Rheology of Chitosan and Genipin Solutions

2008 ◽  
Vol 587-588 ◽  
pp. 27-31 ◽  
Author(s):  
M.J. Moura ◽  
M.M. Figueiredo ◽  
M. Helena Gil

This paper investigates the rheological behaviour of chitosan solutions crosslinked with different concentrations of genipin at body temperature and physiological pH. The effect of the crosslinker concentration on the rheological properties of hydrogels was evaluated. The oscillatory time sweep was used to analyze the dynamics of G’ during in situ gelation experiments enabling the determination of the gelation time. Additionally, the stress and frequency sweeps were employed to measure G’ of cured hydrogels. The solutions of chitosan crosslinked with genipin at physiological conditions were found to form relatively strong elastic gels for all the concentrations, when compared to pure chitosan. A significant reduction on gelation time was achieved. This behaviour shows that these formulations are able to be produced in situ and thus constitute promising matrices for cells and bioactive molecules encapsulation.

2020 ◽  
Author(s):  
S. Minić ◽  
B. Annighöfer ◽  
A. Hélary ◽  
D. Hamdane ◽  
G. Hui Bon Hoa ◽  
...  

ABSTRACTTo probe intermediate states during unfolding and oligomerization of proteins remains a major challenge. High pressure (HP) is a powerful tool for studying these problems, revealing subtle structural changes in proteins not accessible by other means of denaturation. Bovine β-lactoglobulin (BLG), the main whey protein, has a strong propensity to bind various bioactive molecules, such as retinol and resveratrol, two ligands with different affinity and binding sites. By combining in situ HP-small-angle neutron scattering (SANS) and HP-UV/visible absorption spectroscopy, we report the specific effects of these ligands on 3D conformational and local changes in BLG induced by HP. Depending on BLG concentration, two different unfolding mechanisms are observed in situ under pressures up to ~300 MPa, mediated by the formation of disulfide bonds: either a complete protein unfolding, from native dimers to Gaussian chains, or a partial unfolding with oligomerization in tetramers. Retinol, which has a high affinity for BLG hydrophobic cavity, significantly stabilizes BLG both in 3D and local environments, by shifting the onset of protein unfolding by ~100 MPa. Increasing temperature from 30 to 37°C enhances the hydrophobic stabilization effects of retinol. In contrast, resveratrol, which has a low binding affinity for site(s) on the surface of the BLG, does not induce any significant effect on the structural changes of BLG due to pressure. HP treatment back and forth up to ~300 MPa causes irreversible covalent oligomerization of BLG. Ab initio modeling of SANS shows that the oligomers formed from BLG/retinol complex are smaller and more elongated compared to BLG without ligand or in the presence of resveratrol. By combining HP-SANS and HP-UV/vis absorption spectroscopy, our strategy highlights the crucial role of BLG hydrophobic cavity and opens up new possibilities for the structural determination of HP-induced protein folding intermediates and irreversible oligomerization.STATEMENT OF SIGNIFICANCEHigh pressure (HP) is a powerful probe to access the intermediate states of proteins through subtle structural changes not accessible by other means of denaturation. Bovine β-lactoglobulin (BLG), the main whey protein, is able to bind various bioactive molecules, such as retinol and resveratrol, exhibiting different affinity and binding sites. By combining HP-small-angle neutron scattering and HP-UV/visible absorption spectroscopy, we highlight two different mechanisms during the unfolding and oligomerization of BLG depending on protein concentration. Above all, we show that retinol significantly prevents the unfolding and oligomerization of BLG, unlike resveratrol, emphasizing the crucial role of the hydrophobic cavity in BLG stabilization. Our strategy opens up new possibilities for the structural determination of protein intermediates and oligomers using HP.


1998 ◽  
Author(s):  
Dilip Natarajan ◽  
C.S. McCool ◽  
D.W. Green ◽  
G.P. Willhite

1961 ◽  
Vol 38 (4) ◽  
pp. 545-562 ◽  
Author(s):  
L. Kecskés ◽  
F. Mutschler ◽  
I. Glós ◽  
E. Thán ◽  
I. Farkas ◽  
...  

ABSTRACT 1. An indirect paperchromatographic method is described for separating urinary oestrogens; this consists of the following steps: acidic hydrolysis, extraction with ether, dissociation of phenol-fractions with partition between the solvents. Previous purification of phenol fraction with the aid of paperchromatography. The elution of oestrogen containing fractions is followed by acetylation. Oestrogen acetate is isolated by re-chromatography. The chromatogram was developed after hydrolysis of the oestrogens 'in situ' on the paper. The quantity of oestrogens was determined indirectly, by means of an iron-reaction, after the elution of the iron content of the oestrogen spot, which was developed by the Jellinek-reaction. 2. The method described above is satisfactory for determining urinary oestrogen, 17β-oestradiol and oestriol, but could include 16-epioestriol and other oestrogenic metabolites. 3. The sensitivity of the method is 1.3–1.6 μg/24 hours. 4. The quantitative and qualitative determination of urinary oestrogens with the above mentioned method was performed in 50 pregnant and 9 non pregnant women, and also in 2 patients with granulosa cell tumour.


2020 ◽  
Author(s):  
Keishiro Yamashita ◽  
Kazuki Komatsu ◽  
Hiroyuki Kagi

An crystal-growth technique for single crystal x-ray structure analysis of high-pressure forms of hydrogen-bonded crystals is proposed. We used alcohol mixture (methanol: ethanol = 4:1 in volumetric ratio), which is a widely used pressure transmitting medium, inhibiting the nucleation and growth of unwanted crystals. In this paper, two kinds of single crystals which have not been obtained using a conventional experimental technique were obtained using this technique: ice VI at 1.99 GPa and MgCl<sub>2</sub>·7H<sub>2</sub>O at 2.50 GPa at room temperature. Here we first report the crystal structure of MgCl2·7H2O. This technique simultaneously meets the requirement of hydrostaticity for high-pressure experiments and has feasibility for further in-situ measurements.


2019 ◽  
Author(s):  
Patrick Fier ◽  
Suhong Kim ◽  
Kevin M. Maloney

Sulfonamides are pervasive in drugs and agrochemicals, yet are typically considered as terminal functional groups rather than synthetic handles. To enable the general late-stage functionalization of secondary sulfonamides, we have developed a mild and general method to reductively cleave the N-S bonds of sulfonamides to generate sulfinates and amines, components which can further react <i>in-situ</i> to access a variety of other medicinally relevant functional groups. The utility of this platform is highlighted by the selective manipulation of several complex bioactive molecules.


Sign in / Sign up

Export Citation Format

Share Document