A Critical Review of Seating Discomfort and Anthropometric Consideration for Tractors

Author(s):  
M. Boopathi ◽  
S. Balachandran

The seats that are available in the tractors are not as sophisticated as in the cars and most of the tractor operators feels discomfort while operating the tractor. This review not only makes the tractor seat sophisticated one but also includes all other design considerations. It is necessary to design a seat by considering various factors like dimensions, cushioning, anthropometry etc. Anthropometric consideration is not a mere assumption here. In the view of anthropometry, a survey form was created to analyse various pain levels of a tractor operators. The survey was taken from different age and different experience tractor operators to obtain more relevant data for the analysis. At the end of analysis, the dimensions were varied according to the analysis and also consider the ISO and BIS recommendations. To give more comfort to the tractor operators some additional features like hand rest, air cushioning for the seat were added and these also reduce the tractor operator’s pain.

Author(s):  
S.D. Smith ◽  
R.J. Spontak ◽  
D.H. Melik ◽  
S.M. Buehler ◽  
K.M. Kerr ◽  
...  

When blended together, homopolymers A and B will normally macrophase-separate into relatively large (≫1 μm) A-rich and B-rich phases, between which exists poor interfacial adhesion, due to a low entropy of mixing. The size scale of phase separation in such a blend can be reduced, and the extent of interfacial A-B contact and entanglement enhanced, via addition of an emulsifying agent such as an AB diblock copolymer. Diblock copolymers consist of a long sequence of A monomers covalently bonded to a long sequence of B monomers. These materials are surface-active and decrease interfacial tension between immiscible phases much in the same way as do small-molecule surfactants. Previous studies have clearly demonstrated the utility of block copolymers in compatibilizing homopolymer blends and enhancing blend properties such as fracture toughness. It is now recognized that optimization of emulsified ternary blends relies upon design considerations such as sufficient block penetration into a macrophase (to avoid block slip) and prevention of a copolymer multilayer at the A-B interface (to avoid intralayer failure).


Author(s):  
Y. Harada ◽  
K. Tsuno ◽  
Y. Arai

Magnetic objective lenses, from the point of view of pole piece geometry, can he roughly classified into two types, viz., symmetrical and asymmetrical. In the case of the former, the optical properties have been calculated by several authors1-3) and the results would appear to suggest that, in order to reduce the spherical and chromatic aberration coefficients, Cs and Cc, it is necessary to decrease the half-width value of the axial field distribution and to increase the peak flux density. The expressions for either minimum Cs or minimum Cc were presented in the form of ‘universal’ curves by Mulvey and Wallington4).


2021 ◽  
Author(s):  
Manuela Oliverio ◽  
Monica Nardi ◽  
Maria Luisa Di Gioia ◽  
Paola Costanzo ◽  
Sonia Bonacci ◽  
...  

Semi-synthesis is an effective strategy to obtain both natural and synthetic analogues of the olive secoiridoids, starting from easy accessible natural compounds.


Sign in / Sign up

Export Citation Format

Share Document