amplitude and frequency of oscillations were recorded in the wing wake. Increase in angle of attack of the wing resulted in increase in oscillation frequency and amplitude of the PVDF. The results also indicated that the inverted flag configuration performed better in the wake under unsteady conditions when compared to freestream conditions. The results from Particle Image Velocimetry indicated that the wake signature was not affected by the presence of the PVDF in the wake. The root mean square voltage contours in the wake of SD7003 airfoil show remarkable free shear layer wake features such as upper and lower surface stratification and downwash angle which shows the sensitivity of the sensor to the unsteadiness in the wake. The capability of this device to act as a potential energy harvester and as a sensor has serious implications in extending the mission capabilities of small UAVs.


2019 ◽  
Vol 11 ◽  
pp. 175682931983368 ◽  
Author(s):  
Yasir A ElAwad ◽  
Eltayeb M ElJack

High-fidelity large eddy simulation is carried out for the flow field around a NACA-0012 aerofoil at Reynolds number of [Formula: see text], Mach number of 0.4, and various angles of attack around the onset of stall. The laminar separation bubble is formed on the suction surface of the aerofoil and is constituted by the reattached shear layer. At these conditions, the laminar separation bubble is unstable and switches between a short bubble and an open bubble. The instability of the laminar separation bubble triggers a low-frequency flow oscillation. The aerodynamic coefficients oscillate accordingly at a low frequency. The lift and the drag coefficients compare very well to recent high-accuracy experimental data, and the lift leads the drag by a phase shift of [Formula: see text]. The mean lift coefficient peaks at the angle of attack of [Formula: see text], in total agreement with the experimental data. The spectra of the lift coefficient does not show a significant low-frequency peak at angles of attack lower than or equal the stall angle of attack ([Formula: see text]). At higher angles of attack, the spectra show two low-frequency peaks and the low-frequency flow oscillation is fully developed at the angle of attack of [Formula: see text]. The behaviour of the flow-field and changes in the turbulent kinetic energy over one low-frequency flow oscillation cycle are described qualitatively.


2015 ◽  
Vol 137 (9) ◽  
Author(s):  
V. G. Chapin ◽  
E. Benard

The active control of the leading-edge (LE) separation on the suction surface of a stalled airfoil (NACA 0012) at a Reynolds number of 106 based on the chord length is investigated through a computational study. The actuator is a steady or unsteady jet located on the suction surface of the airfoil. Unsteady Reynolds-Averaged Navier–Stokes (URANS) equations are solved on hybrid meshes with the Spalart–Allmaras turbulence model. Simulations are used to characterize the effects of the steady and unsteady actuation on the separated flows for a large range of angle of attack (0 < α < 28 deg). Parametric studies are carried out in the actuator design-space to investigate the control effectiveness and robustness. An optimal actuator position, angle, and frequency for the stalled angle of attack α = 19 deg are found. A significant increase of the lift coefficient is obtained (+ 84% with respect to the uncontrolled reference flow), and the stall is delayed from angle of attack of 18 deg to more than 25 deg. The physical nonlinear coupling between the actuator position, velocity angle, and frequency is investigated. The critical influence of the actuator location relative to the separation location is emphasized.


2020 ◽  
Vol 5 (1) ◽  
pp. 35-40
Author(s):  
Ali Akbar

Airfoil is an aerodynamic form intended to produce a lift force with the smallest drag force. When an airfoil is passed through a fluid flow that causes interaction between the air flow and the surface, variations in velocity and pressure will occur along the top and bottom surfaces of the airfoil, as well as the front and back of the airfoil. The difference in pressure between the upper and lower surface of the airfoil is what causes the resultant force in the direction perpendicular to the direction of fluid flow, this force is called the lift force (lift). In this experiment NACA 0012 airfoil experiments have been carried out using simple wind tunnel. Experiments were conducted with the aim to determine the effect of the angle of attack on the performance of the NACA 0012 airfoil which then analyzed the lift force of the NACA 0012 airfoil. The variation of the angle of attack used was 0 °, 3 °, 6 °, 9 °, 12 °, and 15 ° and used wind speed of 21.5 m / s. The greatest lift force is obtained at an angle of attack of 9 ° with a value of 0.981 while the largest lifting coefficient with a value of 0.106. The greater the angle of attack the greater the airfoil lift force, but for symmetrical airfoil stall at an angle that is too large


Sign in / Sign up

Export Citation Format

Share Document