Numerical Investigations Of Deteriorated Heat Transfer Phenomenon For Supercritical Water Flow In Vertical Tubes

2021 ◽  
Author(s):  
Rohit Maitri ◽  
Huirui Han ◽  
Chao Zhang ◽  
Jin Jiang
Keyword(s):  
Heat Transfer ◽  
Water Flow ◽  
Supercritical Water ◽  
Numerical Investigations ◽  
Transfer Phenomenon ◽  
Heat Transfer Phenomenon ◽  
Vertical Tubes

Numerical Study to Analyze the Effects of Hot/Cold Aisle Configurations on Heat Transfer Phenomenon in a Data Center

2013 ◽  
Author(s):  
Kamran Nazir ◽  
Naveed Durrani ◽  
Imran Akhtar ◽  
M. Saif Ullah Khalid
Keyword(s):  
Heat Transfer ◽  
Data Center ◽  
Data Centers ◽  
Cooling System ◽  
Numerical Study ◽  
High Energy ◽  
Research Area ◽  
Transfer Phenomenon ◽  
Heat Transfer Phenomenon ◽  
Active Research

Due to high energy demands of data centers and the energy crisis throughout the world, efficient heat transfer in a data center is an active research area. Until now major emphasis lies upon study of air flow rate and temperature profiles for different rack configurations and tile layouts. In current work, we consider different hot aisle (HA) and cold aisle (CA) configurations to study heat transfer phenomenon inside a data center. In raised floor data centers when rows of racks are parallel to each other, in a conventional cooling system, there are equal number of hot and cold aisles for odd number of rows of racks. For even number of rows of racks, whatever configuration of hot/cold aisles is adopted, number of cold aisles is either one greater or one less than number of hot aisles i.e. two cases are possible case A: n(CA) = n(HA) + 1 and case B: n(CA) = n(HA) − 1 where n(CA), n(HA) denotes number of cold and hot aisles respectively. We perform numerical simulations for two (case1) and four (case 2) racks data center. The assumption of constant pressure below plenum reduces the problem domain to above plenum area only. In order to see which configuration provides higher heat transfer across servers, we measure heat transfer across servers on the basis of temperature differences across racks, and in order to validate them, we find mass flow rates on rack outlet. On the basis of results obtained, we conclude that for even numbered rows of rack data center, using more cold aisles than hot aisles provide higher heat transfer across servers. These results provide guidance on the design and layout of a data center.

Supercritical water heat transfer in vertical tubes: A look-up table

2008 ◽  
Vol 50 (2-6) ◽  
pp. 532-538 ◽  
Author(s):  
Matthias F. Loewenberg ◽  
Eckart Laurien ◽  
Andreas Class ◽  
Thomas Schulenberg
Keyword(s):  
Heat Transfer ◽  
Supercritical Water ◽  
Look Up Table ◽  
Vertical Tubes

Influence of special water properties variation on the heat transfer of supercritical water flow around a sphere

2020 ◽  
Vol 222 ◽  
pp. 115698 ◽  
Author(s):  
Zhenqun Wu ◽  
Yifei Ren ◽  
Guobiao Ou ◽  
Hui Jin
Keyword(s):  
Heat Transfer ◽  
Water Flow ◽  
Supercritical Water ◽  
Water Properties

CONSIDERATION OF BUOYANCE FORCES WHEN SIMULATING SUPERCRITICAL WATER FLOW IN VERTICAL TUBES

2017 ◽  
Author(s):  
Nataliia Fialko ◽  
◽  
Julii Sherenkovskiy ◽  
Nataliia Meranova ◽  
Serhii Aleshko ◽  
...  
Keyword(s):  
Computer Simulation ◽  
Water Flow ◽  
Supercritical Water ◽  
Flow Characteristics ◽  
Buoyancy Forces ◽  
Vertical Tubes

The results of computer simulation of supercritical water flow in tubes are presented. The regularities of the influence of buoyancy forces on the flow characteristics are investigated.

Comparison of Three-Rod Bundle Data With Existing Heat-Transfer Correlations for Bare Vertical Tubes

2010 ◽  
Author(s):  
Krysten King ◽  
Amjad Farah ◽  
Sahil Gupta ◽  
Sarah Mokry ◽  
Igor Pioro
Keyword(s):  
Heat Transfer ◽  
Supercritical Water ◽  
Annular Channel ◽  
Inlet Temperature ◽  
Outlet Temperature ◽  
Rod Bundle ◽  
Nuclear Systems ◽  
Heat Transfer Correlations ◽  
Vertical Tubes ◽  
Bare Tube

Many heat-transfer correlations exist for bare tubes cooled with SuperCritical Water (SCW). However, there is very few correlations that describe SCW heat transfer in bundles. Due to the lack of extensive data on bundles, a limited dataset on heat transfer in a SCW-cooled bundle was studied and analyzed using existing bare-tube correlations to find the best-fit correlation. This dataset was obtained by Razumovskiy et al. (National Technical University of Ukraine “KPI”) in SCW flowing upward in a vertical annular channel (1-rod channel) and tight 3-rod bundle consisting of tubes of 5.2-mm outside diameter and 485-mm heated length. The heat-transfer data were obtained at pressures of 22.5, 24.5, and 27.5 MPa, mass flux within a range from 800 to 3000 kg/m2s, inlet temperature from 125 to 352°C, outlet temperature up to 372°C and heat flux up to 4.6 MW/m2. The objective of this study is to compare bare-tube SCW heat-transfer correlations with the data on 1- and 3-rod bundles. This work is in support of SuperCritical Water-cooled Reactors (SCWRs) as one of the six concepts of Generation-IV nuclear systems. SCWRs will operate at pressures of ∼25MPa and inlet temperatures of 350°C.

Sign in / Sign up

Export Citation Format

Share Document