Various Replacement Rate Experimental Study on Recycled Concrete

2014 ◽  
Vol 507 ◽  
pp. 273-276
Author(s):  
Jian Qiang Han ◽  
Na Yang ◽  
Xiu Yan Fu
Keyword(s):  
Experimental Study ◽  
Compressive Strength ◽  
Recycled Concrete ◽  
Replacement Rate ◽  
Replacement Ratio ◽  
Basic Properties ◽  
Compressive Strength Of Concrete

Through summarizing and analyzing the domestic and foreign research different replacement ratio of recycled concrete, summarizes the basic properties of recycled concrete with different replacement rate, experimental study on the compressive strength of concrete, explains the replacement rate of recycled concrete, provides the reference for the development and application of recycled concrete.

Experimental Study on Compressive Strength of Recycled Aggregate Concrete with Different Replacement Ratios

2012 ◽  
Vol 174-177 ◽  
pp. 1277-1280 ◽  
Author(s):  
Hai Yong Cai ◽  
Min Zhang ◽  
Ling Bo Dang
Keyword(s):  
Experimental Study ◽  
Compressive Strength ◽  
Failure Mode ◽  
Failure Process ◽  
Recycled Concrete ◽  
Recycled Aggregate Concrete ◽  
Recycled Aggregate ◽  
Recycled Aggregates ◽  
Replacement Ratio ◽  
Aggregate Concrete

Compressive strengths of recycled aggregate concrete(RAC) with different recycled aggregates(RA) replacement ratios at 7d, 28d, 60d ages are investigated respectively. Failure process and failure mode of RAC are analyzed, influences on compressive strength with same mix ratio and different RA replacement ratios are analyzed, and the reason is investigated in this paper. The experimental results indicate that compressive strength of recycled concrete at 28d age can reach the standard generally, it is feasible to mix concrete with recycled aggregates, compressive strength with 50% replacement ratio is relatively high.

Experimental Study on Mechanical Properties of Recycled Concrete Specimens of Marine Engineering

2011 ◽  
Vol 71-78 ◽  
pp. 331-337
Author(s):  
Wen Bai Liu ◽  
Xia Li
Keyword(s):  
Mechanical Properties ◽  
Experimental Study ◽  
Engineering Application ◽  
Recycled Concrete ◽  
Recycled Aggregate ◽  
Replacement Rate ◽  
Replacement Ratio ◽  
Ordinary Concrete ◽  
Seawater Corrosion ◽  
Marine Engineering

Mechanical properties of recycled concrete under different conditions were studied in this paper. Based on three kinds of replacement percentage of recycled aggregate and four kinds of seawater corrosion conditions, the experimental study of mechanical properties of recycled concrete specimens corroded by seawater and produced under vacuum conditions were conducted, and compared with that of ordinary concrete specimens. Testing results show that compressive strength of recycled concrete decreases with the increase of both the replacement rate of recycled aggregate and the corrosion time by seawater, with the maximum reduce value is 17.96% and 24.52%; Vacuum conditions effectively improve the strength of recycled concrete, improved value is 1.03-1.19 times of the same replacement ratio of recycled aggregate, and 1.00-1.16 times of the ordinary concrete. It provides the reference for marine engineering application of recycled concrete.

Experimental Study on Strength of Recycled Concrete

2013 ◽  
Vol 357-360 ◽  
pp. 1282-1285
Author(s):  
Hai Yong Cai ◽  
Li Bin Fu ◽  
Ling Bo Dang
Keyword(s):  
Mechanical Properties ◽  
Experimental Study ◽  
Tensile Strength ◽  
Compressive Strength ◽  
Great Influence ◽  
Recycled Concrete ◽  
Replacement Ratio ◽  
Cement Ratio ◽  
Water Cement Ratio ◽  
Concrete Mechanical Properties

Influence of replacement ratio and water-cement ratio on the recycled concrete mechanical properties were analyzed by testing the compressive strength and tensile strength of the recycled concrete. Results show that the mechanical properties of recycled concrete, compared with common concrete, can meet the requirements of the project. Water-cement ratio has great influence on compressive strength and tensile strength, replacement ratio has obvious influence on compressive strength but little on tensile.

Different Replacement Rate of Recycled Aggregate Concrete Research

2014 ◽  
Vol 507 ◽  
pp. 269-272 ◽  
Author(s):  
Jian Qiang Han ◽  
Ya Hui Pei ◽  
Chun Fang Tian ◽  
Yu Nan Wang
Keyword(s):  
Recycled Concrete ◽  
Recycled Aggregate Concrete ◽  
Concrete Research ◽  
Recycled Aggregate ◽  
Replacement Rate ◽  
Replacement Ratio ◽  
Aggregate Concrete ◽  
Basic Properties ◽  
At Home

This article mainly research on different replacement rate of recycled concrete at home and abroad are summarized , and expounds the various researchers in the research of recycled concrete. Outlines the basic properties of recycled concrete, and explain the effects of replacement ratio of recycled concrete, for the development and application of recycled concrete are proposed.

Study on the Mechanical Properties and Frost Resistance of Recycled Concrete Prepared by Village Construction Wastes

2011 ◽  
Vol 418-420 ◽  
pp. 406-410
Author(s):  
Jun Liu ◽  
Yao Li ◽  
Dan Dan Hong ◽  
Yu Liu
Keyword(s):  
Mechanical Properties ◽  
Compressive Strength ◽  
Frost Resistance ◽  
Cement Mortar ◽  
Strength Loss ◽  
Recycled Concrete ◽  
Recycled Aggregate ◽  
Replacement Rate ◽  
Concrete Mechanical Properties ◽  
Better Than

Abstract. Recycled aggregate—rural building material wastes pretreated by cement mortar—are applied into concrete with different replacement rates: 0, 25%, 50%, 75%, and 100%. Results from measurements of compressive strength, cleavage tensile strength, mass loss after fast freeze-thaw cycles, and compressive strength loss indicate that a different recycled aggregate replacement rate certainly influences concrete mechanical properties and frost resistance. Recycled aggregate replacement rates less than 75% performs better than common concrete. Data from the 100% replacement rate is worse than that of rates less than 75% but still satisfy the general demands of GB standard on C30 concrete.

Experimental Study on Sand and Cement Replacement by Termite Mound Soil

2019 ◽  
pp. 279-287
Author(s):  
Harish R ◽  
Ramesh S ◽  
Tharani A ◽  
Mageshkumar P
Keyword(s):  
Experimental Study ◽  
Experimental Investigation ◽  
Compressive Strength ◽  
Natural Environment ◽  
Fine Aggregate ◽  
Test Results ◽  
Termite Mound ◽  
Cement Concrete ◽  
Cement Ratio ◽  
Compressive Strength Of Concrete

This paper presents the results of an experimental investigation of the compressive strength of concrete cubes containing termite mound soil. The specimens were cast using M20 grade of concrete. Two mix ratios for replacement of sand and cement are of 1:1.7:2.7 and 1:1.5:2.5 (cement: sand: aggregate) with water- cement ratio of 0.45 and varying combination of termite mound soil in equal amount ranging from 30% and 40% replacing fine aggregate (sand) and cement from 10%,15%,20% were used. A total of 27 cubes, 18 cylinders and 6 beams were cast by replacing fine aggregate, specimens were cured in water for 7,14 and 28 days. The test results showed that the compressive strength of the concrete cubes increases with age and decreases with increasing percentage replacement of cement and increases with increasing the replacement of sand with termite mound soil cured in water. The study concluded that termite mound cement concrete is adequate to use for construction purposes in natural environment.

Experimental Study on Alkali-Activated Slag-Lithium Slag-Fly Ash Environmental Concrete

2011 ◽  
Vol 287-290 ◽  
pp. 1237-1240
Author(s):  
Lan Fang Zhang ◽  
Rui Yan Wang
Keyword(s):  
Experimental Study ◽  
Compressive Strength ◽  
Fly Ash ◽  
Setting Time ◽  
Alkali Activated Slag ◽  
Percent Increase ◽  
Compressive Strength Of Concrete ◽  
Activated Slag ◽  
Lithium Slag ◽  
Alkali Activated

The aim of this paper is to study the influence of lithium-slag and fly ash on the workability , setting time and compressive strength of alkali-activated slag concrete. The results indicate that lithium-slag and fly-ash can ameliorate the workability, setting time and improve the compressive strength of alkali-activated slag concrete，and when 40% or 60% slag was replaced by lithium-slag or fly-ash, above 10 percent increase in 28-day compressive strength of concrete were obtained.

Compressive Strength of Concrete from Lightweight Bubbles Aggregate

2015 ◽  
Vol 754-755 ◽  
pp. 348-353 ◽  
Author(s):  
Norlia Mohamad Ibrahim ◽  
Leong Qi Wen ◽  
Mustaqqim Abdul Rahim ◽  
Khairul Nizar Ismail ◽  
Roshazita Che Amat ◽  
...  
Keyword(s):  
Mechanical Properties ◽  
Experimental Study ◽  
Compressive Strength ◽  
Natural Resources ◽  
Concrete Structure ◽  
Concrete Mixture ◽  
New Materials ◽  
Concrete Mixtures ◽  
Compressive Strength Of Concrete

Compressive strength of concrete is the major mechanical properties of concrete that need to be focused on. Poor compressive strength will lead to low susceptibility of concrete structure towards designated actions. Many researches have been conducted to enhance the compressive strength of concrete by incorporating new materials in the concrete mixture. The dependencies towards natural resources can be reduced. Therefore, this paper presents the results of an experimental study concerning the incorporation of artificial lightweight bubbles aggregate (LBA) into cementations mixture in order to produce comparable compressive strength but at a lower densities. Three concrete mixtures containing various percentages of LBA, (10% - 50% of LBA) and one mixture used normal aggregate (NA) were prepared and characterized. The compressive strength of LBA in concrete was identified to be ranged between 39 MPa and 54 MPa. Meanwhile, the densities vary between 2000 kg/m3 to 2300 kg/m3.

On Effects of Fly Ash as a Partial Replacement of Cement on Concrete Strength

2012 ◽  
Vol 204-208 ◽  
pp. 3970-3973
Author(s):  
Reagan J. Case ◽  
Kai Duan ◽  
Thuraichamy G. Suntharavadivel
Keyword(s):  
Compressive Strength ◽  
Fly Ash ◽  
Concrete Strength ◽  
Cementitious Materials ◽  
Partial Replacement ◽  
Replacement Ratio ◽  
Interface Reactions ◽  
Compressive Strength Of Concrete ◽  
Interface Bonding Strength ◽  
Large Research

As a part of a large research program aiming at the cementitious materials containing recycled materials at Central Queensland University – Australia, the current paper presents the preliminary results of a study on the effects of fly ash, which is used to replace cement in concrete, on the concrete compressive strength. For this purpose, systematic experiments have been carried out to investigate the influences of fly ash ratio and age. The compressive strength of concrete specimens with replacement ratios of 15%, 30% and 45%, and aged 7 and 28 days are measured and are compared with those of the concrete specimens without fly ash at the same ages. The results demonstrate that the strength of fly ash containing concrete improves more slowly but more strongly with aging, than their fly ash free counterparts, and an optimum fly ash replacement ratio exists where the maximum compressive strength of fly ash containing concrete can be achieved, and the maximum strength for the specimens aged 28 days and above is higher that of fly ash free concrete. Furthermore, the observation strength behaviours are analysed and discussed in terms of the influences of fly ash on interface reactions and interface bonding strength.

Sign in / Sign up

Export Citation Format

Share Document