scholarly journals Charge Compensation in Europium-Doped Hafnia Nanoparticles: Solvothermal Synthesis and Colloidal Dispersion

Crystals ◽  
2021 ◽  
Vol 11 (9) ◽  
pp. 1042
Author(s):  
Xavier H. Guichard ◽  
Francesco Bernasconi ◽  
Alessandro Lauria
Keyword(s):  
Low Temperature ◽  
Hafnium Oxide ◽  
Aqueous Media ◽  
Charge Compensation ◽  
Colloidal Dispersion ◽  
X Ray Diffraction ◽  
X Ray ◽  
Wide Range ◽  
Direct Formation ◽  
Enhanced Luminescence

Effective charge compensation of europium in hafnium oxide nanoparticles was achieved at low temperature, allowing high doping incorporation (up to 6 at.%) and enhanced luminescence. The efficiency of the incorporation and charge compensation was confirmed by scanning electron microscope energy dispersive X-ray spectroscopy and powder X-ray diffraction measurements. Despite the known polymorphism of hafnium oxide, when doped to a concentration above 3 at.%, only the pure monoclinic phase was observed up to 6 at.% of europium. Furthermore, the low-temperature solvothermal route allowed the direct formation of stable dispersions of the synthesized material over a wide range of concentrations in aqueous media. The dispersions were studied by diffuse light scattering (DLS) to evaluate their quality and by photoluminescence to investigate the incorporation of the dopants into the lattice.

New high- and low-temperature apparatus for synchrotron polycrystalline X-ray diffraction

1998 ◽  
Vol 5 (3) ◽  
pp. 929-931 ◽  
Author(s):  
C. C. Tang ◽  
G. Bushnell-Wye ◽  
R. J. Cernik
Keyword(s):  
High Temperature ◽  
Low Temperature ◽  
Closed Cycle ◽  
X Ray Diffraction ◽  
X Ray ◽  
High Temperature Furnace ◽  
Wide Range ◽  
Powder Samples ◽  
Heater Coil ◽  
Temperature Furnace

A high-temperature furnace with an induction heater coil and a cryogenic system based on closed-cycle refrigeration have been assembled to enhance the non-ambient powder diffraction facilities at the Synchrotron Radiation Source, Daresbury Laboratory. The commissioning of the high- and low-temperature devices on the high-resolution powder diffractometer of Station 2.3 is described. The combined temperature range provided by the furnace/cryostat is 10–1500 K. Results from Fe and NH4Br powder samples are presented to demonstrate the operation of the apparatus. The developments presented in this paper are applicable to a wide range of other experiments and diffraction geometries.

scholarly journals Removal of Zinc Ions Using Hydroxyapatite and Study of Ultrasound Behavior of Aqueous Media

Materials ◽  
2018 ◽  
Vol 11 (8) ◽  
pp. 1350 ◽  
Author(s):  
Simona Iconaru ◽  
Mikael Motelica-Heino ◽  
Régis Guegan ◽  
Mihai Predoi ◽  
Alina Prodan ◽  
...  
Keyword(s):  
Aqueous Solutions ◽  
Aqueous Media ◽  
Zinc Ions ◽  
X Ray Diffraction ◽  
X Ray ◽  
Transmission Electron ◽  
Wide Range ◽  
Ultrasonic Measurements ◽  
Ultrasonic Conditions ◽  
Langmuir And Freundlich Models

The present study demonstrates the effectiveness of hydroxyapatite nanopowders in the adsorption of zinc in aqueous solutions. The synthesized hydroxyapatites before (HAp) and after the adsorption of zinc (at a concentration of 50 mg/L) in solution (HApD) were characterized using X-ray diffraction (XRD), and scanning and transmission electron microscopy (SEM and TEM, respectively). The effectiveness of hydroxyapatite nanopowders in the adsorption of zinc in aqueous solutions was stressed out through ultrasonic measurements. Both Langmuir and Freundlich models properly fitted on a wide range of concentration the equilibrium adsorption isotherms, allowing us to precisely quantify the affinity of zinc to hydroxyapatite nanopowders and to probe the efficacy of hydroxyapatite in removal of zinc ions from aqueous solutions in ultrasonic conditions.

Self-Recognizing π-π Stacking Interactions Designed for the Generation of Ultrastable Mesoporous Hydrogen-Bonded Organic Frameworks

2019 ◽  
Author(s):  
KAIKAI MA ◽  
Peng Li ◽  
John Xin ◽  
Yongwei Chen ◽  
Zhijie Chen ◽  
...  
Keyword(s):  
Pore Size ◽  
Fiber Composite ◽  
Aqueous Media ◽  
Stacking Interactions ◽  
Mustard Gas ◽  
X Ray Diffraction ◽  
X Ray ◽  
Expansion Strategy ◽  
Π Stacking ◽  
Hydrogen Bonded

Creating crystalline porous materials with large pores is typically challenging due to undesired interpen-etration, staggered stacking, or weakened framework stability. Here, we report a pore size expansion strategy by self-recognizing π-π stacking interactions in a series of two-dimensional (2D) hydrogen–bonded organic frameworks (HOFs), HOF-10x (x=0,1,2), self-assembled from pyrene-based tectons with systematic elongation of π-conjugated molecular arms. This strategy successfully avoids interpene-tration or staggered stacking and expands the pore size of HOF materials to access mesoporous HOF-102, which features a surface area of ~ 2,500 m2/g and the largest pore volume (1.3 cm3/g) to date among all reported HOFs. More importantly, HOF-102 shows significantly enhanced thermal and chemical stability as evidenced by powder x-ray diffraction and N2 isotherms after treatments in chal-lenging conditions. Such stability enables the adsorption of dyes and cytochrome c from aqueous media by HOF-102 and affords a processible HOF-102/fiber composite for the efficient photochemical detox-ification of a mustard gas simulant.

Micro X-Ray Diffraction Study of Polycrystalline MgB 2 Wire and Evaluation of Carbon Doping Effect Via Low-Temperature Sintering

2019 ◽  
Author(s):  
Minoru Maeda ◽  
Dipak Patel, Dr. ◽  
Hiroaki Kumakura, Dr. ◽  
Gen Nishijima, Dr. ◽  
Akiyoshi Matsumoto, Dr. ◽  
...  
Keyword(s):  
Low Temperature ◽  
Diffraction Study ◽  
Carbon Doping ◽  
Doping Effect ◽  
Low Temperature Sintering ◽  
X Ray Diffraction ◽  
X Ray

The Application of X-Ray Diffraction at Elevated Temperatures to Study the Mechanism of Formation of Sodium Tripolyphosphate

1961 ◽  
Vol 5 ◽  
pp. 276-284
Author(s):  
E. L. Moore ◽  
J. S. Metcalf
Keyword(s):  
High Temperature ◽  
Low Temperature ◽  
Amorphous Phase ◽  
Elevated Temperatures ◽  
Sodium Tripolyphosphate ◽  
X Ray Diffraction ◽  
Mechanism Of Formation ◽  
X Ray ◽  
Temperature Form ◽  
High Temperature Form

AbstractHigh-temperature X-ray diffraction techniques were employed to study the condensation reactions which occur when sodium orthophosphates are heated to 380°C. Crystalline Na4P2O7 and an amorphous phase were formed first from an equimolar mixture of Na2HPO4·NaH2PO4 and Na2HPO4 at temperatures above 150°C. Further heating resulted in the formation of Na5P3O10-I (high-temperature form) at the expense of the crystalline Na4P4O7 and amorphous phase. Crystalline Na5P3O10-II (low-temperature form) appears after Na5P3O10-I.Conditions which affect the yield of crystalline Na4P2O7 and amorphous phase as intermediates and their effect on the yield of Na5P3O10 are also presented.

scholarly journals Multidimensional Ln-Aminophthalate Photoluminescent Coordination Polymers

Materials ◽  
2021 ◽  
Vol 14 (7) ◽  
pp. 1786
Author(s):  
Carla Queirós ◽  
Chen Sun ◽  
Ana M. G. Silva ◽  
Baltazar de Castro ◽  
Juan Cabanillas-Gonzalez ◽  
...  
Keyword(s):  
Water Content ◽  
Coordination Polymers ◽  
Metal Ion ◽  
Low Cost ◽  
Microwave Assisted Synthesis ◽  
X Ray Diffraction ◽  
X Ray ◽  
Wide Range ◽  
Ft Ir ◽  
Ft Ir Spectroscopy

The development of straightforward reproducible methods for the preparation of new photoluminescent coordination polymers (CPs) is an important goal in luminescence and chemical sensing fields. Isophthalic acid derivatives have been reported for a wide range of applications, and in addition to their relatively low cost, have encouraged its use in the preparation of novel lanthanide-based coordination polymers (LnCPs). Considering that the photoluminescent properties of these CPs are highly dependent on the existence of water molecules in the crystal structure, our research efforts are now focused on the preparation of CP with the lowest water content possible, while considering a green chemistry approach. One- and two-dimensional (1D and 2D) LnCPs were prepared from 5-aminoisophthalic acid and Sm3+/Tb3+ using hydrothermal and/or microwave-assisted synthesis. The unprecedented LnCPs were characterized by single-crystal X-ray diffraction (SCRXD), powder X-ray diffraction (PXRD), Fourier transform infrared (FT-IR) spectroscopy and scanning electron microscopy (SEM), and their photoluminescence (PL) properties were studied in the solid state, at room temperature, using the CPs as powders and encapsulated in poly(methyl methacrylate (PMMA) films, envisaging the potential preparation of devices for sensing. The materials revealed interesting PL properties that depend on the dimensionality, metal ion, co-ligand used and water content.

scholarly journals X-ray diffraction analysis of kaolin M1 and M2 via the Williamson–Hall and Warren–Averbach methods

2021 ◽  
pp. 174751982098472
Author(s):  
Lalmi Khier ◽  
Lakel Abdelghani ◽  
Belahssen Okba ◽  
Djamel Maouche ◽  
Lakel Said
Keyword(s):  
Grain Size ◽  
High Temperature ◽  
Low Temperature ◽  
Diffraction Analysis ◽  
Mechanical Resistance ◽  
X Ray Diffraction ◽  
Integral Breadth ◽  
X Ray ◽  
Mullite Phase

Kaolin M1 and M2 studied by X-ray diffraction focus on the mullite phase, which is the main phase present in both products. The Williamson–Hall and Warren–Averbach methods for determining the crystallite size and microstrains of integral breadth β are calculated by the FullProf program. The integral breadth ( β) is a mixture resulting from the microstrains and size effect, so this should be taken into account during the calculation. The Williamson–Hall chart determines whether the sample is affected by grain size or microstrain. It appears very clearly that the principal phase of the various sintered kaolins, mullite, is free from internal microstrains. It is the case of the mixtures fritted at low temperature (1200 °C) during 1 h and also the case of the mixtures of the type chamotte cooks with 1350 °C during very long times (several weeks). This result is very significant as it gives an element of explanation to a very significant quality of mullite: its mechanical resistance during uses at high temperature remains.

Silicate-germanate K2Y[(Si3Ge)O10(OH)] with unusual complex corrugated layer and its correlation to ring silicate gerenite and chain silicate chkalovite

2020 ◽  
Vol 235 (4-5) ◽  
pp. 167-172
Author(s):  
Anastasiia P. Topnikova ◽  
Elena L. Belokoneva ◽  
Olga V. Dimitrova ◽  
Anatoly S. Volkov ◽  
Leokadiya V. Zorina
Keyword(s):  
Low Temperature ◽  
Cross Section ◽  
Complex Anion ◽  
Diffraction Experiment ◽  
X Ray Diffraction ◽  
Unit Cell Parameters ◽  
X Ray ◽  
Cell Parameters ◽  
Chain Silicate ◽  
Novel Complex

AbstractA new silicate-germanate K2Y[(Si3Ge)O10(OH)] was synthesized hydrothermally in a system Y2O3:GeO2:SiO2 = 1:1:2 (T = 280 °C; P = 90–100 atm.); K2CO3 was added to the solution as a mineralizer. Single-crystal X-ray diffraction experiment was carried out at low temperature (150 K). The unit cell parameters are a = 10.4975(4), b = 6.9567(2), c = 15.4001(6) Å, β = 104.894(4)°; V = 1086.86(7) Å3; space group is P 21/c. A novel complex anion is presented by corrugated (Si,Ge) tetrahedral layers connected by couples of YO6 octahedra into the mixed microporous framework with the channels along b and a axes, the maximal size of cross-section is ~5.6 Å. This structure has similarity with the two minerals: ring silicate gerenite (Ca,Na)2(Y,REE)3Si6O18 · 2H2O and chain silicate chkalovite Na2BeSi2O6. Six-member rings with 1̅ symmetry as in gerenite are distinguished in the new layer. They are mutually perpendicular to each other and connected by additional tetrahedra. Straight crossing chains in chkalovite change to zigzag four-link chains in the new silicate-germanate layer.

Sign in / Sign up

Export Citation Format

Share Document