Physiochemical Properties of Pyrolysis Oil Derived from Fast Pyrolysis of Wet and Dried Rice Husk in a Free Fall Reactor

2014 ◽  
Vol 625 ◽  
pp. 604-607 ◽  
Author(s):  
Salman Raza Naqvi ◽  
Yoshimitsu Uemura ◽  
Noridah Binti Osman ◽  
Suzana Yusup ◽  
Mohd Fadhil Nuruddin

Rice husk is considered as a massive agricultural lignocellulosic biomass residue for the production of bio-based fuels and chemicals products. The purpose of this study is to investigate the physiochemical properties of the pyrolysis-oil derived from wet and dried rice husk fast pyrolysis process. The experiments were performed in a drop type fixed-bed pyrolyzer at the pyrolysis temperature of 350 to 600 °C. The products, char, pyrolysis-oil and gas, yield are investigated. The pyrolysis-oil derived from dried rice husk contained higher Carbon and Hydrogen and less oxygen contents than the pyrolysis-oil obtained from wet rice husk. FT-IR results showed the oxygenated compounds present in both pyrolysis-oil. The pyrolysis oil from dried rice husk has higher concentration of hydrocarbons as compared to wet rice husk pyrolysis-oil. The dried rice husk pyrolysis-oil produced more phenols and less carboxylic acid as compared to wet rice husk pyrolysis-oil at 500 °C. More volatile released in dried rice husk conversion produced more volatile compounds. These findings suggest that the original moisture present in biomass samples is the major influencing parameter on the thermal degradation of biomass during fast pyrolysis process.

2020 ◽  
Vol 0 (0) ◽  
Author(s):  
Ige Ayodeji Rapheal ◽  
Elinge Cosmos Moki ◽  
Aliyu Muhammad ◽  
Gwani Mohammed ◽  
Lawal Hassan Gusau

AbstractThe study depicts the production, optimization and characterization of bio-oil from pyrolyzed rice husk using a fabricated fixed bed reactor. The pyrolysis process was conducted with bio-oil response, bio-char response and non-condensable gases response as products. The effect of pyrolysis variables were observed by the production of the bio-oil as the response. Sixty runs of pyrolysis experiments were suggested by Box Benkhen design indicated optimum pyrolysis conditions at particle size of 2.03mm mesh, reaction time of 81.80 mins and temperature of 650oC for rice husk. The maximum bio-oil yield was obtained with 38.39% at optimum condition of the variables. The bio-oil sample obtained had better performance compared with ASTM standard. Such a determination would contribute so immensely to a significant comprehension of the chemical efficiency of the pyrolysis reaction.


2017 ◽  
Vol 102 ◽  
pp. 13-22 ◽  
Author(s):  
Yuan Zhang ◽  
Hongyou Cui ◽  
Weiming Yi ◽  
Feng Song ◽  
Pingping Zhao ◽  
...  

2019 ◽  
Vol 13 (1) ◽  
pp. 4636-4647 ◽  
Author(s):  
N. I. Izzatie ◽  
M. H. Basha ◽  
Y. Uemura ◽  
M. S. M. Hashim ◽  
M. Afendi ◽  
...  

Co-pyrolysis of rubberwood sawdust (RWS) waste and polypropylene (PP) was carried out at different temperatures (450,500,550, and 600°C) with biomass to plastics ratio 1:1 by using fixed bed drop-type pyrolyzer. The yield of pyrolysis oil has an increasing trend as the temperature increased from 450°C to 550°C. However, the pyrolysis oil yield dropped at a temperature of 600°C. Co-pyrolysis of RWS and PP generated maximum pyrolysis oil with 36.47 wt.% at 550°C. The result is compared with the pyrolysis of RWS only without plastics, with the same feedstock, and the maximum pyrolysis oil yield obtained was 33.3 wt.%. The water content in pyrolysis oil of co-pyrolysis RWS with PP is lower than RWS only with 54.2 wt.% and 62 wt.% respectively. Hydrocarbons, acyclic olefin, alkyl, and aromatic groups are the major compound in the pyrolysis oil from the co-pyrolysis process. Carbon monoxide (52.2 vol.%) and carbon dioxide (38.2 vol.%) are the major gas components.


2021 ◽  
Author(s):  
Koson Rueangsan ◽  
Pakkip Kraisoda ◽  
Adcha Heman ◽  
Homhuan Tasarod ◽  
Monchawan Wangkulangkool ◽  
...  

2018 ◽  
Vol 27 (4) ◽  
pp. 1305-1311 ◽  
Author(s):  
A.M. Shoaib ◽  
R.A. El-Adly ◽  
M.H.M. Hassanean ◽  
A. Youssry ◽  
A.A. Bhran

Sign in / Sign up

Export Citation Format

Share Document