scholarly journals Novel Hierarchical Fe(III)-Doped Cu-MOFs With Enhanced Adsorption of Benzene Vapor

2019 ◽  
Vol 7 ◽  
Author(s):  
Xuejiao Sun ◽  
Xiulian Gu ◽  
Wentao Xu ◽  
Wen-Jie Chen ◽  
Qibin Xia ◽  
...  
Keyword(s):  
Benzene Vapor ◽  
Enhanced Adsorption

One-pot synthesis of silicon-based zirconium phosphate for the enhanced adsorption of Sr (II) from the contaminated wastewater

2021 ◽  
Vol 318 ◽  
pp. 111016
Author(s):  
Zihao Jiao ◽  
Yiguo Meng ◽  
Chunlin He ◽  
Xiangbiao Yin ◽  
Xinpeng Wang ◽  
...  
Keyword(s):  
Zirconium Phosphate ◽  
One Pot ◽  
One Pot Synthesis ◽  
Enhanced Adsorption ◽  
Silicon Based

scholarly journals Preparation and Gas Sensing Properties of PANI/SnO2 Hybrid Material

Polymers ◽  
2021 ◽  
Vol 13 (9) ◽  
pp. 1360
Author(s):  
Qiaohua Feng ◽  
Huanhuan Zhang ◽  
Yunbo Shi ◽  
Xiaoyu Yu ◽  
Guangdong Lan
Keyword(s):  
Hybrid Material ◽  
Room Temperature ◽  
Tin Dioxide ◽  
Gas Adsorption ◽  
Gas Sensing ◽  
Oxidative Polymerization ◽  
Environmental Pollutants ◽  
Decomposition Temperature ◽  
Benzene Vapor ◽  
Thermo Gravimetric Analyzer

A sensor operating at room temperature has low power consumption and is beneficial for the detection of environmental pollutants such as ammonia and benzene vapor. In this study, polyaniline (PANI) is made from aniline under acidic conditions by chemical oxidative polymerization and doped with tin dioxide (SnO2) at a specific percentage. The PANI/SnO2 hybrid material obtained is then ground at room temperature. The results of scanning electron microscopy show that the prepared powder comprises nanoscale particles and has good dispersibility, which is conducive to gas adsorption. The thermal decomposition temperature of the powder and its stability are measured using a differential thermo gravimetric analyzer. At 20 °C, the ammonia gas and benzene vapor gas sensing of the PANI/SnO2 hybrid material was tested at concentrations of between 1 and 7 ppm of ammonia and between 0.4 and 90 ppm of benzene vapor. The tests show that the response sensitivities to ammonia and benzene vapor are essentially linear. The sensing mechanisms of the PANI/SnO2 hybrid material to ammonia and benzene vapors were analyzed. The results demonstrate that doped SnO2 significantly affects the sensitivity, response time, and recovery time of the PANI material.

Enhanced adsorption of polystyrene nanoplastics (PSNPs) onto oxidized corncob biochar with high pyrolysis temperature

2021 ◽  
Vol 784 ◽  
pp. 147115
Author(s):  
Abdoul Salam Issiaka Abdoul Magid ◽  
Md. Shafiqul Islam ◽  
Yali Chen ◽  
Liping Weng ◽  
Jinbo Li ◽  
...  
Keyword(s):  
Pyrolysis Temperature ◽  
Enhanced Adsorption

scholarly journals Enhanced Adsorption of Bisphenol A from Aqueous Solution with 2-Vinylpyridine Functionalized Magnetic Nanoparticles

Polymers ◽  
2018 ◽  
Vol 10 (10) ◽  
pp. 1136 ◽  
Author(s):  
Qiang Li ◽  
Fei Pan ◽  
Wentao Li ◽  
Dongya Li ◽  
Haiming Xu ◽  
...  
Keyword(s):  
Bisphenol A ◽  
Aqueous Solutions ◽  
Adsorption Capacity ◽  
Magnetic Nanoparticle ◽  
Maximum Adsorption Capacity ◽  
Salting Out ◽  
Functionalized Magnetic Nanoparticles ◽  
Ft Ir ◽  
Fe3o4 Nanospheres ◽  
Enhanced Adsorption

In this study, a novel 2-vinylpyridine functionalized magnetic nanoparticle (Mag-PVP) was successfully prepared. The prepared Mag-PVP was characterized by transmission electronic microscopy (TEM), Fourier transform infrared spectrophotometry (FT-IR), vibrating sample magnetometry (VSM) and thermogravimetric analysis (TGA), and was used for the adsorption of bisphenol A (BPA) from aqueous solutions. Mag-PVP, which is composed of Fe3O4 nanoparticles and poly divinylbenzene-2-vinylpyridine (with a thickness of 10 nm), exhibited magnetic properties (Ms = 44.6 emu/g) and thermal stability. The maximum adsorption capacity (Qm) of Mag-PVP for BPA obtained from the Langmuir isotherm was 115.87 mg/g at 20 °C, which was more than that of Fe3O4 nanospheres. In the presence of NaCl, the improved adsorption capacity of Mag-PVP was probably attributed to the screening effect of Mag-PVP surface charge and salting-out effect. In the presence of CaCl2 and humic acid (HA), the adsorption capacity of BPA decreased due to competitive adsorption. The adsorption of BPA by Mag-PVP increased slightly with the increase in pH from 3.0 to 5.0 and obtained the largest adsorption amount at pH 5.0, which was probably attributed to hydrogen bonding interactions. Moreover, in actual water, Mag-PVP still showed excellent adsorption performance in removing BPA. The high adsorption capacity and excellent reusability performance in this work indicated that Mag-PVP was an effective adsorbent for removing BPA from aqueous solutions.

Sign in / Sign up

Export Citation Format

Share Document