Effect of GGBFS on Compressive Strength and Durability of Concrete

2018 ◽  
Vol 1145 ◽  
pp. 22-26 ◽  
Author(s):  
Mao Chieh Chi ◽  
Jen Hao Chi ◽  
Chung Hao Wu
Keyword(s):  
Compressive Strength ◽  
Electrical Resistivity ◽  
Water Absorption ◽  
Chloride Permeability ◽  
Supplementary Cementitious Material ◽  
Cement Replacement ◽  
Granulated Blast Furnace Slag ◽  
Compressive Strength Test ◽  
Strength And Durability ◽  
Durability Of Concrete

Facing the cement and concrete development process, reducing greenhouse gases and the consumption of natural resources has become an important issue. To reduce the cement content in concrete, the increased use of concrete combining large amounts of industrial by-products is expected. Ground granulated blast furnace slag (GGBFS) has been used as a supplementary cementitious material in ordinary Portland cement (OPC) concrete. In this study, GGBFS at different cement replacement ratios of 0%, 20%, 40%, and 60% by weight were used to produce concrete. Compressive strength test, water absorption, electrical resistivity, and rapid chloride penetration test (RCPT) were performed to investigate the effect of GGBFS on compressive strength and durability of concrete. Test results show that GGBFS concrete with 40% cement replacement (G40) has the highest compressive strength. The water absorption and chloride permeability reduced with the increasing cement replacement percentage by GGBFS. Meanwhile, the electrical resistivity increased with an increasing GGBFS replacement percentage. Based on the results, GGBFS concrete with 40% cement replacement seems to be the optimum replacement in this study.

Effect of ground granulated blast funrnace slag and fly ash on strength, permeability, and under-water abrasion of fine-grained concrete

2020 ◽  
Vol 71 (7) ◽  
pp. 775-788
Author(s):  
Quyet Truong Van ◽  
Sang Nguyen Thanh
Keyword(s):  
Fly Ash ◽  
Concrete Strength ◽  
Cementitious Materials ◽  
Supplementary Cementitious Materials ◽  
Chloride Permeability ◽  
Cement Replacement ◽  
Fine Grained ◽  
Granulated Blast Furnace Slag ◽  
Compressive Strength Test ◽  
Economic Ground

The utilisation of supplementary cementitious materials (SCMs) is widespread in the concrete industry because of the performance benefits and economic. Ground granulated blast furnace slag (GGBFS) and fly ash (FA) have been used as the SCMs in concrete for reducing the weight of cement and improving durability properties. In this study, GGBFS at different cement replacement ratios of 0%, 20%, 40% and 60% by weight were used in fine-grained concrete. The ternary binders containing GGBFS and FA at cement replacement ratio of 60% by weight have also evaluated. Flexural and compressive strength test, rapid chloride permeability test and under-water abrasion test were performed. Experimental results show that the increase in concrete strength with GGBFS contents from 20% to 40% but at a higher period of maturity (56 days and more). The chloride permeability the under-water abrasion reduced with the increasing cement replacement by GGBFS or a combination of GGBFS and FA

scholarly journals Effect of ground granulated blast funrnace slag and fly ash on strength, permeability, and under-water abrasion of fine-grained concrete

2020 ◽  
Vol 71 (7) ◽  
pp. 775-788
Author(s):  
Quyet Truong Van ◽  
Sang Nguyen Thanh
Keyword(s):  
Fly Ash ◽  
Concrete Strength ◽  
Cementitious Materials ◽  
Supplementary Cementitious Materials ◽  
Chloride Permeability ◽  
Cement Replacement ◽  
Fine Grained ◽  
Granulated Blast Furnace Slag ◽  
Compressive Strength Test ◽  
Economic Ground

The utilisation of supplementary cementitious materials (SCMs) is widespread in the concrete industry because of the performance benefits and economic. Ground granulated blast furnace slag (GGBFS) and fly ash (FA) have been used as the SCMs in concrete for reducing the weight of cement and improving durability properties. In this study, GGBFS at different cement replacement ratios of 0%, 20%, 40% and 60% by weight were used in fine-grained concrete. The ternary binders containing GGBFS and FA at cement replacement ratio of 60% by weight have also evaluated. Flexural and compressive strength test, rapid chloride permeability test and under-water abrasion test were performed. Experimental results show that the increase in concrete strength with GGBFS contents from 20% to 40% but at a higher period of maturity (56 days and more). The chloride permeability the under-water abrasion reduced with the increasing cement replacement by GGBFS or a combination of GGBFS and FA

scholarly journals Fresh, Mechanical, and Durability Properties of Self-Compacting Mortar Incorporating Alumina Nanoparticles and Rice Husk Ash

Materials ◽  
2021 ◽  
Vol 14 (22) ◽  
pp. 6778
Author(s):  
Bahareh Mehdizadeh ◽  
Soheil Jahandari ◽  
Kirk Vessalas ◽  
Hania Miraki ◽  
Haleh Rasekh ◽  
...  
Keyword(s):  
Electrical Resistivity ◽  
Flexural Strength ◽  
Water Absorption ◽  
Rice Husk ◽  
Rice Husk Ash ◽  
Alumina Nanoparticles ◽  
Chloride Permeability ◽  
Cement Replacement ◽  
Durability Properties ◽  
Durability Performance

This paper presents a comprehensive evaluation on self-compacting (SC) mortars incorporating 0, 1, 3, and 5% alumina nanoparticles (NA) as well as 0% and 30% rice husk ash (RHA) used as Portland cement replacement. To evaluate the workability, mechanical, and durability performance of SC mortars incorporating NA and RHA, the fresh properties (slump flow diameter and V-funnel flow time), hardened properties (compressive strength, flexural strength, and ultrasonic pulse velocity), and durability properties (water absorption, rapid chloride permeability, and electrical resistivity) were determined. The results indicated that the addition of NA and RHA has negligible effect on the workability and water absorption rate of the SC mortars. However, significant compressive and flexural strength development was observed in the SC mortars treated with NA or the combination of NA and RHA. The introduction of RHA and NA also reduced the rapid chloride permeability and enhanced the electrical resistivity of the SC mortars significantly. It is concluded that the coexistence of 30% RHA and 3% NA as cement replacement in SC mortars can provide the best mechanical and durability performance.

scholarly journals The Hydration, Mechanical, Autogenous Shrinkage, Durability, and Sustainability Properties of Cement–Limestone–Slag Ternary Composites

2021 ◽  
Vol 13 (4) ◽  
pp. 1881
Author(s):  
Mei-Yu Xuan ◽  
Yi Han ◽  
Xiao-Yong Wang
Keyword(s):  
Compressive Strength ◽  
Electrical Resistivity ◽  
Experimental Studies ◽  
Autogenous Shrinkage ◽  
Ultrasonic Pulse Velocity ◽  
Ultrasonic Pulse ◽  
Pulse Velocity ◽  
Hydration Heat ◽  
Granulated Blast Furnace Slag ◽  
Binder Ratio

This study examines the hydration–mechanical–autogenous shrinkage–durability–sustainability properties of ternary composites with limestone filler (LF) and ground-granulated blast furnace slag (BFS). Four mixtures were prepared with a water/binder ratio of 0.3 and different replacement ratios varying from 0 to 45%. Multiple experimental studies were performed at various ages. The experimental results are summarized as follows: (1) As the replacement levels increased, compressive strength and autogenous shrinkage (AS) decreased, and this relationship was linear. (2) As the replacement levels increased, cumulative hydration heat decreased. At the age of 3 and 7 days, there was a linear relationship between compressive strength and cumulative hydration heat. (3) Out of all mixtures, the ultrasonic pulse velocity (UPV) and electrical resistivity exhibited a rapid increase in the early stages and tended to slow down in the latter stages. There was a crossover of UPV among various specimens. In the later stages, the electrical resistivity of ternary composite specimens was higher than plain specimens. (4) X-ray diffraction (XRD) results showed that LF and BFS have a synergistic effect. (5) With increasing replacement ratios, the CO2 emissions per unit strength reduced, indicating the sustainability of ternary composites.

scholarly journals Properties of Self-curing High Strength Concrete by using Baby Polymer Diapers

2018 ◽  
Vol 203 ◽  
pp. 06022
Author(s):  
Salmia Beddu ◽  
Daud Mohamad ◽  
Fadzli Mohamed Nazri ◽  
Siti Nabihah Sadon ◽  
Mohamed Galal Elshawesh
Keyword(s):  
Compressive Strength ◽  
High Strength Concrete ◽  
Drying Shrinkage ◽  
High Strength ◽  
Strength Test ◽  
Curing Process ◽  
Compressive Strength Test ◽  
Mechanical And Physical Properties ◽  
Compressive Strength Of Concrete ◽  
Strength And Durability

This study investigates the self-curing concrete using baby polymer diapers as substitute method of curing process in order to improve mechanical and physical properties of concrete. Three different proportion of baby polymer diapers which are 1%, 3% and 5% were mix with concrete. Slump, compressive strength and drying shrinkage test were performed in order to study the workability, strength and durability of the concrete. All concrete were tested for 1, 3, 7, 14, and 28 days for drying shrinkage test. Meanwhile, all concrete were test at 3, 7 and 28 days for compressive strength test. Compressive strength of concrete containing 5% baby polymer diapers show the highest strength at 28 days compared to others percentage. Thus, it indicates that application of baby polymer diaper as self-cure agent can improve the concrete performances.

scholarly journals Effect of fine recycled aggregates on the properties of non-cement blended materials

2020 ◽  
Vol 323 ◽  
pp. 01018
Author(s):  
Wei-Ting Lin ◽  
Lukáš Fiala ◽  
An Cheng ◽  
Michaela Petříková
Keyword(s):  
Compressive Strength ◽  
Blast Furnace Slag ◽  
Interface Structure ◽  
Strength Test ◽  
Recycled Aggregates ◽  
Test Results ◽  
Granulated Blast Furnace Slag ◽  
Fine Aggregates ◽  
Compressive Strength Test ◽  
Furnace Slag

In this study, the different proportions of co-fired fly ash and ground granulated blast-furnace slag were used to fully replace the cement as non-cement blended materials in a fixed water-cement ratio. The recycled fine aggregates were replaced with natural fine aggregates as 10%, 20%, 30%, 40% and 50%. The flowability, compressive strength, water absorption and scanning electron microscope observations were used as the engineered indices by adding different proportions of recycled fine aggregates. The test results indicated that the fluidity cannot be measured normally due to the increase in the proportion of recycled fine aggregates due to its higher absorbability. In the compressive strength test, the compressive strength decreased accordingly as the recycled fine aggregates increased due to the interface structure and the performance of recycled aggregates. The fine aggregates and other blended materials had poor cementation properties, resulting in a tendency for their compressive strength to decrease. However, the compressive strength can be controlled above 35 MPa of the green non-cement blended materials containing 20% recycled aggregates.

Setting Time and Compressive Strength of Mortar Containing Cockle Shell Powder as Partial Cement Replacement

2021 ◽  
Vol 879 ◽  
pp. 62-67
Author(s):  
Khairunisa Muthusamy ◽  
Rahimah Embong ◽  
Nabilla Mohamad ◽  
Nur Syahira Hanim Kamarul Bahrin ◽  
Fadzil Mat Yahaya
Keyword(s):  
Compressive Strength ◽  
Setting Time ◽  
Cement Replacement ◽  
Compressive Strength Test ◽  
Shell Waste ◽  
Suitable Combination ◽  
Time Test ◽  
Partial Cement Replacement ◽  
Shell Powder ◽  
Cockle Shell

Environmental degradation caused by deforestation activities for harvesting of limestone from the hills and its calcination process at cement factory along with disposal of cockle shell waste from fisheries industries is in need of resolution. In view of sustainable green environment, approach of utilizing cockle shell waste as partial cement replacement in cement production would reduce pollution caused by both industries. Thus, this research investigates the effect of cockle shell powder as partial cement replacement on setting time and compressive strength of mortar. A total of five types of mortar mixes consisting different percentage of cockle shell powder as partial cement replacement from 0%, 10%, 20%, 30%, and 40% by weight of cement were prepared. Setting time test were conducted on fresh paste. All specimens were subjected to water curing until the testing age. Compressive strength test were conducted on hardened mortar cubes at 3, 7 and 28 days. Finding shows that integration of cockle shell powder as partial cement replacement influences the setting time and compressive strength of mortar. Suitable combination of 10% cockle shell powder successfully enhances the compressive strength of mortar. Conclusively, success in transforming the cockle shell waste to be used as partial cement replacement in mortar production able to reduce cement consumption, save landfill usage for trash dumping and promote cleaner environment for healthier lifestyle of community nearby.

Sign in / Sign up

Export Citation Format

Share Document