Statistical analysis of properties of non-fullerene acceptors for organic photovoltaics

2022 ◽  
Author(s):  
Naoya Yamaguchi ◽  
Hiroaki Sano ◽  
Hikaru Sawahata ◽  
Masahiro Nakano ◽  
Tetsuya TAIMA ◽  
...  
Keyword(s):  
Organic Photovoltaics ◽  
High Performance ◽  
Open Circuit Voltage ◽  
Short Circuit ◽  
Power Conversion ◽  
Short Circuit Current ◽  
Short Circuit Current Density ◽  
Open Circuit ◽  
Performance Parameters ◽  
Chemical Structures

Abstract From ~1500 published journal papers on organic photovoltaics (OPVs), we extracted OPV performance parameters of power conversion efficiency (PCE), open circuit voltage (VOC) and short circuit current density (JSC) and chemical structures of photovoltaic layer materials to investigate the relation between the extracted data of OPVs accompanied by non-fullerene acceptors (NFAs). Our analysis indicated that there was a suitable range of VOC for high PCE or JSC in NFAs. We also investigated the correlation between the performance parameters and chemical structures of small molecule NFAs. Our approach may enable us to provide new design strategy for high performance OPVs.

A naphthodithiophene-based nonfullerene acceptor for high-performance polymer solar cells with a small energy loss

2020 ◽  
Vol 8 (19) ◽  
pp. 6513-6520 ◽  
Author(s):  
Xingliang Dong ◽  
Qing Guo ◽  
Qi Liu ◽  
Lei Zhu ◽  
Xia Guo ◽  
...  
Keyword(s):  
High Performance ◽  
Open Circuit Voltage ◽  
Polymer Solar Cells ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Short Circuit Current Density ◽  
Open Circuit ◽  
Small Energy ◽  
High Performance Polymer ◽  
Nonfullerene Acceptor

A new non-fullerene acceptor named NTO-4F is developed. The optimal PSC based on PM6:NTO-4F achieves a PCE of 11.5% with simultaneously high open-circuit voltage of 0.99 V and short-circuit current density of 19.1 mA cm−2.

Narrow band-gap materials with overlapping absorption simultaneously increase the open circuit voltage and average visible transmittance of semitransparent organic solar cells

2021 ◽  
Author(s):  
Xuexiang Huang ◽  
Jiyeon Oh ◽  
Yujun Cheng ◽  
Bin Huang ◽  
Shanshan Ding ◽  
...  
Keyword(s):  
Organic Solar Cells ◽  
Near Infrared ◽  
Open Circuit Voltage ◽  
Narrow Band ◽  
Short Circuit ◽  
Power Conversion ◽  
Short Circuit Current ◽  
Short Circuit Current Density ◽  
Open Circuit ◽  
Visible Transmittance

Overlapping near-infrared absorption not only does not reduce short-circuit current density (JSC), but also can ensure a high average visible transmittance (AVT) and get a high open-circuit voltage (VOC) and power conversion efficiency (PCE) at the same time.

Development of New Fullerene-based Electron Acceptors for Efficient Organic Photovoltaic Cells

2012 ◽  
Vol 1390 ◽  
Author(s):  
Yutaka Matsuo
Keyword(s):  
High Performance ◽  
Open Circuit Voltage ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Short Circuit Current Density ◽  
Open Circuit ◽  
Fullerene Derivative ◽  
High Electron ◽  
Organic Thin Film ◽  
Photovoltaic Devices

ABSTRACTThis article describes design of fullerene-based electron-accepting materials to obtain high performance in organic thin-film photovoltaic devices. A 1,4-bis(dimethylphenylsilylmethyl)[60]fullerene gives higher open circuit voltage than 1,2-diadduct because of smaller π-conjugated systems, and enables columnar fullerene-core array for high electron mobility and thermal crystallization for ideal phase separation with electron-donor materials. A 56π-electron fullerene derivative possessing the dihydromethano group as the smallest carbon addend does not disrupt fullerene-fullerene contact in solid state, giving high open-circuit voltage without decreasing of short-circuit current density and fill factor.

IMPROVING STABILITY OF CHLOROPHYLL AS NATURAL DYE FOR DYE-SENSITIZED SOLAR CELLS

2017 ◽  
Vol 80 (1) ◽  
Author(s):  
Zainal Arifin ◽  
Sudjito Soeparman ◽  
Denny Widhiyanuriyawan ◽  
Suyitno Suyitno ◽  
Argatya Tara Setyaji
Keyword(s):  
Current Density ◽  
Open Circuit Voltage ◽  
Short Circuit ◽  
Dye Sensitized Solar Cells ◽  
Short Circuit Current ◽  
Short Circuit Current Density ◽  
Open Circuit ◽  
Natural Dyes ◽  
Dye Sensitized ◽  
Sensitized Solar Cells

Natural dyes have attracted much researcher’s attention due to their low-cost production, simple synthesis processes and high natural abundance. However the dye-sensitized solar cells (DSSCs) based natural dyes have higher tendency to degradation. This article reports on the enhancement of performance and stability of dye-sensitized solar cells (DSSCs) using natural dyes. The natural dyes were extracted from papaya leaves by ethanol solvent at a temperature of 50 °C. Then the extracted dyes were isolated and modified into Mg-chlorophyll using column chromatography. Mg-chlorophyll was then synthesized into Fe-chlorophyll to improve stability. The natural dyes were characterized using ultraviolet-visible spectrometry, Fourier transform infrared spectroscopy, and cyclic voltammetry. The performance of DSSCs was tested using a solar simulator. The results showed the open-circuit voltage, the short-circuit current density, and the efficiency of the extracted papaya leaves-based DSSCs to be 325 mV, 0.36 mA/cm2, and 0.07%, respectively. Furthermore, the DSSCs with purified chlorophyll provide high open-circuit voltage of 425 mV and short-circuit current density of 0.45 mA/cm2. The use of Fe-chlorophyll for sensitizing the DSSCs increases the efficiency up to 2.5 times and the stability up to two times. The DSSCs with Fe-chlorophyll dyes provide open-circuit voltage, short-circuit current density, and efficiency of 500 mV, 0.62 mA/cm2, and 0.16%, respectively. Further studies to improve the current density and stability of natural dye-based DSSCs along with an improvement in the anchor between dyes and semiconducting layers are required.

scholarly journals Optimized Thin-Film Organic Solar Cell with Enhanced Efficiency

2021 ◽  
Vol 13 (23) ◽  
pp. 13087
Author(s):  
Waqas Farooq ◽  
Muhammad Ali Musarat ◽  
Javed Iqbal ◽  
Syed Asfandyar Ali Kazmi ◽  
Adnan Daud Khan ◽  
...  
Keyword(s):  
Thin Film ◽  
Solar Cell ◽  
Organic Solar Cell ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Short Circuit Current Density ◽  
Open Circuit ◽  
Bragg Reflector ◽  
Performance Parameters ◽  
Distributed Bragg Reflector

Modification of a cell’s architecture can enhance the performance parameters. This paper reports on the numerical modeling of a thin-film organic solar cell (OSC) featuring distributed Bragg reflector (DBR) pairs. The utilization of DBR pairs via the proposed method was found to be beneficial in terms of increasing the performance parameters. The extracted results showed that using DBR pairs helps capture the reflected light back into the active region by improving the photovoltaic parameters as compared to the structure without DBR pairs. Moreover, implementing three DBR pairs resulted in the best enhancement gain of 1.076% in power conversion efficiency. The measured results under a global AM of 1.5G were as follows: open circuit voltage (Voc) = 0.839 V; short circuit current density (Jsc) = 10.98 mA/cm2; fill factor (FF) = 78.39%; efficiency (η) = 11.02%. In addition, a thermal stability analysis of the proposed design was performed and we observed that high temperature resulted in a decrease in η from 11.02 to 10.70%. Our demonstrated design may provide a pathway for the practical application of OSCs.

Metal/Porous Silicon Schottky Diode Structures as Sensors

2006 ◽  
Vol 915 ◽  
Author(s):  
Tayyar Dzhafarov ◽  
Cigdem Oruc Lus ◽  
Sureyya AYDIN ◽  
Emel Cingi
Keyword(s):  
Porous Silicon ◽  
Schottky Diode ◽  
Open Circuit Voltage ◽  
Short Circuit ◽  
Short Circuit Current ◽  
Short Circuit Current Density ◽  
Open Circuit ◽  
Current Voltage ◽  
Schottky Type ◽  
Capacitance Characteristics

AbstractIn this work we present data on investigation of the current-voltage and capacitance characteristics of Au/PS Schottky type structures in the presence of different hydrogen-containing solutions (glucose, ethanol, methanol, boric acid, sodium tetraborate pentahydrate, sodium borohydride, benzine, KOH). Generation of the open-circuit voltage and short-circuit current density and capacitance up to 0.55 V, 25 mA/cm2 and 1μF respectively on placing of Au/PS structures in these solutions was discovered. This effect is mainly caused by hydrogen component of solutions. The possible mechanism generation of voltage and capacitance in metal/PS sensors hydrogen-containing solutions is suggested. The advantage of metal/PS Schottky type sensors consists in working without applying external electricity.

Novel Linear and Hyperbranched Polythiophene Derivatives Containing Diketopyrrolopyrroles as Linking Groups

2015 ◽  
Vol 1771 ◽  
pp. 213-219
Author(s):  
Sheng-Hsiung Yang ◽  
Chia-Hao Hsieh
Keyword(s):  
Fill Factor ◽  
Open Circuit Voltage ◽  
Short Circuit ◽  
Power Conversion ◽  
Short Circuit Current ◽  
Open Circuit ◽  
Photovoltaic Properties ◽  
Molecular Weights ◽  
Active Layers ◽  
Film State

ABSTRACTThe goal of this research is to synthesize novel linear and hyperbranched polythiophene derivatives containing diketopyrrolopyrrole (DPP) as linking groups, and to investigate thermal, optical, electrochemical, and photovoltaic properties of those derivatives. Polymers with high regioregularity were synthesized via the Universal Grignard metathesis polymerization. Those linear or hyperbranched polythiophenes containing DPP bridging moieties showed higher molecular weights and better thermal stability compared with normal P3HT. The UV-vis absorption spectra of the DPP-containing polymers are similar to that of P3HT in film state, while they show distinct attenuation in fluorescent emission. Finally, all polymers were blended with PC61BM and used as active layers for fabrication of inverted solar devices. The devices based on those DPP-containing polythiophenes revealed the open-circuit voltage (VOC) of 0.55–0.58 V, the short-circuit current (JSC) of 8.62–16.21 mA/cm2, the fill factor (FF) of 36–41%, and the power conversion efficiency (PCE) of 1.73–3.74%.

Iodide management in formamidinium-lead-halide–based perovskite layers for efficient solar cells

Science ◽  
2017 ◽  
Vol 356 (6345) ◽  
pp. 1376-1379 ◽  
Author(s):  
Woon Seok Yang ◽  
Byung-Wook Park ◽  
Eui Hyuk Jung ◽  
Nam Joong Jeon ◽  
Young Chan Kim ◽  
...  
Keyword(s):  
Solar Cells ◽  
High Performance ◽  
Deep Level ◽  
Short Circuit ◽  
Perovskite Solar Cells ◽  
Short Circuit Current ◽  
Short Circuit Current Density ◽  
Open Circuit ◽  
Small Cells ◽  
Iodide Ions

The formation of a dense and uniform thin layer on the substrates is crucial for the fabrication of high-performance perovskite solar cells (PSCs) containing formamidinium with multiple cations and mixed halide anions. The concentration of defect states, which reduce a cell’s performance by decreasing the open-circuit voltage and short-circuit current density, needs to be as low as possible. We show that the introduction of additional iodide ions into the organic cation solution, which are used to form the perovskite layers through an intramolecular exchanging process, decreases the concentration of deep-level defects. The defect-engineered thin perovskite layers enable the fabrication of PSCs with a certified power conversion efficiency of 22.1% in small cells and 19.7% in 1-square-centimeter cells.

Sign in / Sign up

Export Citation Format

Share Document