Methylene Blue Removal from Aqueous Solution by Adsorption on Nitric Acid Modified Water Treatment Sludge

2014 ◽  
Vol 931-932 ◽  
pp. 251-255
Author(s):  
Thanatcha Potiya ◽  
Peerakarn Banjerdkij ◽  
Nuttaporn Pimpha
Keyword(s):  
Aqueous Solution ◽  
Methylene Blue ◽  
Nitric Acid ◽  
Water Treatment ◽  
Low Cost ◽  
Water Treatment Sludge ◽  
Experiment System ◽  
Initial Ph ◽  
Positively Charged ◽  
Maximum Removal

Nitric acid modified water treatment sludge (NS) was used as an adsorbent for methylene blue (MB) removal from aqueous solution in a batch experiment system. Surface area and pore volume were characterized by BET-N2 method. Zeta potential measurements of the NS showed a negatively charge which has the potential to attract positively charged molecules. The effect of initial MB concentration and initial pH solution were investigated. When the initial MB concentration was increased, the percentage of MB removal decreased accordingly while the amount of adsorbed MB on NS at equilibrium time (qe) increased. For the effect of initial pH solution, the adsorption of MB was increased with increase in pH. The maximum removal was observed at pH 11. The result indicates that NS can be used as low cost adsorbent in wastewater treatment for cationic dye removal.

scholarly journals Removal Efficiency and Mechanism of Cr(VI) from Aqueous Solution by Maize Straw Biochars Derived at Different Pyrolysis Temperatures

Water ◽  
2019 ◽  
Vol 11 (4) ◽  
pp. 781 ◽  
Author(s):  
Wang ◽  
Zhang ◽  
Lv
Keyword(s):  
Aqueous Solution ◽  
Removal Efficiency ◽  
Photoelectron Spectroscopy ◽  
Low Cost ◽  
X Ray ◽  
Removal Capacity ◽  
Maize Straw ◽  
Efficient Adsorbent ◽  
Positively Charged ◽  
Maximum Removal

The removal efficiency and mechanism of Cr(VI) removal from aqueous solution on semi-decomposed maize straw biochars pyrolyzed at 300 to 600 °C were investigated. The removal of Cr(VI) by the biochars decreased with pyrolysis temperature increasing from 300 to 600 °C, and the maximum removal capacity of Cr(VI) for maize straw biochar pyrolyzed at 300 °C was 91 mg/g at pH 2.0. The percentage removal of Cr(VI) rapidly decreased with pH increasing from 2.0 to 8.0, with the maximum (>99.9%) at pH 2.0. The variation of Cr(VI) and Cr(III) concentrations in the solution after reaction showed that Cr(VI) concentration decreased while Cr(III) increased and the equilibrium was reached after 48 h, while the redox potential after reaction decreased due to Cr(VI) reduction. X-ray photoelectron spectroscopy (XPS) semi-quantitative analysis showed that Cr(III) accounted for 75.7% of the total Cr bound to maize straw biochar, which indicated reductive adsorption was responsible for Cr(VI) removal by the biochars. Cr(VI) was firstly adsorbed onto the positively charged biochar surface and reduced to Cr(III) by electrons provided by oxygen-containing functional groups (e.g., C=O), and subsequently part of the converted Cr(III) remained on the biochar surface and the rest released into solution. Fourier transform infrared (FTIR) data indicated the participation of C=O, Si–O, –CH2 and –CH3 groups in Cr(VI) removal by the biochars. This study showed that maize straw biochar pyrolyzed at 300 °C for 2 h was one low-cost and efficient adsorbent for Cr(VI) removal from aqueous solution.

Adsorption of methylene blue from aqueous solutions using water treatment sludge modified with sodium alginate as a low cost adsorbent

2016 ◽  
Vol 75 (2) ◽  
pp. 281-295 ◽  
Author(s):  
Hamid Poormand ◽  
Mostafa Leili ◽  
Marzieh Khazaei
Keyword(s):  
Methylene Blue ◽  
Water Treatment ◽  
Aqueous Solutions ◽  
Sodium Alginate ◽  
Contact Time ◽  
Low Cost ◽  
Drinking Water Treatment ◽  
Water Treatment Sludge ◽  
Maximum Sorption Capacity ◽  
Adsorbent Dose

In this research, aluminum-based drinking water treatment sludge is used as a starting material and immobilized by sodium alginate to develop low cost adsorbent for the removal of methylene blue (MB) from aqueous solutions. The studied variables included pH, adsorbent dose, initial MB concentration and contact time. Characteristics of the adsorbent were also studied using scanning electron microscopy and Fourier transform infrared spectroscopy (FTIR). It was revealed from kinetic tests that removal efficiency of MB was 88.5% under the optimum conditions of pH 8, initial MB concentration of 50 mg/L, contact time of 60 min, and adsorbent dose of 0.3 g/L. The oxygen functional groups such as –OH, C–O–C and C=O were found on the surface of developed adsorbent by FTIR. In addition, the adsorption data fitted well the Langmuir adsorption model with the maximum sorption capacity of 909.1 mg/g, and followed the pseudo-second-order kinetics. Findings of this study indicate that the prepared adsorbent is promising for further development of an effective and economical adsorbent material in the near future.

scholarly journals Eggshell Powder as an Adsorbent for Removal of Fluoride from Aqueous Solution: Equilibrium, Kinetic and Thermodynamic Studies

2012 ◽  
Vol 9 (3) ◽  
pp. 1457-1480 ◽  
Author(s):  
R. Bhaumik ◽  
N. K. Mondal ◽  
B. Das ◽  
P. Roy ◽  
K. C. Pal ◽  
...  
Keyword(s):  
Aqueous Solution ◽  
Adsorption Process ◽  
Low Cost ◽  
Fluoride Removal ◽  
Contaminated Water ◽  
Fluoride Adsorption ◽  
Langmuir Isotherm Model ◽  
Pseudo Second Order ◽  
Kinetic And Thermodynamic Studies ◽  
Maximum Removal

A new medium, eggshell powder has been developed for fluoride removal from aqueous solution. Fluoride adsorption was studied in a batch system where adsorption was found to be pH dependent with maximum removal efficiency at 6.0. The experimental data was more satisfactorily fitted with Langmuir isotherm model. The kinetics and the factor controlling adsorption process fully accepted by pseudo-second-order model were also discussed. Eawas found to be 45.98 kJmol-1by using Arrhenius equation, indicating chemisorption nature of fluoride onto eggshell powder. Thermodynamic study showed spontaneous nature and feasibility of the adsorption process with negative enthalpy (∆H0) value also supported the exothermic nature. Batch experiments were performed to study the applicability of the adsorbent by using fluoride contaminated water collected from affected areas. These results indicate that eggshell powder can be used as an effective, low-cost adsorbent to remove fluoride from aqueous solution as well as groundwater.

scholarly journals Bioremediation of organic dyes using combination of plants ash

2019 ◽  
Vol 7 (2) ◽  
pp. 240-246
Author(s):  
Kaur Harpreet ◽  
Kaur Harpreet ◽  
Vandana Kamboj ◽  
Vandana Kamboj
Keyword(s):  
Aqueous Solution ◽  
Methylene Blue ◽  
Methyl Orange ◽  
Crystal Violet ◽  
Congo Red ◽  
Organic Dyes ◽  
Low Cost ◽  
Sem Image ◽  
Orange Peels

Water is the most crucial thing to mankind and so its contamination by various agencies is posing a threat to the natural balance. So, in the present work, the efficiency of various adsorbents derived from plant waste, to remove different dyes from aqueous solution was evaluated. Parameters for study were contact time, concentration and pH. Various combinations of plant ashes were used for the study. It was found that adsorbent prepared from the combination of orange peels, pomegranate and banana peels ashes, exhibited good adsorption capacity for methylene blue, congo red and crystal violet. All these dyes were completely removed from the aqueous solution while methyl orange was not removed. Congo red was removed completely within 40 min of contact with the adsorbent while methyl orange took 3 hrs to be removed to the extent of 48% only. The adsorption coefficient of congo red was found to be 2.33 while value for methylene blue and crystal violet was 1 and 1.66 respectively. The characterization of adsorbent was done by Scanning Electron Microscopy and IR spectroscopy. SEM image revealed the surface of adsorbent to be made of differential pores. From the results it became evident that the low-cost adsorbent could be used as a replacement for costly traditional methods of removing colorants from water.

Low-cost ceramic membrane made from alumina- and silica-rich water treatment sludge and its application to wastewater filtration

2020 ◽  
Vol 40 (15) ◽  
pp. 5942-5950 ◽  
Author(s):  
Rajaa Mouratib ◽  
Brahim Achiou ◽  
Mohammed El Krati ◽  
Saad Alami Younssi ◽  
Soufiane Tahiri
Keyword(s):  
Water Treatment ◽  
Ceramic Membrane ◽  
Low Cost ◽  
Water Treatment Sludge ◽  
Wastewater Filtration

Removal of fluoride in aqueous solution by adsorption on acid activated water treatment sludge

2010 ◽  
Vol 256 (17) ◽  
pp. 5458-5462 ◽  
Author(s):  
Soydoa Vinitnantharat ◽  
Sriwilai Kositchaiyong ◽  
Siriluk Chiarakorn
Keyword(s):  
Aqueous Solution ◽  
Water Treatment ◽  
Water Treatment Sludge

Orthophosphate removal from aqueous solutions using drinking-water treatment sludge

2013 ◽  
Vol 68 (8) ◽  
pp. 1757-1762 ◽  
Author(s):  
Krzysztof Piaskowski
Keyword(s):  
Drinking Water ◽  
Water Treatment ◽  
Low Cost ◽  
Drinking Water Treatment ◽  
Cost Effective ◽  
Underground Water ◽  
Iron Hydroxides ◽  
Water Treatment Sludge ◽  
Main Component ◽  
Static Conditions

Drinking-water treatment sludge (DWTS) is a by-product generated during the production of drinking water where iron hydroxides are the main component of the sludge. The aim of the study presented here was to determine the effectiveness of using ferric sludge from two underground water treatment stations to remove orthophosphates from a model solution. The analyses were performed in static conditions. The sludge was dosed in a dry and suspended form. Using sludge dried at room temperature and preparing the suspension again proved to be much less effective in orthophosphate removal than using a suspension brought directly from the station. An increase in process effectiveness with a decreasing pH was observed for all the analysed sludge. Due to the low cost and high capability, DWTS has the potential to be utilised for cost-effective removal of phosphate from wastewater.

scholarly journals The Equilibrium, Kinetics, and Thermodynamics Studies of the Sorption of Methylene Blue from Aqueous Solution Using Pulverized Raw Macadamia Nut Shells

2020 ◽  
Vol 2020 ◽  
pp. 1-10
Author(s):  
Joshua N. Edokpayi ◽  
Samson O. Alayande ◽  
Ahmed Adetoro ◽  
John O. Odiyo
Keyword(s):  
Aqueous Solution ◽  
Methylene Blue ◽  
Surface Area ◽  
Low Cost ◽  
Aqueous Media ◽  
Group Analysis ◽  
Second Order ◽  
Isotherm Models ◽  
Macadamia Nut ◽  
Pseudo Second Order

In this study, the potential for pulverized raw macadamia nut shell (MNS) for the sequestration of methylene blue from aqueous media was assessed. The sorbent was characterized using scanning electron microscopy for surface morphology, functional group analysis was performed with a Fourier-transform infrared spectrometer (FT-IR), and Brunauer–Emmett–Teller (BET) isotherm was used for surface area elucidation. The effects of contact time, sorbent dosage, particle size, pH, and change in a solution matrix were studied. Equilibrium data were fitted using Temkin, Langmuir, and Freundlich adsorption isotherm models. The sorption kinetics was studied using the Lagergren pseudo-first-order, pseudo-second-order, Elovich, and intraparticle diffusion models. The feasibility of the study was established from the thermodynamic studies. A surface area of 2.763 m2/g was obtained. The equilibrium and kinetics of sorption was best described by the Langmuir and the pseudo-second-order models, respectively. The sorption process was spontaneous (−ΔG0=28.72−31.77 kJ/mol) and endothermic in nature (ΔH0=17.45 kJ/mol). The positive value of ΔS0 (0.15 kJ/molK) implies increased randomness of the sorbate molecules at the surface of the sorbent. This study presents sustainable management of wastewater using MNS as a potential low-cost sorbent for dye decontamination from aqueous solution.

Sign in / Sign up

Export Citation Format

Share Document