Influence of Addition of Ethanol into Non-Edible Biodiesel from Rice Bran Oil on the Properties and Performance - An Experimental Study in Direct Injection VCR Diesel Engine

2019 ◽  
Author(s):  
Prabakaran Balasubramanian ◽  
Padmanaba Sundar Shanmuga Sundaram ◽  
Hemakumar Manoharan
Keyword(s):  
Experimental Study ◽  
Diesel Engine ◽  
Rice Bran ◽  
Rice Bran Oil ◽  
Direct Injection ◽  
And Performance

Biofuel (Cooking Oil) Blends Contribution in DI Diesel Engine – Performance & Emission Study

2014 ◽  
Vol 984-985 ◽  
pp. 839-844
Author(s):  
Natesan Kanthavelkumaran ◽  
P. Seenikannan
Keyword(s):  
Diesel Engine ◽  
Rice Bran ◽  
Diesel Fuel ◽  
Rice Bran Oil ◽  
Direct Injection ◽  
Research Work ◽  
Engine Performance ◽  
Performance And Emission ◽  
Emission Study ◽  
Ci Engines

In present scenario researchers focusing the alternate sources of petroleum products. Based on this, current research work focused the emission study of its characteristics and potential as a substitute for Diesel fuel in CI engines. Current research biodiesel is produced by base catalyzed transesterification of rice bran oil is known as Rice Bran Oil Methyl Ester (Biofuel). In this research various proportions of Biofuel and Diesel are prepared on volume basis. It is used as fuels in a four stroke single cylinder direct injection Diesel engine to study the performance and emission characteristics of these fuels. Varieties of results obtained, that shows around 50% reduction in smoke, 33% reduction in HC and 38% reduction in CO emissions. In result discussion a different blends of the brake power and BTE are reduced nearly 2 to 3% and 3 to 4% respectively around 5% increase in the SFC. Therefore it is accomplished from the this experimental work that the blends of Biofuel and Diesel fuel can successfully be used in Diesel engines as an alternative fuel without any modification in the engine. It is also environment friendly blended fuel by the various emission standards.

Experimental investigation of the combustion characteristics of a biodiesel (rice-bran oil methyl ester)-fuelled direct-injection transportation diesel engine

2007 ◽  
Vol 221 (8) ◽  
pp. 921-932 ◽  
Author(s):  
S Sinha ◽  
A K Agarwal
Keyword(s):  
Diesel Engine ◽  
Methyl Ester ◽  
Vegetable Oils ◽  
Rice Bran ◽  
Rice Bran Oil ◽  
Direct Injection ◽  
Pressure Rise ◽  
Cylinder Pressure ◽  
Biodiesel Blends ◽  
Crank Angle

Increased environmental awareness and depletion of fossil petroleum resources are driving industry to develop alternative fuels that are environmentally more acceptable. Transesterified vegetable oil derivatives called ‘biodiesel’ appear to be the most convenient way of utilizing bio-origin vegetable oils as substitute fuels in diesel engines. The methyl esters of vegetable oils do not require significant modification of existing engine hardware. Previous research has shown that biodiesel has comparable performance and lower brake specific fuel consumption than diesel with significant reduction in emissions of CO, hydrocarbons (HC), and smoke but slightly increased NO x emissions. In the present experimental research work, methyl ester of rice-bran oil is derived through transesterification of rice-bran oil using methanol in the presence of sodium hydroxide (NaOH) catalyst. Experimental investigations have been carried out to examine the combustion characteristics in a direct injection transportation diesel engine running with diesel, biodiesel (rice-bran oil methyl ester), and its blends with diesel. Engine tests were performed at different engine loads ranging from no load to rated (100 per cent) load at two different engine speeds (1400 and 1800 r/min). A careful analysis of the cylinder pressure rise, heat release, and other combustion parameters such as the cylinder peak combustion pressure, rate of pressure rise, crank angle at which peak pressure occurs, rate of pressure rise, and mass burning rates was carried out. All test fuels exhibited similar combustion stages as diesel; however, biodiesel blends showed an earlier start of combustion and lower heat release during premixed combustion phase at all engine load-speed combinations. The maximum cylinder pressure reduces as the fraction of biodiesel increases in the blend and, at higher engine loads, the crank angle position of the peak cylinder pressure for biodiesel blends shifted away from the top dead centre in comparison with baseline diesel data. The maximum rate of pressure rise was found to be higher for diesel at higher engine loads; however, combustion duration was higher for biodiesel blends.

Performance and Emission Characteristics of Low Heat Rejection Diesel Engine Fuelled with Rice Bran Oil Biodiesel

2013 ◽  
Vol 768 ◽  
pp. 245-249 ◽  
Author(s):  
G. Arunkumar ◽  
A. Santhoshkumar ◽  
M. Vivek ◽  
L. Anantha Raman ◽  
G. Sankaranarayanan ◽  
...  
Keyword(s):  
Diesel Engine ◽  
Rice Bran ◽  
Rice Bran Oil ◽  
Direct Injection ◽  
Inlet Valve ◽  
Heat Rejection ◽  
Performance And Emission ◽  
Piston Cylinder ◽  
Spray Method ◽  
Test Engine

In this study, the performance and exhaust emissions of a biodiesel fuelled low heat rejection (LHR) direct injection Diesel engine have been investigated experimentally and compared with the results of standard diesel engine without any coatings. Piston, cylinder head, exhaust and inlet valve of test engine were coated with 0.5 mm thickness of zirconia through plasma spray method. Biodiesel used in the testing was prepared from rice bran oil through transesterification process.

Comparative Performance, Emission, and Combustion Characteristics of Rice-Bran Oil and Its Biodiesel in a Transportation Diesel Engine

2010 ◽  
Vol 132 (6) ◽  
Author(s):  
Avinash Kumar Agarwal ◽  
Atul Dhar
Keyword(s):  
Diesel Engine ◽  
Heat Release ◽  
Rice Bran ◽  
Heat Release Rate ◽  
Release Rate ◽  
Rice Bran Oil ◽  
Direct Injection ◽  
Pressure Rise ◽  
Combustion Characteristics ◽  
Comparative Performance

The methyl esters of vegetable oils known as biodiesel are becoming increasingly popular because of their low environmental impact and potential as a green alternative fuel for diesel engines. Methyl ester of rice-bran oil (RBOME) is prepared through the process of transesterification. In the present investigation, experiments have been carried out to examine the performance, emission, and combustion characteristics of a direct-injection transportation diesel engine running with diesel, 20% blend of rice-bran oil (RBO), and 20% blend of RBOME with mineral diesel. A four-stroke, four-cylinder, direct-injection transportation diesel engine (MDI 3000) was instrumented for the measurement of the engine performance, emissions, in-cylinder pressure-crank angle history, rate of pressure rise, and other important combustion parameters such as instantaneous heat release rate, cumulative heat release rate, mass fraction burned, etc. A careful analysis of the performance, emissions, combustion, and heat release parameters has been carried out. HC, CO, and smoke emissions for RBO and RBOME blends were lower than mineral diesel while NOx emissions were almost similar and brake specific fuel consumption (BSFC) was slightly higher than mineral diesel. Combustion characteristics were quite similar for the three fuels.

Combustion Characteristics of Rice Bran Oil Derived Biodiesel in a Transportation Diesel Engine

2006 ◽  
Author(s):  
Shailendra Sinha ◽  
Avinash Kumar Agarwal
Keyword(s):  
Diesel Engine ◽  
Heat Release ◽  
Rice Bran ◽  
Heat Release Rate ◽  
Release Rate ◽  
Rice Bran Oil ◽  
Direct Injection ◽  
Pressure Rise ◽  
Combustion Characteristics ◽  
Experimental Investigations

The methyl esters of vegetable oils, known as biodiesel are becoming increasingly popular because of their low environmental impact and potential as a green alternative fuel for diesel engines. They do not require significant modification in existing engine hardware. Methyl ester of rice bran oil (ROME) is prepared through the process of transesterification. Previous research has shown that ROME has comparable performance, lower bsfc in comparison to diesel. There was reduction in the emissions of CO, HC, and smoke but NOx emissions increased. In the present research, experimental investigations have been carried out to examine the combustion characteristics of a direct injection transportation diesel engine running with diesel, and 20% blend of ROME with diesel. A four-stroke, four-cylinder, direct-injection transportation diesel engine (MDI 3000) was fully instrumented for the measurement of combustion pressure, rate of pressure rise and other combustion parameters such as instantaneous heat release rate, cumulative heat release rate, mass fraction burned etc. Tests were performed at different loads ranging from no load to 100%, at constant engine speed. No engine hardware modification was carried out for the present study. A careful analysis of combustion and heat release parameters has been carried out, which gives precise information about the in-cylinder combustion of rice bran oil based biodiesel vis-a`-vis mineral diesel.

scholarly journals Combustion and emission characteristics of diesel engine fuelled with rice bran oil methyl ester and its diesel blends

2008 ◽  
Vol 12 (1) ◽  
pp. 139-150 ◽  
Author(s):  
Rao Gattamaneni ◽  
Saravanan Subramani ◽  
Sampath Santhanam ◽  
Rajagopal Kuderu
Keyword(s):  
Diesel Engine ◽  
Methyl Ester ◽  
Heat Release ◽  
Vegetable Oils ◽  
Rice Bran ◽  
Ignition Delay ◽  
Rice Bran Oil ◽  
Direct Injection ◽  
Engine Fuel ◽  
Maximum Heat

There has been a worldwide interest in searching for alternatives to petroleum-derived fuels due to their depletion as well as due to the concern for the environment. Vegetable oils have capability to solve this problem because they are renewable and lead to reduction in environmental pollution. The direct use of vegetable oils as a diesel engine fuel is possible but not preferable because of their extremely higher viscosity, strong tendency to polymerize and bad cold start properties. On the other hand, Biodiesels, which are derived from vegetable oils, have been recently recognized as a potential alternative to diesel oil. This study deals with the analysis of rice bran oil methyl ester (RBME) as a diesel fuel. RBME is derived through the transesterification process, in which the rice bran oil reacts with methanol in the presence of KOH. The properties of RBME thus obtained are comparable with ASTM biodiesel standards. Tests are conducted on a 4.4 kW, single-cylinder, naturally aspirated, direct-injection air-cooled stationary diesel engine to evaluate the feasibility of RBME and its diesel blends as alternate fuels. The ignition delay and peak heat release for RBME and its diesel blends are found to be lower than that of diesel and the ignition delay decreases with increase in RBME in the blend. Maximum heat release is found to occur earlier for RBME and its diesel blends than diesel. As the amount of RBME in the blend increases the HC, CO, and soot concentrations in the exhaust decreased when compared to mineral diesel. The NOx emissions of the RBME and its diesel blends are noted to be slightly higher than that of diesel.

Effect of Combustion Chamber Design on the Performance and Emission Characteristics of a Direct Injection (DI) Diesel Engine Fuelled With Refined Rice Bran Oil Blends

2004 ◽  
Author(s):  
A. Samuel Raja ◽  
G. Lakshmi Narayana Rao ◽  
N. Nallusamy ◽  
M. Selva Ganesh Kumar
Keyword(s):  
Diesel Engine ◽  
Combustion Chamber ◽  
Rice Bran ◽  
Rice Bran Oil ◽  
Direct Injection ◽  
Spherical Shape ◽  
Experimental Investigations ◽  
Emission Characteristics ◽  
Performance And Emission ◽  
Piston Bowl

The present work deals with the experimental investigations on the effect of refined rice bran oil and its blends with diesel on performance and emission characteristics of diesel engine with different combustion chamber geometry. The engine was tested with various neat vegetable oils and it was found that with refined rice bran oil the performance and emission characteristics were comparable with that of neat diesel. The K- factor of the combustion chamber geometry (ratio of the piston bowl volume to the clearance volume) was maintained at 0.74. The D/d ratio (ratio of piston crown diameter to piston bowl diameter) was altered to achieve re-entrant and torroidal shapes from spherical shape. Tests were carried out for each blend, with particular geometry of combustion chamber. Results with different combustion chamber geometry and different blends have been compared.

scholarly journals Effect of Alcoholic and Nanoparticle Additives on the Performance, Combustion and Emission Analysis of Biodiesel blended Common Rail Direct Injection Diesel Engine

2021 ◽  
Author(s):  
Prabhu Kishore Nutakki ◽  
Santhosh Kumar Gugulothu ◽  
Jatoth Ramachander ◽  
Mulugundam Sivasurya
Keyword(s):  
Experimental Study ◽  
Iron Oxide ◽  
Diesel Engine ◽  
Direct Injection ◽  
Common Rail ◽  
Pollutant Emissions ◽  
Direct Injection Diesel Engine ◽  
And Performance ◽  
Ternary Fuel ◽  
Nanoparticle Additives

Abstract This paper deals with the study on the influence of the effects of iron oxide nanoparticle additives when added to ternary fuel (diesel + Mahua methyl ester + Pentanol) on the emission, combustion and performance characteristics of a four stroke, single cylinder, common rail direct injection diesel engine working at a constant speed and varying operating scenarios. Doping is done in various proportions to the nanoparticle additives with the help of a homogenizer and ultrasonicator where the cationic surfactant used is CTAB (cetyl trimethyl ammonium bromide). Iron oxide nanoparticles were used as additives in fuel in the dosages of 40 ppm, 80 ppm & 120 ppm respectively and TF (Ternary fuel) is obtained by mixing 10% pentanol, 20% Mahua and 70% diesel together is used for the experimental study. The experimental study revealed that while using the nanoparticle additives blended ternary fuel (i.e., TF80) the number of harmful pollutants like smoke (5.38%), HC (6.39%), carbon monoxide (10.24%) and NOx etc. has reduced to a considerable extent and there was a commendable improvement in the BTE by 8.8%. So, we can summarize that when ternary fuel and nano additives are blended together the combustion and performance of the engine was improved considerably and pollutant emissions were decreased.

Sign in / Sign up

Export Citation Format

Share Document