scholarly journals Experimental Studies of Immiscible High-Nitrogen Natural Gas WAG Injection Efficiency in Mixed-Wet Carbonate Reservoir

Energies ◽  
2020 ◽  
Vol 13 (9) ◽  
pp. 2346
Author(s):  
Mirosław Wojnicki ◽  
Jan Lubaś ◽  
Marcin Warnecki ◽  
Jerzy Kuśnierczyk ◽  
Sławomir Szuflita
Keyword(s):  
Natural Gas ◽  
Enhanced Oil Recovery ◽  
Oil Recovery ◽  
Gas Injection ◽  
Water Injection ◽  
Experimental Studies ◽  
Carbonate Reservoir ◽  
High Nitrogen ◽  
The Impact ◽  
Wag Injection

Crucial oil reservoirs are located in naturally fractured carbonate formations and are currently reaching a mature phase of production. Hence, a cost-effective enhanced oil recovery (EOR) method is needed to achieve a satisfactory recovery factor. The paper focuses on an experimental investigation of the efficiency of water alternating sour and high-nitrogen (~85% N2) natural gas injection (WAG) in mixed-wetted carbonates that are crucial reservoir rocks for Polish oil fields. The foam-assisted water alternating gas method (FAWAG) was also tested. Both were compared with continuous water injection (CWI) and continuous gas injection (CGI). A series of coreflooding experiments were conducted within reservoir conditions (T = 126 ℃, P = 270 bar) on composite cores, and each consisted of four reservoir dolomite core plugs and was saturated with the original reservoir fluids. In turn, some of the experiments were conducted on artificially fractured cores to evaluate the impact of fractures on recovery efficiency. The performance evaluation of the tested methods was carried out by comparing oil recoveries from non-fractured composite cores, as well as fractured. In the case of non-fractured cores, the WAG injection outperformed continuous gas injection (CGI) and continuous water injection (CWI). As expected, the presence of fractures significantly reduced performance of WAG, CGI and CWI injection modes. In contrast, with regard to FAWAG, deployment of foam flow in the presence of fractures remarkably enhanced oil recovery, which confirms the possibility of using the FAWAG method in situations of premature gas breakthrough. The positive results encourage us to continue the research of the potential uses of this high-nitrogen natural gas in EOR, especially in the view of the utilization of gas reservoirs with advantageous location, high reserves and reservoir energy.

Experimental Investigation of Near-Miscible Water-Alternating-Gas Injection Performance in Water-Wet and Mixed-Wet Systems

SPE Journal ◽  
2013 ◽  
Vol 18 (01) ◽  
pp. 114-123 ◽  
Author(s):  
S. Mobeen Fatemi ◽  
Mehran Sohrabi
Keyword(s):  
Relative Permeability ◽  
Oil Recovery ◽  
Gas Injection ◽  
Water Injection ◽  
Laboratory Data ◽  
Co2 Injection ◽  
Water Alternating Gas ◽  
Three Phase ◽  
The Impact ◽  
Wag Injection

Summary Laboratory data on water-alternating-gas (WAG) injection for non-water-wet systems are very limited, especially for near-miscible (very low IFT) gas/oil systems, which represent injection scenarios involving high-pressure hydrocarbon gas or CO2 injection. Simulation of these processes requires three-phase relative permeability (kr) data. Most of the existing three-phase relative permeability correlations have been developed for water-wet conditions. However, a majority of oil reservoirs are believed to be mixed-wet and, hence, prediction of the performance of WAG injection in these reservoirs is associated with significant uncertainties. Reliable simulation of WAG injection, therefore, requires improved relative permeability and hysteresis models validated by reliable measured data. In this paper, we report the results of a comprehensive series of coreflood experiments carried out in a core under natural water-wet conditions. These included water injection, gas injection, and also WAG injection. Then, to investigate the impact of wettability on the performance of these injection strategies, the wettability of the same core was changed to mixed-wet (by aging the core in an appropriate crude oil) and a similar set of experiments were performed in the mixed-wet core. WAG experiments under both wettability conditions started with water injection (I) followed by gas injection (D), and this cyclic injection of water and gas was repeated (IDIDID). The results show that in both the water-wet and mixed-wet cores, WAG injection performs better than water injection or gas injection alone. Changing the rock wettability from water-wet to mixed-wet significantly improves the performance of water injection. Under both wettability conditions (water-wet and mixed-wet), the breakthrough (BT) of the gas during gas injection happens sooner than the BT of water in water injection. Ultimate oil recovery by gas injection is considerably higher than that obtained by water injection in the water-wet system, while in the mixed-wet system, gas injection recovers considerably less oil.

Pilot Project Evaluating WAG Efficiency for Carbonate Reservoir in Eastern Siberia

2021 ◽  
Author(s):  
Valentina Zharko ◽  
Dmitriy Burdakov
Keyword(s):  
Oil Recovery ◽  
Gas Injection ◽  
Oil Production ◽  
Pilot Project ◽  
Carbonate Reservoir ◽  
Recovery Factor ◽  
Eastern Siberia ◽  
Water Cut ◽  
Wag Injection ◽  
Injection Rates

Abstract The paper presents the results of a pilot project implementing WAG injection at the oilfield with carbonate reservoir, characterized by low efficiency of traditional waterflooding. The objective of the pilot project was to evaluate the efficiency of this enhanced oil recovery method for conditions of the specific oil field. For the initial introduction of WAG, an area of the reservoir with minimal potential risks has been identified. During the test injections of water and gas, production parameters were monitored, including the oil production rates of the reacting wells and the water and gas injection rates of injection wells, the change in the density and composition of the produced fluids. With first positive results, the pilot area of the reservoir was expanded. In accordance with the responses of the producing wells to the injection of displacing agents, the injection rates were adjusted, and the production intensified, with the aim of maximizing the effect of WAG. The results obtained in practice were reproduced in the simulation model sector in order to obtain a project curve characterizing an increase in oil recovery due to water-alternating gas injection. Practical results obtained during pilot testing of the technology show that the injection of gas and water alternately can reduce the water cut of the reacting wells and increase overall oil production, providing more efficient displacement compared to traditional waterflooding. The use of WAG after the waterflooding provides an increase in oil recovery and a decrease in residual oil saturation. The water cut of the produced liquid decreased from 98% to 80%, an increase in oil production rate of 100 tons/day was obtained. The increase in the oil recovery factor is estimated at approximately 7.5% at gas injection of 1.5 hydrocarbon pore volumes. Based on the received results, the displacement characteristic was constructed. Methods for monitoring the effectiveness of WAG have been determined, and studies are planned to be carried out when designing a full-scale WAG project at the field. This project is the first pilot project in Russia implementing WAG injection in a field with a carbonate reservoir. During the pilot project, the technical feasibility of implementing this EOR method was confirmed, as well as its efficiency in terms of increasing the oil recovery factor for the conditions of the carbonate reservoir of Eastern Siberia, characterized by high water cut and low values of oil displacement coefficients during waterflooding.

Theoretical and Numerical Investigation of Supersonic Multiphase Gas Injection

2021 ◽  
Author(s):  
Da Zhu ◽  
Mohan Sivagnanam ◽  
Ian Gates
Keyword(s):  
Shock Wave ◽  
Enhanced Oil Recovery ◽  
Oil Recovery ◽  
Single Phase ◽  
Gas Injection ◽  
Continuous Phase ◽  
Solid Particles ◽  
Gas Flows ◽  
Theoretical Derivation ◽  
The Impact

Abstract Supersonic gas injection can help deliver gas uniformly to a reservoir, regardless of reservoir conditions. This technology has played a key role in enhanced oil recovery (EOR) and in particular, thermal enhanced oil recovery operations. Most previous studies have focused on single phase gas injection whereas in most field applications, multiphase and multicomponent situations occur. In the research documented in this paper, we report on results of evaluations of compressible multiphase supersonic gas flows in which gas is the continuous phase is seeded with dispersed liquid droplets or solid particles. Theoretical derivation and numerical simulations with and without relative motions between continuous and disperse phases are examined first. The results illustrate that the shock wave structures and flow properties associated with the multiphase gas flows are different than that of single-phase isentropic flows. The existence and importance of relaxation zones after the normal shock wave in multiphase flow is described. Numerical computational fluid dynamics (CFD) simulations are conducted to show how the multiphase multicomponent flow affects gas phase injection under different conditions. The impact of solid/liquid mass loading on flow performance is discussed. Finally, the practical application of the findings is discussed.

scholarly journals Performance Quantification of Enhanced Oil Recovery Methods in Fractured Reservoirs

Energies ◽  
2021 ◽  
Vol 14 (16) ◽  
pp. 4739
Author(s):  
Riyaz Kharrat ◽  
Mehdi Zallaghi ◽  
Holger Ott
Keyword(s):  
Enhanced Oil Recovery ◽  
Oil Recovery ◽  
Driving Forces ◽  
Fractured Reservoirs ◽  
Gas Injection ◽  
Capillary Forces ◽  
Dimensionless Numbers ◽  
Water Alternating Gas ◽  
Eor Processes ◽  
Wag Injection

The enhanced oil recovery mechanisms in fractured reservoirs are complex and not fully understood. It is technically challenging to quantify the related driving forces and their interaction in the matrix and fractures medium. Gravity and capillary forces play a leading role in the recovery process of fractured reservoirs. This study aims to quantify the performance of EOR methods in fractured reservoirs using dimensionless numbers. A systematic approach consisting of the design of experiments, simulations, and proxy-based optimization was used in this work. The effect of driving forces on oil recovery for water injection and several EOR processes such as gas injection, foam injection, water-alternating gas (WAG) injection, and foam-assisted water-alternating gas (FAWAG) injection was analyzed using dimensionless numbers and a surface response model. The results show that equilibrium between gravitational and viscous forces in fracture and capillary and gravity forces in matrix blocks determines oil recovery performance during EOR in fractured reservoirs. When capillary forces are dominant in gas injection, fluid exchange between fracture and matrix is low; consequently, the oil recovery is low. In foam-assisted water-alternating gas injection, gravity and capillary forces are in equilibrium conditions as several mechanisms are involved. The capillary forces dominate the water cycle, while gravitational forces govern the gas cycle due to the foam enhancement properties, which results in the highest oil recovery factor. Based on the performed sensitivity analysis of matrix–fracture interaction on the performance of the EOR processes, the foam and FAWAG injection methods were found to be more sensitive to permeability contrast, density, and matrix block highs than WAG injection.

scholarly journals Study of the impact of injection parameters on the performance of miscible sour gas injection for enhanced oil recovery

2019 ◽  
Vol 10 (4) ◽  
pp. 1575-1589
Author(s):  
Aminu Yau Kaita ◽  
Oghenerume Ogolo ◽  
Xingru Wu ◽  
Isah Mohammed ◽  
Emmanuel Akaninyene Akpan
Keyword(s):  
Enhanced Oil Recovery ◽  
Oil Recovery ◽  
Gas Injection ◽  
Research Work ◽  
Gas Concentration ◽  
Acid Gas ◽  
Minimum Miscibility Pressure ◽  
Injection Parameters ◽  
The Impact ◽  
Sour Gas

AbstractSour gas reservoirs have faced critics for environmental concerns and hazards, necessitating a novel outlook to how the produced sour gases could be either utilized or carefully disposed. Over the years of research and practice, several methods of sour gas processing and utilization have been developed, from the solid storage of sulfur to reinjecting the sour gas into producing or depleted light oil reservoir for miscible flooding enhanced oil recovery. This paper seeks to investigate the impact of injection parameters on the performance of sour gas injection for enhance oil recovery. In designing a miscible gas flooding project, empirical correlations are used and the key parameter which impacts the phase behavior is identified to be the minimum miscibility pressure (MMP). A compositional simulator was utilized in this research work to study the effect of injection parameters such as minimum miscibility pressure, acid gas concentration, injection pressure and injection rate on the performance of miscible sour gas injection for enhanced oil recovery. The findings showed that methane concentration had a significant impact on the MMP of the process. Additionally, an increase in acid gas concentration decreases the MMP of the process as a result of an increase in gas viscosity, consequently extending the plateau period resulting in late gas breakthrough and increased overall recovery of the process.

Experimental Study of Miscible Thickened Natural Gas Injection for Enhanced Oil Recovery

2017 ◽  
Vol 31 (5) ◽  
pp. 4951-4965 ◽  
Author(s):  
Nasser M. Al Hinai ◽  
A. Saeedi ◽  
Colin D. Wood ◽  
R. Valdez ◽  
Lionel Esteban
Keyword(s):  
Experimental Study ◽  
Natural Gas ◽  
Enhanced Oil Recovery ◽  
Oil Recovery ◽  
Gas Injection
Sign in / Sign up

Export Citation Format

Share Document