scholarly journals Investigating Behavior of Six Methods for Sediment Transport Capacity Estimation of Spatial-Temporal Soil Erosion

Water ◽  
2021 ◽  
Vol 13 (21) ◽  
pp. 3054
Author(s):  
Linh Nguyen Van ◽  
Xuan-Hien Le ◽  
Giang V. Nguyen ◽  
Minho Yeon ◽  
Sungho Jung ◽  
...  
Keyword(s):  
Sediment Transport ◽  
Soil Erosion ◽  
Sediment Concentration ◽  
Sediment Runoff ◽  
Additional Parameter ◽  
Transport Capacity ◽  
Stream Power ◽  
Sediment Transport Capacity ◽  
Wide Range ◽  
Depth Analysis

Estimation of sediment transport capacity (STC) plays a crucial role in simulating soil erosion using any physics-based models. In this research, we aim to investigate the pros and cons of six popular STC methods (namely, Shear velocity, Kilinc-Richardson (KR), Effective stream power, Slope and unit discharge, Englund-Hansen (EH), and Unit stream power) for soil erosion/deposition simulation at watershed scales. An in-depth analysis was performed using the selected STC methods integrated into the Grid Surface Subsurface Hydrologic Analysis model for investigating the changes in morphology at spatial-temporal scales at the Cheoncheon watershed, South Korea, over three storm events. Conclusions were drawn as follows. (1) Due to the ability of the KR and EH methods to include an additional parameter (i.e., erodibility coefficient), they outperformed others by producing more accurate simulation results of sediment concentration predictions. The KR method also proved to be superior to the EH method when it showed a more suitable for sediment concentration simulations with a wide range of sediment size and forcing magnitude. (2) We further selected 2 STC methods among the 6 methods to deeply explore the spatial distribution of erosion/deposition. The overall results were more agreeable. For instance, the phenomenon of erosion mainly occurred upstream of watersheds with steep slopes and unbalanced initial sediment concentrations, whereas deposition typically appeared at locations with flat terrain (or along the mainstream). The EH method demonstrated the influence of topography (e.g., gradient slope) on accretionary erosion/deposition results more significantly than the KR method. The obtained results contribute a new understanding of rainfall-sediment-runoff processes and provide fundamental plans for soil conservation in watersheds.

scholarly journals Effect of hydraulic parameters on sediment transport capacity in overland flow over erodible beds

2012 ◽  
Vol 16 (2) ◽  
pp. 591-601 ◽  
Author(s):  
M. Ali ◽  
G. Sterk ◽  
M. Seeger ◽  
M. Boersema ◽  
P. Peters
Keyword(s):  
Shear Stress ◽  
Sediment Transport ◽  
Hydraulic Parameters ◽  
Transport Capacity ◽  
Slope Gradient ◽  
Mean Flow ◽  
Stream Power ◽  
Unit Discharge ◽  
Sediment Transport Capacity ◽  
Mean Flow Velocity

Abstract. Sediment transport is an important component of the soil erosion process, which depends on several hydraulic parameters like unit discharge, mean flow velocity, and slope gradient. In most of the previous studies, the impact of these hydraulic parameters on transport capacity was studied for non-erodible bed conditions. Hence, this study aimed to examine the influence of unit discharge, mean flow velocity and slope gradient on sediment transport capacity for erodible beds and also to investigate the relationship between transport capacity and composite force predictors, i.e. shear stress, stream power, unit stream power and effective stream power. In order to accomplish the objectives, experiments were carried out in a 3.0 m long and 0.5 m wide flume using four well sorted sands (0.230, 0.536, 0.719, 1.022 mm). Unit discharges ranging from 0.07 to 2.07 × 10−3 m2 s−1 were simulated inside the flume at four slopes (5.2, 8.7, 13.2 and 17.6%) to analyze their impact on sediment transport rate. The sediment transport rate measured at the bottom end of the flume by taking water and sediment samples was considered equal to sediment transport capacity, because the selected flume length of 3.0 m was found sufficient to reach the transport capacity. The experimental result reveals that the slope gradient has a stronger impact on transport capacity than unit discharge and mean flow velocity due to the fact that the tangential component of gravity force increases with slope gradient. Our results show that unit stream power is an optimal composite force predictor for estimating transport capacity. Stream power and effective stream power can also be successfully related to the transport capacity, however the relations are strongly dependent on grain size. Shear stress showed poor performance, because part of shear stress is dissipated by bed irregularities, bed form evolution and sediment detachment. An empirical transport capacity equation was derived, which illustrates that transport capacity can be predicted from median grain size, total discharge and slope gradient.

scholarly journals Investigating transport capacity equations in sediment yield modelling for the Cariri semi-arid region of Paraiba-PB/Brazil

2015 ◽  
Vol 367 ◽  
pp. 374-381
Author(s):  
E. E. De Figueiredo ◽  
C. C. R. A. Souto ◽  
Z. C. Vieira
Keyword(s):  
Sediment Transport ◽  
Soil Erosion ◽  
The State ◽  
Transport Capacity ◽  
Stream Power ◽  
Study Region ◽  
Physically Based Model ◽  
Sediment Size ◽  
Physically Based ◽  
Semi Arid

Abstract. In the semi arid Cariri region of the state of Paraiba, Brazil, runoff is of the Hortonian type generated by excess of rainfall over infiltration capacity, and soil erosion is governed by rainfall intensity and sediment size. However, the governing sediment transport mechanism is not well understood. Sediment transport generally depends on the load of sediment provided by soil erosion and on the transport capacity of the flow. The latter is mainly governed by mechanisms such as water shear stress, or stream power. Accordingly, the load of sediment transported by the flow may vary depending on the mechanism involved in the equation of estimation. Investigation of the sediment transport capacity of the flow via a distributed physically-based model is an important and necessary task, but quite rare in semi-arid climates, and particularly in the Cariri region of the state of Paraíba/Brazil. In this study, the equations of Yalin, Engelund & Hansen, Laursen, DuBoys and Bagnold have been coupled with the MOSEE distributed physically based model aiming at identifying the mechanisms leading to the best model simulations when compared with data observed at various basin scales and land uses in the study region. The results obtained with the investigated methods were quite similar and satisfactory suggesting the feasibility of the mechanisms involved, but the observed values were better represented with Bagnold’s equation, which is physically grounded on the stream power, and we recommend it for simulations of similar climate, runoff generation mechanisms and sediment characteristics as in the study region.

scholarly journals TEST OF EMPIRICAL SEDIMENT TRANSPORT RELATIONS AGAINST EXPERIMENTAL SWASH DATA UNDER THE NON-CAPACITY MODELING FRAMEWORK

2018 ◽  
pp. 81
Author(s):  
Peng Hu ◽  
Liming Tan ◽  
Jiafeng Xie ◽  
Zhiguo He
Keyword(s):  
Sediment Transport ◽  
Sediment Concentration ◽  
Transport Rate ◽  
Swash Zone ◽  
Transport Capacity ◽  
Modeling Framework ◽  
Sediment Transport Capacity ◽  
Sediment Transport Rate ◽  
Advection Diffusion Equation ◽  
Empirical Relations

Swash sediment transport and beach deformation has received great attention in the past two decades. Quantification of swash-induced sediment transport rate is of vital importance for accurate prediction of beach deformation in the swash zone. Two empirical parameters are involved in this quantification, empirical relations for sediment transport capacity and the bed shear stress that may be used in the former. Since the swash zone is highly unsteady, of short cross-shore distance, sediment transport in this zone may be of high possibility to be lag of the flow variation. Thus we have firstly developed a non-capacity sediment transport model for the swash zone. This model appreciates the fact that the actual sediment transport rate may not be necessarily equal to the sediment transport capacity of the flow. In contrast to traditional capacity models that calculate sediment transport rate using directly empirical relations (Hu et al. 2015), the non-capacity model uses the advection-diffusion equation to calculate depth-averaged sediment concentration firstly, and afterwards compute sediment transport rate as flow depth*velocity*concentration. We have also noted that some empirical relations for sediment transport capacity may predict physically unrealistic high values of sediment concentration in the swash zone. This is attributed to the vanishing water depth in the swash zone, whereas existing empirical relations are developed for relatively large water depths (Hu et al. 2015; Li et al. 2017).

scholarly journals Effect of hydraulic parameters on sediment transport capacity in overland flow over erodible beds

2011 ◽  
Vol 8 (4) ◽  
pp. 6939-6965 ◽  
Author(s):  
M. Ali ◽  
G. Sterk ◽  
M. Seeger ◽  
M. P. Boersema ◽  
P. Peters
Keyword(s):  
Shear Stress ◽  
Sediment Transport ◽  
Hydraulic Parameters ◽  
Transport Capacity ◽  
Slope Gradient ◽  
Mean Flow ◽  
Stream Power ◽  
Unit Discharge ◽  
Sediment Transport Capacity ◽  
Mean Flow Velocity

Abstract. Sediment transport is an important component of the soil erosion process, which depends on several hydraulic parameters like unit discharge, mean flow velocity, and slope gradient. In most of the previous studies, the impact of these hydraulic parameters on transport capacity was studied for non-erodible bed conditions. Hence, this study aimed to examine the influence of unit discharge, mean flow velocity and slope gradient on sediment transport capacity for erodible beds and also to investigate the relationship between transport capacity and composite force predictors i.e. shear stress, stream power, unit stream power and effective stream power. In order to accomplish the objectives, experiments were carried out using four well sorted sands (0.230, 0.536, 0.719, 1.022 mm). Unit discharges ranging from 0.07 to 2.07 × 10−3 m2 s−1 were simulated inside the flume at four slopes (5.2, 8.7, 13.2 and 17.6 %) to analyze their impact on sediment transport rate. The sediment transport rate measured at the bottom end of the flume by taking water and sediment samples was considered equal to sediment transport capacity, because the selected flume length of 3.0 m was found sufficient to reach the transport capacity. The experimental result reveals that the slope gradient has a stronger impact on transport capacity than unit discharge and mean flow velocity due to the fact that the tangential component of gravity force increases with slope gradient. Our results show that unit stream power is an optimal composite force predictor for estimating transport capacity. Stream power and effective stream power can also be successfully related to the transport capacity, however the relations are strongly dependent on grain size. Shear stress showed poor performance, because part of shear stress is dissipated by bed irregularities, bed form evolution and sediment detachment. An empirical transport capacity equation was derived, which illustrates that transport capacity can be predicted from median grain size, total discharge and slope gradient.

scholarly journals MORPHOLOGICAL HYSTERESIS OF ARTIFICIAL BEACH UNDER LARGE WAVE CONDITION: AN EXPERIMENTAL INVESTIGATION

2020 ◽  
pp. 33
Author(s):  
Yuan Li ◽  
Chi Zhang
Keyword(s):  
Experimental Investigation ◽  
Sediment Transport ◽  
Water Column ◽  
Wave Breaking ◽  
Storm Surges ◽  
Sediment Concentration ◽  
Transport Capacity ◽  
Large Wave ◽  
Wave Condition ◽  
Sediment Transport Capacity

Submerged Artificial sandBars (SAB) are usually implemented on the lower shoreface to protect berms or dunes during storm surges. The lee-effect of SAB is due to its ability in triggering large wave breaking, so that sediment concentration in water column and sediment transport capacity will decrease in the covered areas. Previous studies analyzed the lee-effect and topography evolution of SAB, however the morphological coupling of SAB and natural profiles is seldom referred. In this study, the morphological coupling between SAB located on the lower shoreface and the berm in upper beach is investigated in a well-controlled physical experiment.Recorded Presentation from the vICCE (YouTube Link): https://youtu.be/KsOK30StZZQ

Sign in / Sign up

Export Citation Format

Share Document