scholarly journals Toward a Better Understanding of Sediment Dynamics as a Basis for Maintenance Dredging in Nagan Raya Port, Indonesia

Fluids ◽  
2021 ◽  
Vol 6 (11) ◽  
pp. 397
Author(s):  
Muhammad Zikra ◽  
Shaskya Salsabila ◽  
Kriyo Sambodho

The Port of 2 × 110 MW Nagan Raya Coal Fired Steam Power Plant is one of the facilities constructed by the State Electricity Company in Aceh Province, Indonesia. During its operation, which began in 2013, the port has dealt with large amounts of sedimentation within the port and ship entrances. The goal of this study is to mitigate the sedimentation problem in the Nagan Raya port by evaluating the effect of maintenance dredging. Field measurements, and hydrodynamic and sediment transport modeling analysis, were conducted during this study. Evaluation of the wind data showed that the dominant wind direction is from south to west. Based on the analysis of the wave data, the dominant wave direction is from the south to the west. Therefore, the wave-induced currents in the surf zone were from south to north. Based on the analysis of longshore sediment transport, the supply of sediments to Nagan Raya port was estimated to be around 40,000–60,000 m3 per year. Results from the sediment model showed that sedimentation of up to 1 m was captured in areas of the inlet channel of Nagan Raya port. The use of a passing system for sand is one of the sedimentation management solutions proposed in this study. The dredged sediment material around the navigation channel was dumped in a dumping area in the middle of the sea at a depth of 11 m, with a distance of 1.5 km from the shoreline. To obtain a greater maximum result, the material disposal distance should be dumped further away, at least at a depth of 20 m or a distance of 20 miles from the coastline.

2012 ◽  
Vol 1 (33) ◽  
pp. 40 ◽  
Author(s):  
Cüneyt Baykal ◽  
Ayşen Ergin ◽  
Işıkhan Güler

This paper presents an energetic-based simple approach for the computation of cross-shore distribution of total longshore sediment transport (LST) rates. The proposed approach (Baykal 2012) follows similar assumptions with the given formula of Bayram et al. (2007) for the total LST rate (Qlst,t) across the surf zone and is applied to investigate the relation between the rate of dissipation in wave energy flux due to wave breaking and total longshore sediment flux using the available laboratory measurements of Wang et al. (2002) and Gravens and Wang (2007) and the field measurements carried out at Duck site, North Carolina, USA between years 1995-1998 (Miller 1999). The proposed approach is also compared with some of the available distributed total load models. From the comparative studies, it is found that the proposed approach shows good agreement with both the laboratory and field measurements, using a single empirical constant, both qualitatively and quantitatively, especially for the cases where the wave conditions are highly energetic (both for plunging and spilling type breakers) and the suspended load is the main mode of sediment transport in the surf zone.


2020 ◽  
Vol 8 (1) ◽  
pp. 55
Author(s):  
Jesbin George ◽  
V. Sanil Kumar ◽  
R. Gowthaman ◽  
Jai Singh

The nearshore wave characteristics and variations in littoral drift (longshore sediment transport; LST) are estimated based on different approaches for four years along the Vengurla coast, with comparable wind-sea and swell energy assessed. The waverider buoy-measured data at 15 m water depth is utilized as the input wave parameters along with the reanalysis model data, and the numerical wave model Delft-3D is used for estimating the nearshore wave parameters. The relative contribution of wind-seas and swells on LST rates are specifically examined. The clear prevalence of west-southwest waves implies the prevalence of south to north longshore sediment transport with net transport varying from 0.19–0.37 × 105 m3/yr. LST is strongly dependent on the breaker angle and a small change in the wave direction substantially alters the LST, and hence reanalysis/model data with coarse resolutions produce large errors (~38%) in the LST estimate. The annual gross LST rate based on integral wave parameters is only 58% considering the wind-seas and swells separately, since the wind-sea energy is comparable to swell energy, and the direction of these two systems differs significantly.


Water ◽  
2022 ◽  
Vol 14 (2) ◽  
pp. 214
Author(s):  
Margarita Shtremel ◽  
Yana Saprykina ◽  
Berna Ayat

Sand bar migration on the gently sloping sandy bottom in the coastal zone as a result of nonlinear wave transformation and corresponding sediment transport is discussed. Wave transformation on the intermediate depth causes periodic exchange of energy in space between the first and the second wave harmonics, accompanied by changes in the wave profile asymmetry. This leads to the occurrence of periodical fluctuations in the wave-induced sediment transport. It is shown that the position of the second nonlinear wave harmonic maximum determines location of the divergence point of sediment transport on the inclined bottom profile, where it changes direction from the onshore to the offshore. Such sediment transport pattern leads to formation of an underwater sand bar. A method is proposed to predict the position of the bar on an underwater slope after a storm based on calculation of the position of the maximum amplitude of the second nonlinear harmonic. The method is validated on the base of field measurements and ERA 5 reanalysis wave data.


2017 ◽  
Vol 21 (1) ◽  
pp. 1-13 ◽  
Author(s):  
V. Sanil Kumar ◽  
P. R. Shanas ◽  
G. Udhaba Dora ◽  
Johnson Glejin ◽  
Sajiv Philip

2015 ◽  
Vol 42 (8) ◽  
pp. 2869-2877 ◽  
Author(s):  
A. Fernández-Mora ◽  
D. Calvete ◽  
A. Falqués ◽  
H. E. de Swart

1980 ◽  
Vol 1 (17) ◽  
pp. 86 ◽  
Author(s):  
R.O. Bruno ◽  
R.G. Dean ◽  
C.G. Gable

A field experiment was conducted by the Coastal Engineering Research Center (CERC) to develop correlations between wave characteristics and longshore sediment transport. The waves were measured by two near-bottom mounted pressure transducers and the average longshore sediment transport rates were determined from sequential volumetric surveys behind an offshore breakwater which was regarded as a total trap. The data analyzed herein encompass a period of nine months during which a total accumulation of 675,000 m3 occurred as documented by eight surveys. Spectral analyses of the wave data were conducted and yielded one direction per frequency. The correlations include immersed weight sediment transport rate, I, versus (1) longshore component of wave energy flux at breaking, P&Sf and (2) the onshore flux of the longshore component of wave-induced momentum, S „. The most widely used correlation constant, K, in the relationship I = KPjig is 0,77. The best-fit values found from the data were K = 0.65 and 0.92 for linear and log best-fits, respectively, as based on the p£s values directed toward the trap. The corresponding values of KA (dimensional) relating I and Sxv are 4.98 m/s and 6.37 m/s, respectively. One feature of this type of trap is the potential for overtrapping if the waves are directed nearly normal to shore.


1982 ◽  
Vol 1 (18) ◽  
pp. 84
Author(s):  
Hiroshi Hashimoto ◽  
Takaaki Uda

In order to investigate the response of beach profiles to incident waves, computations by the empirical eigenfunction analysis proposed by Winant et al. are performed. The analysis of the data obtained at Ajigaura Beach over three years from 1976 to 1979 indicates that beach profile changes due to longshore and onshore-offshore sediment transport are separable by the empirical eigenfunction method. The beach profile changes due to longshore sediment transport has a time lag of 12 weeks with respect to the change of wave direction at Ajigaura Beach. It was found theoretically that this time lag was due to the sand waves propagating in the longshore direction. Regarding as onshore-offshore sand transport, the second eigenfunction is associated with the beach changes due to onshore-offshore sand transport caused by the change of wave height.


Sign in / Sign up

Export Citation Format

Share Document