scholarly journals Boosting the H2 Production Efficiency via Photocatalytic Organic Reforming: The Role of Additional Hole Scavenging System

Catalysts ◽  
2021 ◽  
Vol 11 (12) ◽  
pp. 1423
Author(s):  
Yamen AlSalka ◽  
Osama Al-Madanat ◽  
Amer Hakki ◽  
Detlef W. Bahnemann

The simultaneous photocatalytic H2 evolution with environmental remediation over semiconducting metal oxides is a fascinating process for sustainable fuel production. However, most of the previously reported photocatalytic reforming showed nonstoichiometric amounts of the evolved H2 when organic substrates were used. To explain the reasons for this phenomenon, a careful analysis of the products and intermediates in gas and aqueous phases upon the photocatalytic hydrogen evolution from oxalic acid using Pt/TiO2 was performed. A quadrupole mass spectrometer (QMS) was used for the continuous flow monitoring of the evolved gases, while high performance ion chromatography (HPIC), isotopic labeling, and electron paramagnetic resonance (EPR) were employed to understand the reactions in the solution. The entire consumption of oxalic acid led to a ~30% lower H2 amount than theoretically expected. Due to the contribution of the photo-Kolbe reaction mechanism, a tiny amount of formic acid was produced then disappeared shortly after the complete consumption of oxalic acid. Nevertheless, a much lower concentration of formic acid was generated compared to the nonstoichiometric difference between the formed H2 and the consumed oxalic acid. Isotopic labeling measurements showed that the evolved H2, HD, and/or D2 matched those of the solvent; however, using D2O decreased the reaction rate. Interestingly, the presence of KI as an additional hole scavenger with oxalic acid had a considerable impact on the reaction mechanism, and thus the hydrogen yield, as indicated by the QMS and the EPR measurements. The added KI promoted H2 evolution to reach the theoretically predictable amount and inhibited the formation of intermediates without affecting the oxalic acid degradation rate. The proposed mechanism, by which KI boosts the photocatalytic performance, is of great importance in enhancing the overall energy efficiency for hydrogen production via photocatalytic organic reforming.

1991 ◽  
Vol 46 (7) ◽  
pp. 625-629 ◽  
Author(s):  
Hak-Jin Jung ◽  
Nikola Getoff

The radiolysis of methanol in the presence of air as well as of pure oxygen (1 to 5atm) was investigated, the yields of the major products: carboxylic acids (by far predominantly formic acid), oxalic acid, formaldehyde and glycolaldehyde were determined as a function of the absorbed dose. In addition small amounts (G≤0.05) of glyoxal, glyoxalic acid and glycolic acid were also detected. Based on the results a possible reaction mechanism is presented.


Water ◽  
2020 ◽  
Vol 12 (6) ◽  
pp. 1523 ◽  
Author(s):  
Arnaud Igor Ndé-Tchoupé ◽  
Rui Hu ◽  
Willis Gwenzi ◽  
Achille Nassi ◽  
Chicgoua Noubactep

Metallic iron (Fe0) has been demonstrated as an excellent material for decentralized safe drinking water provision, wastewater treatment and environmental remediation. An open issue for all these applications is the rational material selection or quality assurance. Several methods for assessing Fe0 quality have been presented, but all of them are limited to characterizing its initial reactivity. The present study investigates H2 evolution in an acidic solution (pH 2.0) as an alternative method, while comparing achieved results to those of uranium removal in quiescent batch experiments at neutral pH values. The unique feature of the H2 evolution experiment is that quantitative H2 production ceased when the pH reached a value of 3.1. A total of twelve Fe0 specimens were tested. The volume of molecular H2 produced by 2.0 g of each Fe0 specimen in 560 mL H2SO4 (0.01 M) was monitored for 24 h. Additionally, the extent of U(VI) (0.084 mM) removal from an aqueous solution (20.0 mL) by 0.1 g of Fe0 was characterized. All U removal experiments were performed at room temperature (22 ± 2 °C) for 14 days. Results demonstrated the difficulty of comparing Fe0 specimens from different sources and confirmed that the elemental composition of Fe0 is not a stand-alone determining factor for reactivity. The time-dependent changes of H2 evolution in H2SO4 confirmed that tests in the neutral pH range just address the initial reactivity of Fe0 materials. In particular, materials initially reacting very fast would experience a decrease in reactivity in the long-term, and this aspect must be incorporated in designing novel materials and sustainable remediation systems. An idea is proposed that could enable the manufacturing of intrinsically long-term efficient Fe0 materials for targeted operations as a function of the geochemistry.


ACS Catalysis ◽  
2020 ◽  
Vol 10 (7) ◽  
pp. 4112-4126 ◽  
Author(s):  
Saurabh Bhandari ◽  
Srinivas Rangarajan ◽  
Christos T. Maravelias ◽  
James A. Dumesic ◽  
Manos Mavrikakis

1970 ◽  
Vol 48 (2) ◽  
pp. 271-276 ◽  
Author(s):  
B. J. Rezansoff ◽  
K. J. McCallum ◽  
R. J. Woods

Saturated aqueous chloroform solutions (0.07 M) with pH ranging from 0.8 to 12.6 have been irradiated with 60Co γ-radiation in the presence and absence of air. G(Cl− + ClO−) increases with increasing pH in the pH range 1–3 (aerated solutions) or 3–6 (deaerated solutions) and again at pH greater than 10.5. The variation in yield from aerated solutions in the region pH 1–3 is attributed to competition between chloroform and hydrogen ions for hydrated electrons. However, such competition cannot account for the pH effect observed in deaerated solutions between pH 3 and 6. Increased yields from both aerated and deaerated solutions at high pH are attributed to the formation of O− by reaction of hydroxyl radicals and hydroxide ions. Formic acid and oxalic acid have been identified as minor products when aerated chloroform solutions are irradiated.


2015 ◽  
Vol 17 (16) ◽  
pp. 11088-11094 ◽  
Author(s):  
Ellie L. Uzunova ◽  
Nicola Seriani ◽  
Hans Mikosch

The CO2 hydrogenation to methanol using dissociated water as the hydrogen source proceeds via stable carboxyl, formic acid and formaldehyde intermediates.


2014 ◽  
Vol 26 (3) ◽  
pp. 662-672 ◽  
Author(s):  
Yingying Chen ◽  
Yongbing Xie ◽  
Jun Yang ◽  
Hongbin Cao ◽  
Yi Zhang

2015 ◽  
Vol 119 (19) ◽  
pp. 4347-4357 ◽  
Author(s):  
Matthew K. Louie ◽  
Joseph S. Francisco ◽  
Marco Verdicchio ◽  
Stephen J. Klippenstein ◽  
Amitabha Sinha

Sign in / Sign up

Export Citation Format

Share Document