scholarly journals Municipal sewage sludge as a source of microelements in sustainable plant production: a laboratory lysimeter study

2022 ◽  
Vol 20 (2) ◽  
pp. e1258
Author(s):  
Vanda Adamcová ◽  
Martin Valica ◽  
Jozef Gubiš ◽  
Marcela Gubišová ◽  
Katarína Ondreičková ◽  
...  

The aim of the work was to characterize the samples of sewage sludge (SSL) originated from the Wastewater Treatment Plant Piešťany (TAVOS, a.s., Trnava, Slovakia) in terms of their potential application into the soils. Within the physico-chemical characterization of SSL, the samples were analysed in terms of the values of pH, cation exchange capacity (CEC), total organic carbon (TOC), water holding capacity (WHC), as well as the presence of heavy metals. It was found that SSL contained significant amounts of microelements Zn (1,269 mg.kg-1, d.w.) and Cu (224 mg.kg-1, d.w.). Laboratory lysimeter experiments involving the application of SSL into the top layer of agriculturally used soil (0 – 10 cm) forming a soil column, in which seedlings of tobacco (Nicotiana tabacum L.) were cultivated, showed that in the case of SSL application in the highest permitted amounts (15 t.ha-1) only 0.11 % Zn and 0.07 % Cu were released into the soil eluate during a 28 day of exposure, while in tobacco plants 0.13 % Zn and 0.05 % Cu were accumulated from the total amount of Zn and Cu originated from the application of SSL (Zn – 133 mg and Cu – 23.5 mg). When applying SSL in amount 30 t.ha-1 i.e., in the dose exceeding the permitted limits, only 0.02 % Zn and 0.04 % Cu were released into the soil eluate and 0.16 % Zn and 0.09 % Cu were accumulated in tobacco plants from the applied amount of SSL (Zn – 267 mg and Cu – 47.0 mg).

2013 ◽  
Vol 671-674 ◽  
pp. 2736-2741
Author(s):  
Yin An Ming ◽  
Tao Tao

To reuse municipal sewage sludge safely, experiment was carried out on grapefruit trees fertilized with composted sludge from Shiweitou Sewage Treatment Plant in Xiamen City of China, and a method was introduced of how to assess the environmental quality of grapefruit trees soil fertilized with sludge by Set Pair Analysis (SPA) model. The results showed that the soil in the surface layer (0-15cm) and the deeper layer (15-30cm) was less clean, and the environment of soil was not polluted. Thus it was feasible to use sludge as fruit fertilizer. The maximum service life of sludge for continuous land application was estimated by taking Cd as the limiting factor, which would provide scientific guide and technical support for safe land application of sludge.


Author(s):  
A. Ribeiro ◽  
J. Araújo ◽  
A. Mota ◽  
R. Campos ◽  
C. Vilarinho ◽  
...  

Abstract A large quantity of sludges resulting from the treatment of MWWTP (Municipal Wastewater Treatment Plant) effluent is generated annually following the increase of population density and acceleration of urbanization. Sludge production in Europe has been predicted by around 12 million tons in 2020. As a solid waste, appropriate disposal of Municipal Sewage Sludge (MSS) has been taken seriously due to its larger volume and toxic substances such as heavy metals. Electrokinetic remediation has more advantages in heavy metals uptake compared to other technologies, due to the ability to treat soils in-situ and to remove heavy metals from soils. In this work, it was studied the remediation of MSS by the electrokinetic remediation coupled with activated carbon (AC) as a permeable reactive barrier (PRB). It was applied an electric current of 3 V cm−1 and it was used an AC/sludge ratio of 30 g kg−1 of contaminated sludge for the preparation of the PRB. In each trial, the evolution of cadmium (Cd), lead (Pb), copper (Cu), chromium (Cr), nickel (Ni) and zinc (Zn) removal from the sludge were evaluated. Results proved that this process is perfectly suited for the removal of chromium, nickel and zinc metals from the sludge. At the end of the operation time, it was achieved a maximum removal rate of 56% for chromium, 73% for nickel and 99% for zinc, with initial concentrations of 2790 mg kg−1, 2840 mg kg−1, and 94200 mg kg−1, respectively. Based on these results, it was proved the technical viability of the proposed technology (electrokinetic with AC as a permeable reactive barrier) to treat municipal sewage sludges.


2016 ◽  
Vol 22 (3) ◽  
pp. 157-166 ◽  
Author(s):  
Elżbieta Włodarczyk ◽  
Marta Próba ◽  
Lidia Wolny

Abstract Aim of this study was to evaluate the ecotoxicity of municipal sewage sludge conditioned with polyelectrolytes, taken from selected sewage treatment plant. Using the bioindication analysis overall toxicity was assessed, which allows to know the total toxicity of all the harmful substances contained in sewage sludge, in many cases acting synergistically. To prepare a sample of sludge for the basic test, all analyses were performed with a ratio of liquid to solid of 10:1 (water extract). Daphnia pulex biological screening test was used. A dilution series of an water extract of sludge were prepared to include within its scope the lowest concentration that causes 100% effect and the highest producing less than 10% of the effect within a specified range of the assay. The results of the test were read after 24 and 48 hours. Based on the research and analysis of test results it proved that the sewage sludge conditioned with polyelectrolytes exhibit the characteristics of eco-toxic.


2018 ◽  
Vol 53 (1) ◽  
pp. 14-23 ◽  
Author(s):  
Petra C. Lindholm-Lehto ◽  
Heidi S. J. Ahkola ◽  
Juha S. Knuutinen

Abstract Concentrations of pharmaceuticals, consisting of four anti-inflammatory and one antiepileptic drug, were studied in the aqueous and solid phase of municipal sewage sludge, collected from a wastewater treatment plant (WWTP) in central Finland. The samples included untreated municipal sludge from the biological wastewater treatment, digested sludge and sludge before and after composting. First, samples were taken as grab samples to study the bioavailable part in aqueous phase but also the part in solid fraction. Later, the long-term concentrations were studied by passive sampling with styrene divinylbenzene-reverse phase sulfonated (SDB-RPS) disks. In the untreated solid sludge, the concentrations of carbamazepine, diclofenac, ibuprofen, ketoprofen, and naproxen were 0.5 ng g−1, 26 ng g−1, 29 ng g−1, 250 ng g−1, and 13 ng g−1, while in liquid phase they were 5.6 ng L−1, 200 ng L−1, 210 ng L−1, 35 ng L−1, and 55 ng L−1, respectively. Concentrations decreased with the treatment steps but substantial amounts still occured even after the final stage. The results show that current sludge treatment cannot fully remove pharmaceuticals, leaving varying concentrations after each stage. Additionally, the results suggest that SDB-RPS disks are suitable for sampling and quantification of the bioavailable fraction of pharmaceuticals in municipal sludge.


Author(s):  
C. González ◽  
B. Fernández ◽  
F. Molina ◽  
M. A. Camargo-Valero ◽  
C. Peláez

Abstract Struvite from nutrient-rich wastewaters has been identified as a potential substitute for commercial mineral fertilisers, with the added benefit of reducing threats to global food security by prolonging phosphate rock reserves. A fertilisation test using grass (Brachiaria brizantha Marandú) and a sand column leaching test was conducted to determine the agronomic effectiveness of struvite precipitates produced from the supernatant of dewatered sewage sludge (centrate) from a municipal Wastewater Treatment Plant (WWTP). The performance of this struvite as a fertiliser was compared with Biosolids and commercial fertilisers (Urea and Triple15). The results show that the concentration of heavy metals in struvite was lower than in Biosolids and below the limits of Colombia and European fertiliser regulations. Struvite increased the uptake of N and P in grass, resulting in crop yields similar to other treatments tested. Struvite use as an effective slow-release fertiliser is highly dependent on the size of crystal particles, particularly in achieving low P losses but resulted in high N loss in the sand columns tested; N loses from struvite were higher than in the commercial fertilisers due to the struvite small particle size. Therefore, struvite represents a suitable opportunity to recover and recycle nutrients from municipal sewage sludge, facilitating the effective reuse of P and N in agriculture and uptake by plants.


2013 ◽  
Vol 28 (S2) ◽  
pp. S425-S435 ◽  
Author(s):  
B. Peplinski ◽  
C. Adam ◽  
B. Adamczyk ◽  
R. Müller ◽  
R. Schadrack ◽  
...  

Evidence is provided that the tridymite component observed in the X-ray diffraction patterns of some sewage sludge ashes (SSAs) should not be interpreted as the tridymite modification of SiO2 but as the tridymite form of AlPO4. This proof is based on a combined X-ray Powder Diffraction (XRD), X-ray fluorescence (XRF) and Mossbauer spectroscopy investigation of two SSAs produced at two fluidized bed incineration facilities, located in different municipalities and operated differently. The structural and chemical characterization was carried out on the ‘as received’ SSA samples as well as on the residues of these two SSAs pretreated by leaching in citric acid. In addition, direct proof is presented that the tridymite form of AlPO4 does crystallize from X-ray amorphous precursors under conditions that mimic the huge heating rate and short retention time (just seconds at T ≈ 850 °C) typical for fluidized bed incinerators.


2008 ◽  
Vol 198 (1-4) ◽  
pp. 133-148 ◽  
Author(s):  
G. Egiarte ◽  
G. Corti ◽  
M. Pinto ◽  
J. Arostegui ◽  
F. Macías ◽  
...  

2014 ◽  
Vol 955-959 ◽  
pp. 2940-2943
Author(s):  
Ke Zhao ◽  
Yu Zhang ◽  
Yu Ting Zhang ◽  
Ying Ying Yin

Based on the static composting process of municipal sewage sludge, the parameters of the treatment process were studied, including moisture, temperature, pH, organic matter, total phosphorus, the number of bacterial and GI(Germination Index). The decomposition of organic matter and phosphorus concentration were obvious and the amount of bacteria varied regularly. After the composting, pH, water contend, organic matter and GI all met Disposal of sludge from municipal wastewater treatment plant-Control standard for agricultural use.


2016 ◽  
Vol 23 (4) ◽  
pp. 665-675 ◽  
Author(s):  
Grzegorz Wielgosiński ◽  
Robert Cichowicz ◽  
Jacek Wiśniewski

Abstract In quantitative terms, sludge produced in the process of municipal wastewater treatment represents a small part of the total waste generated in municipal sources - its quantity represents only a few percent of the generated mass of municipal waste. However, the threats it brings, do not allow it to be neglected while designing the wastewater treatment process. At the same time, with increasing requirements regarding the quality of sewage discharged into the environment, there is an increase in the amount of sludge produced in wastewater treatment processes. In recent years, the share of thermal treatment of municipal sewage sludge has risen sharply - about 12 modern sludge incineration plants have been built and construction of new ones is considered. During more than a four-year operation of the sewage sludge incineration plant in the Combined Sewage Treatment Plant in Lodz (GOS) a large ammonia emission from the combustion process was observed. So, a decision was taken to examine this process. The paper presents results of ammonia emission from the combustion of sewage sludge from GOS as a function of temperature.


Energies ◽  
2021 ◽  
Vol 14 (2) ◽  
pp. 316
Author(s):  
Mariusz Tańczuk ◽  
Wojciech Kostowski

The treatment of growing production of municipal sewage sludge has become a significant global problem. Drying of digested sewage sludge is a promising alternative to sludge disposal at dumping sites. The research objective of this study was to find the optimal heat source for a sludge drying plant in a large municipal sewage treatment plant (people equivalent: 250,000). Two boundary heat supply cases were analyzed in the paper: cogeneration of heat and power (CHP) units, internal combustion (IC) engines fired with natural gas, and plant supplied with a gas boiler. The aim of the research was to find the optimal size of the cogeneration unit cooperating with the gas boiler as heat sources for a given drying plant case with the maximum net present (NPV) value as the objective function. The results of the conducted optimization show higher profitability of cases with larger cogeneration unit. For the basic assumptions, the maximum NPV is obtained for the largest analyzed CHP unit: 1300 kW of thermal power output. Sensitivity analyses show that the varying gas and electricity prices can relocate the NPV maximum towards smaller CHP sizes. A supplementary energy analysis shows that implementing larger CHP units yields a higher energy efficiency of the system, up to 0.52.


Sign in / Sign up

Export Citation Format

Share Document