scholarly journals AXIAL RATIO TUNED CIRCULARLY POLARIZED SLOT-LOADED ANTENNA FOR S-BAND AND C-BAND APPLICATIONS

2021 ◽  
Vol 113 ◽  
pp. 239-249
Author(s):  
Ramya Radhakrishnan ◽  
Shilpi Gupta
Keyword(s):  
Axial Ratio ◽  
Circularly Polarized ◽  
Loaded Antenna

A Broadband Circularly Polarized Cross-slotted Patch Antenna with Horizontal Meandered Strip (HMS)

Frequenz ◽  
2020 ◽  
Vol 74 (5-6) ◽  
pp. 191-199
Author(s):  
M. K. Verma ◽  
Binod K. Kanaujia ◽  
J. P. Saini ◽  
Padam S. Saini
Keyword(s):  
Circular Polarization ◽  
Patch Antenna ◽  
Impedance Matching ◽  
Axial Ratio ◽  
Impedance Bandwidth ◽  
Radiation Patterns ◽  
Circularly Polarized ◽  
Feeding Technique

AbstractA broadband circularly polarized slotted square patch antenna with horizontal meandered strip (HMS) is presented and studied. The HMS feeding technique provides the good impedance matching and broadside symmetrical radiation patterns. A set of cross asymmetrical slots are etched on the radiating patch to realize the circular polarization. An electrically small stub is added on the edge of the antenna for further improvement in performance. Measured 10-dB impedance bandwidth (IBW) and 3-dB axial ratio bandwidth (ARBW) of the proposed antenna are 32.31 % (3.14–4.35 GHz) and 20.91 % (3.34–4.12 GHz), respectively. The gain of the antenna is varied from 3.5 to 4.86dBi within 3-dB ARBW. Measured results matched well with the simulated results.

Bilayer split-ring chiral metamaterial based reconfigurable antenna for polarization conversion

Frequenz ◽  
2021 ◽  
Vol 0 (0) ◽  
Author(s):  
Preet Kaur ◽  
Pravin R. Prajapati
Keyword(s):  
Low Cost ◽  
Axial Ratio ◽  
Center Frequency ◽  
Impedance Bandwidth ◽  
Split Ring ◽  
Circularly Polarized ◽  
Left Hand ◽  
Rectangular Patch ◽  
Mode 2 ◽  
Chiral Metamaterial

Abstract A bilayer split-ring chiral metamaterial converts the linearly polarized wave, into a nearly perfect left or right-handed circularly polarized wave. The proposed antenna is intended to operate at center frequency of 5.80 GHz with switchable polarization capability. The polarization re-configurability is achieved by electronically switching of two PIN-diode pairs, which are embedded into bilayer split-ring Chiral Metamaterial. The optimized length of rectangular patch is 16 mm and width is 12.1 mm. Two types of radiation characteristics offered by the proposed antenna; left hand circularly polarized in mode 1 and right hand circularly polarized in mode 2. Measured results show that its impedance bandwidth is 155 MHz from 5.70 to 5.855 GHz for both mode 1 and mode 2. The measured axial-ratio bandwidth is 100 MHz from 5.75 to 5.85 GHz for mode 1 and 110 MHz from 5.73 to 5.84 GHz for mode 2. Antenna has LHCP gain of 2.52 dBi and RHCP gain of −23 dBi in mode 1. RHCP gain of 2 dBi and polarization purity of about −20 dBi is obtained in mode 2. The proposed antenna has simple structure, low cost and it has potential application in field of wireless communication (i.e., WiMax, WLAN etc.).

A Single-Layer Dual Circularly Polarized SIW Cavity-Backed Patch Filtenna With Wide Axial Ratio Bandwidth

2021 ◽  
pp. 1-1
Author(s):  
Wenlei Wang ◽  
Huayan Jin ◽  
Weiliang Yu ◽  
Xiao Hong Zhang ◽  
Fan Wu ◽  
...  
Keyword(s):  
Single Layer ◽  
Axial Ratio ◽  
Circularly Polarized

scholarly journals Modified Dual-Band Stacked Circularly Polarized Microstrip Antenna

2013 ◽  
Vol 2013 ◽  
pp. 1-5 ◽  
Author(s):  
Guo Liu ◽  
Liang Xu ◽  
Yi Wang
Keyword(s):  
Radiation Pattern ◽  
Global Positioning System ◽  
Microstrip Antenna ◽  
High Performance ◽  
Axial Ratio ◽  
Dual Band ◽  
Optimized Design ◽  
Positioning System ◽  
Circularly Polarized ◽  
Global Positioning

A novel high-performance circularly polarized (CP) antenna is proposed in this paper. Two separate antennas featuring the global positioning system (GPS) dual-band operation (1.575 GHz and 1.227 GHz for L1 band and L2 band, resp.) are integrated with good isolation. To enhance the gain at low angle, a new structure of patch and two parasitic metal elements are introduced. With the optimized design, good axial ratio and near-hemispherical radiation pattern are obtained.

A novel design of circularly polarized ring CDRA with wideband impedance bandwidth using slotted microstrip feed line for X-band applications

2021 ◽  
pp. 1-10
Author(s):  
Chandravilash Rai ◽  
Sanjai Singh ◽  
Ashutosh Kumar Singh ◽  
Ramesh Kumar Verma
Keyword(s):  
Axial Ratio ◽  
Impedance Bandwidth ◽  
Dielectric Resonator Antenna ◽  
Circularly Polarized ◽  
Feed Line ◽  
X Band ◽  
Novel Design ◽  
Two Hybrid ◽  
Microstrip Feed Line ◽  
Microstrip Feed

Abstract A circularly polarized ring cylindrical dielectric resonator antenna (ring-CDRA) of wideband impedance bandwidth is presented in this article. The proposed ring CDRA consist of an inverted rectangular (tilted rectangular) shaped aperture and inverted L-shaped slotted microstrip feed line. The tilted rectangular shaped aperture and inverted L-shaped microstrip feed line generate two-hybrid mode HEM11δ and HEM12δ while ring CDRA and slotted microstrip feed line are used for the enhancement of impedance bandwidth. The proposed ring CDRA is resonating between 6.08 and 12.2 GHz with 66.95% (6120 MHz) impedance bandwidth. The axial ratio (AR) bandwidth of 6.99% (780 MHz) is obtained between 10.76 and 11.54 GHz with a minimum AR value of 0.2 dB at a frequency of 11 GHz. The proposed geometry of ring CDRA has been validated with measurement performed by VNA and anechoic chamber. The operating range of the proposed radiator is useful for different applications in X-band.

scholarly journals CPW-fed circularly-polarized antenna array with high front-to-back ratio and low-profile

Open Physics ◽  
2018 ◽  
Vol 16 (1) ◽  
pp. 651-655 ◽  
Author(s):  
Yilin Liu ◽  
Kama Huang
Keyword(s):  
Antenna Array ◽  
Coplanar Waveguide ◽  
Ground Plane ◽  
Axial Ratio ◽  
Antenna Design ◽  
Impedance Bandwidth ◽  
Feeding Method ◽  
Circularly Polarized ◽  
Low Profile ◽  
Novel Design

Abstract A novel design of a coplanar waveguide (CPW) feed antenna array with circular polarization (CP) and a high front-to-back ratio is described. The proposed CP array is achieved by using a compact CPW–slotline transition network etched in the ground plane. The measured results show that this kind of feeding method can improve the impedance bandwidth, as well as the axial ratio bandwidth of the CP antenna array and provide adequate gain. The proposed array can achieve a 6.08% impedance bandwidth and a 4.10% CP bandwidth. Details of the antenna design and experimental results are presented and discussed.

scholarly journals X-band compact dual circularly polarized isoflux antenna for nanosatellite applications

2017 ◽  
Vol 9 (7) ◽  
pp. 1509-1516 ◽  
Author(s):  
Eric Arnaud ◽  
Cyrille Menudier ◽  
Jamil Fouany ◽  
Thierry Monediere ◽  
Marc Thevenot
Keyword(s):  
Circular Polarization ◽  
Microstrip Line ◽  
Ground Plane ◽  
Axial Ratio ◽  
Horn Antenna ◽  
Azimuth Angle ◽  
Original Solution ◽  
Circularly Polarized ◽  
X Band

This paper presents an original solution to design a compact dual circularly polarized isoflux antenna for nanosatellite applications. This kind of antenna has been previously designed in our laboratory, for a single circular polarization. This antenna is composed of a dual circularly polarized feed and a choke horn antenna. This feed is a cross-shaped slot in the ground plane, which provides coupling between a patch and a ring microstrip line with two ports. It is located at the center of a choke horn antenna. The simulated antenna presents an axial ratio <3 dB and a realized gain close to 0 dB over a 400 MHz bandwidth (8.0–8.4 GHz) at the limit of coverage, i.e. 65° whatever the azimuth angle (φ) and the port. A 20 dB matching for each port and 13 dB isolation characteristics between the two ports have been achieved on this bandwidth. It has been realized and successfully measured.

Sign in / Sign up

Export Citation Format

Share Document