Vulcanization Kinetics of Natural Rubber Coagulated by Microorganisms with Use of a Vulcameter

2010 ◽  
Vol 160-162 ◽  
pp. 1181-1186 ◽  
Author(s):  
Zhi Feng Wang ◽  
Si Dong Li ◽  
Xiao Dong She

Kinetics of vulcanization of natural rubber coagulated by microorganisms (NR-m) was studied with the use of a vulcameter. In the induction period of vulcanization, the time t0 of NR-m is shorter than that of natural rubber coagulated by acid (NR-a), and the rate constant k1/a of NR-m are greater than that of NR-a. Both the curing periods of NR-m and NR-a consist of two stages. The first stage follows first-order reaction. The rate constants k2 of NR-m in the first stage are greater than that of NR-a at the same temperature, and so are the activation energy E2. The second stage (end stage of the curing period) does not follow first-order reaction, and the calculated reaction order n of NR-m is in the range of 0.82-0.85, and that of NR-a is in the range of 0.64-0.72. The rate constants k3 of the second stage for NR -m are greater than that of NR-a at the same temperature, and so is the activation energy E3.

1959 ◽  
Vol 32 (2) ◽  
pp. 566-576
Author(s):  
Walter Scheele ◽  
Klaus Hummel

Abstract Bound sulfur in a pure thiuram vulcanizate increases relatively rapidly at first at all temperatures, reaches a poorly defined maximum at about 27 to 30%, independent of temperature, and then recedes slightly to reach a limiting value of 25% also independent of temperature, based on the original thiuram disulfide. The rise in sulfur content at the start points to a temperature-independent limiting value of 33%. It is shown that the combination of sulfur in this region initially follows a first order reaction, and goes at the same rate as the reduction in concentration of thiuram disulfide. It can be seen from the above that sulfur may be combined in thiuram vulcanization without simultaneous crosslinking. The dithiocarbamate formation increases rapidly in the region of longer vulcanization times, after the maximum in bound sulfur has been reached, without further combination of sulfur with the vulcanizate. The rate constants for thiuram decrease, for dithiocarbamate increase and for sulfur combination were calculated. The temperature dependence of each of these reactions has practically the same activation energy, 23 kcal/mole. The bound sulfur content of the vulcanizates in pure thiuram vulcanizations is no criterion of the state of vulcanization.


1956 ◽  
Vol 29 (1) ◽  
pp. 37-48 ◽  
Author(s):  
Walter Scheele ◽  
Otto Lorenz

Abstract If we disregard for the moment the phenomena which occur in the interaction of thiuram disulfide with geraniol under the influence of air and confine our consideration to the results which can be deduced from the study of this reaction in a stream of nitrogen, we are led to the conclusion that geraniol, which was used as a model compound, behaves with respect to its interaction with tetraethylthiuram disulfide, not only qualitatively but also quantitatively, exactly like rubber, and that it is not to be assumed that other tetraalkylthiuram disulfides as well as other compounds which are analogous to geraniol will behave differently. Thus the results can be evaluated as a proof that the vulcanization of natural rubber by thiuram disulfides depends on nothing other than a definite and always similar interaction with the allyl groups of the polyisoprene chain. The results of the investigation described in this paper can be regarded, moreover, as support for the correctness of our procedure in the clarification of the vulcanization mechanisms, and they stress the importance of analytical-chemical methods, which have certainly not been pursued in the past with the necessary intensity and insight. These investigations are being continued. It has already been found that the vulcanization of natural rubber with thiuram monosulfides and sulfur leads to the same results as vulcanization with thiuram disulfides. This has been conjectured, to be sure, by a number of workers. However, it was never really demonstrated experimentally. We shall report on this in the near future. The experimental results can now be summarized as follows : 1. The reaction between thiuram disulfide and geraniol (demonstrated by the example of tetraethylthiuram disulfide) takes place qualitatively and quantitatively like the interaction between thiuram disulfide and natural rubber. In the vulcanization of rubber by thiuram disulfides, therefore, there is involved a reaction of the thiuram disulfide with the allyl groups, leading to a definite conversion. 2. It was found that in the interaction of geraniol with thiuram disulfide under nitrogen and in the presence of zinc oxide, the limiting value of zinc dithiocarbamate amounts to 66 mole-per cent of the original thiuram disulfide, independent of the temperature. This was the result found in the study of the reaction of the thiuram disulfides with rubber. 3. We were able to show that the limiting value of the dithiocarbamate yield in the interaction of tetraethylthiuram disulfide with geraniol is independent of the thiuram disulfide concentration. This is likewise true for the reaction of the thiuram disulfides with natural rubber. From this it follows that the interaction of thiuram disulfides with allyl groupings, as they occur in the polyisoprene chain, is apparently a stoichiometric one. For this reason we can no longer retain the assumption that the limiting value of the yield of dithiocarbamate is the result of a sterically hindered reaction. 4. The change of concentration of zinc dithiocarbamate in the interaction of tetraethylthiuram disulfide with geraniol under nitrogen can be accounted for by postulating a reaction of the first order. The velocity constants were calculated and it was found that the resulting activation energy is somewhat greater than the one for the interaction with natural rubber. 5. Similarly the concentration of thiuram disulfide obeys a first-order reaction as it falls off to zero. The velocity constants were calculated. The activation energy obtained from the temperature dependence is in good agreement with that found for the interaction with rubber. 6. In the presence of oxygen, the reaction between thiuram disulfide and geraniol takes a quite different course. The rate of decrease of concentration of thiuram disulfide, which likewise follows a first-order reaction, is higher. The yield of zinc dithiocarbamate does not attain the constant value of 66 mole-per cent of the original thiuram disulfide. In the temperature range studied, the amount of dithiocarbamate found is smaller. The limiting value reached at the various temperatures is progressively smaller, the lower the temperature chosen. Whether by expanding the temperature range, one would eventually reach a minimum and a maximum limiting value has not been investigated.


Author(s):  
Jafar Safarian ◽  
Merete Tangstad

AbstractVacuum induction refining is a process that can be applied to remove phosphorus from molten silicon for the production of solar grade silicon. Pure silicon was doped by phosphorus to make molten silicon containing around 17 ppmw phosphorus. The kinetics of phosphorus removal from this silicon was studied at 0.5 Pa through the application of vacuum induction refining. It was observed that vacuum removal of phosphorus occurs through a first-order reaction. The rate constants of phosphorus evaporation were determined as 2.28


1956 ◽  
Vol 29 (1) ◽  
pp. 15-28 ◽  
Author(s):  
Walter Scheele ◽  
Otto Lorenz ◽  
Wilhelm Dummer

Abstract This paper gives some insight into the kinetics of thiuram vulcanization. The following results were obtained. 1. The decrease of concentration of thiuram disulfides during vulcanization is a first-order reaction in the range of short vulcanization times. At longer reaction times, departures occur. The process then takes place more slowly. 2. The departures from the course of a first-order reaction are displaced with decreasing temperature toward the range of longer vulcanization times. 3. At 87° C, the reaction of tetramethylthiuram disulfide is of the first order over the whole range of vulcanization temperatures chosen, and at this temperature no deviations whatever are observed. 4. The same relationships are found in the kinetic study of dithiocarbamate formation. 5. From the combined results, it is concluded that, besides the two reactions occurring independently of each other during vulcanization, the diffusion of the reaction partners also has some influence on the kinetics. 6. The limiting value of dithiocarbamate formation is correlated with the macromolecular structure of the polyisoprene, and it is shown to be probable that this limit is not determined fundamentally by the chemistry of the vulcanization reaction.


1984 ◽  
Vol 39 (10) ◽  
pp. 963-965 ◽  
Author(s):  
J. Chr. Buhl ◽  
A. Willgallis

Abstract The kinetics of the crystallization of hiibnerite (MnWO4) and ferberite (FeWO4) was studied by hydrothermally reacting the metal (II)-chlorides and sodium tungstate in a special autoclave at two temperatures (300 °C. 400 °C) and a pressure of 1 kbar. The rates of crystallization were determined by continual removal of the reactants from the autoclave. At both temperatures, the decrease of tungstate concentration in solution followed at first order reaction. The rate constants of the reactions were calculated and the Jerofejev-equation was used to describe the kinetics. The rate of hiibnerite formation was larger and increased faster with temperature. This should affect the formation of mixed crystals by initiating a shift of the composition towards higher MnWO4/FeWO4 ratios and might well account for a zonation or inhomogeneity of natural wolframites.


1993 ◽  
Vol 28 (2) ◽  
pp. 135-144 ◽  
Author(s):  
S. Matsui ◽  
R. Ikemoto Yamamoto ◽  
Y. Tsuchiya ◽  
B. Inanc

Using a fluidized bed reactor, experiments on glucose decomposition with and without sulfate reduction were conducted. Glucose in the reactor was mainly decomposed into lactate and ethanol. Lactate was mainly decomposed into propionate and acetate, while ethanol was decomposed into propionate, acetate, and hydrogen. Sulfate reduction was not involved in the decomposition of glucose, lactate, and ethanol, but was related to propionate and acetate decomposition. The stepwise reactions were modeled using either a Monod expression or first order reaction kinetics in respect to the reactions. The coefficients of the kinetic equations were determined experimentally. The modified Monod and first order reaction equations were effective at predicting concentrations of glucose, lactate, ethanol, propionate, acetate, and sulfate along the beight of the reactor. With sulfate reduction, propionate was decomposed into acetate, while without sulfate reduction, accumulation of propionate was observed in the reactor. Sulfate reduction accelerated propionate conversion into acetate by decreasing the hydrogen concentration.


1992 ◽  
Vol 57 (7) ◽  
pp. 1451-1458 ◽  
Author(s):  
Refat M. Hassan

The kinetics of oxidation of arsenic(III) by hexachloroiridate(IV) at lower acid concentrations and at constant ionic strength of 1.0 mol dm-3 have been investigated spectrophotometrically. A first-order reaction in [IrCl62-] and fractional order with respect to arsenic(III) have been observed. A kinetic evidence for the formation of an intermediate complex between the hydrolyzed arsenic(III) species and the oxidant was presented. The results showed that decreasing the [H+] is accompanied by an appreciable acceleration of the rate of oxidation. The activation parameters have been evaluated and a mechanism consistent with the kinetic results was suggested.


1975 ◽  
Vol 28 (4) ◽  
pp. 759 ◽  
Author(s):  
NS Ham ◽  
JR Hall ◽  
GA Swile

A quantitative analysis of the variable-temperature 1H N.M.R. spectra of acetylacetonatotrimethyl-platinum(IV) has been made. In CDCl3 solution the exchange of acetylacetonate ligands is a first-order reaction and proceeds predominantly by dissociation of the dimer into two separated five-coordinate activated complexes. The activation energy is 61.5 � 0.8 kJ mol-1.


1972 ◽  
Vol 18 (3) ◽  
pp. 263-265 ◽  
Author(s):  
John A Daly ◽  
Gerhard Ertingshausen

Abstract A direct method was developed for determining inorganic phosphate in serum, which requires only a single reagent addition. The method quantitates the unreduced phosphomolybdate heteropolyacid at 340 nm and is linear to at least 10 mg of phosphate per 100 ml. Only 10 µl of serum is required. The unique blanking capabilities of centrifugal analyzers permit the "on run" elimination of serum and reagent background absorbances, which are automatically subtracted. Data on precision, correlation, and recovery are presented. Kinetics of the reaction were studied, and theoretical limits of automatic blanking when applied to a first-order reaction are discussed.


1985 ◽  
Vol 40 (3-4) ◽  
pp. 215-218 ◽  
Author(s):  
Fritz Thümmler ◽  
Peter Eilfeld ◽  
Wolfhart Rüdiger ◽  
Doo-Khil Moon ◽  
Pill-Soon Song

The reactivity of the phytochrome chromophore and related tetrapyrroles towards ozone and tetranitromethane was investigated. Both oxidizing reagents cause bleaching of the main absorp­tion band of the pigment. The rate constants for this bleaching were determined under conditions of pseudo first order reaction kinetics. The rate constants for the reaction with ozone are similar for native phytochrome and for freely accessible tetrapyrroles (biliverdin, small chromopeptides from phytochrome) indicating that accessibility is not the limiting factor for the reaction with ozone. Under a variety of conditions, the Pfr chromophore reacts by about 10% faster than the Pr chromophore. This may reflect the true difference in reactivity. The rate constants for the reaction with tetranitromethane are much larger for biliverdin, bilirubin and small chromopeptides from phytochrome than for native phytochrome. The limiting factor for this reaction in native phytochrome therefore is the accessibility of the chromophore by the reagent. Previous conclusions on the difference in exposure of the tetrapyrrole chromophore in Pr and Pfr are confirmed.


Sign in / Sign up

Export Citation Format

Share Document