scholarly journals Fuzzy Logic Based Robust DVC Design of PWM Rectifier Connected to a PMSG WECS under wind/load Disturbance Conditions

2019 ◽  
Vol 4 (1) ◽  
pp. 37
Author(s):  
Youcef SAIDI ◽  
Abdelkader Mezouar ◽  
Yahia Miloud ◽  
Mohammed Amine Benmahdjoub ◽  
Maamar Yahiaoui
Keyword(s):  
Fuzzy Logic ◽  
Fuzzy Logic Controller ◽  
Pulse Width Modulation ◽  
Wind Load ◽  
Voltage Source ◽  
Pwm Rectifier ◽  
Wind Energy Conversion ◽  
Logic Control ◽  
Wind Turbine System ◽  
Three Phase

Permanent Magnet Generator has been widely used in Variable-Speed Wind Energy Conversion System (VSWECS). Fuzzy Logic Control (FLC) of the generator side converter has the ability to have good regulation of the DC-link voltage to meet the requirements necessary to achieve optimal system operation, regardless of the disturbances caused by the characteristics of the drive train or some changes into the DC-load. The main focus of this paper is to present a model for a three-phase voltage source space vector pulse width modulation (SVPWM) rectifier which is connected to a PMSG in a wind turbine system, where a direct voltage control (DVC) using FLC based on voltage orientation strategy is used to control the mentioned rectifier. The control algorithm employs a fuzzy logic controller to effectively achieve a smooth control of DC-link voltage under wind/load perturbation conditions. Some simulation results, using Matlab/Simulink, are presented to show the effectiveness of the SVPWM rectifier Connected to a PMSG WECS with the proposed control strategy.

scholarly journals Feedback Loop Control Strategies of the Multi Dc Bus Link Voltages Using Adaptive Fuzzy Logic Control

2013 ◽  
Vol 64 (3) ◽  
pp. 143-151
Author(s):  
Farid Bouchafaa ◽  
Mohamed Seghir Boucherit ◽  
El Madjid Berkouk
Keyword(s):  
Fuzzy Logic ◽  
Fuzzy Logic Controller ◽  
Control Strategies ◽  
Harmonic Distortion ◽  
Power Converter ◽  
Voltage Source ◽  
Switching Frequency ◽  
Pwm Rectifier ◽  
Loop Control ◽  
Multilevel Inverters

Voltage source multilevel inverters have become very attractive for power industries in power electronics applications during last years. The main purposes that have led to the development of the studies about multilevel inverters are the generation of output voltage signals with low harmonic distortion; the reduction of switching frequency. A serious constraint in a multilevel inverter is the capacitor voltage-balancing problem. The unbalance of different DC voltage sources of five-level neutral point clamping (NPC) voltage source inverter (VSI) constitutes the major limitation for the use of this new power converter. In order to stabilize these DC voltages, we propose in this paper to study the cascade constituted by three phases five-level PWM rectifier, a clamping bridge and five-level NPC (VSI). In the first part, we present a topology of five-level NPC VSI, and then they propose a model of this converter and an optimal PWM strategy to control it using four bipolar carriers. Then in the second part, we study a five-level PWM rectifier, which is controlled by a multiband hysteresis strategy. In the last part of this paper, the authors study shows particularly the problem of the stability of the multi DC voltages of the inverter and its consequence on the performances of the induction motors (IM). Then, we propose a solution to the problem by employed closed loop regulation using PI regulator type fuzzy logic controller (FLC). The results obtained with this solution confirm the good performances of the proposed solution, and promise to use the inverter in high voltage and great power applications as electrical traction.

scholarly journals Reconfigurable Control of PWM AC-DC-DC Converter without Redundancy Leg Supplying an AC Motor Drive

2021 ◽  
Vol 65 (1) ◽  
pp. 74-81
Author(s):  
Khaled Sahraoui ◽  
Bachir Gaoui
Keyword(s):  
Pulse Width Modulation ◽  
Fault Tolerant ◽  
Open Circuit ◽  
Voltage Source ◽  
Fast Method ◽  
Pwm Rectifier ◽  
Reconfigurable Control ◽  
Ac Motor ◽  
Three Phase ◽  
Zero Sequence

The purpose of this paper is the study by simulation of a fault tolerant control with Pulse Width Modulation (PWM) AC-DC-AC converter supplying a three-phase rotor field oriented induction motor. The back to back converter, is supplied with three-phase network and composed of a PWM rectifier and a voltage source inverter. Fault tolerant topology of AC-DC-AC converter that without redundancy have been studied and associated with affective and fast method of fault detection and compensation to guarantee the continuity of service, in the presence of a possible open circuit failure on the level of one of their legs. Although of the presence of open circuit on the level of one of the converter legs the control based on the Zero Sequence Signal (ZSS) assure the service continuity, the simulation results obtained prove that it is possible to maintain the good performance of the drive without redundancy leg (6/5 topology).

Research on the Method of Variable-Frequency Hysteresis SVPWM Current Control for Three-Phase PWM Rectifier

2014 ◽  
Vol 678 ◽  
pp. 392-398 ◽  
Author(s):  
Xu Chen ◽  
Shou Qi Wei
Keyword(s):  
Pulse Width ◽  
Pulse Width Modulation ◽  
Current Control ◽  
Voltage Source ◽  
Variable Frequency ◽  
Pwm Rectifier ◽  
Hysteresis Current Control ◽  
Voltage Vector ◽  
Three Phase ◽  
Space Voltage Vector

Aiming at the shortcomings of the method of conventional hysteresis current control for three-phase PWM rectifier, this paper proposes a new method, which combines Variable-frequency hysteresis current control with Space Vector Pulse-width Modulation (SVPWM) strategy. With this method, the error current can be limited in a given hysteresis loop by switching the space voltage vector of the voltage source PWM rectifier (VSR) in real time. And it can get a faster response for the current, while the frequency of the switches can be reduced. So, this method can obtain a high quality for the current control of PWM rectifier.

scholarly journals Evaluation of the High Performance Indirect Field Oriented Controlled Dual Induction Motor Drive Fed by a Single Inverter using Type-2 Fuzzy Logic Control

2020 ◽  
Vol 10 (5) ◽  
pp. 6301-6308
Author(s):  
A. Bounab ◽  
A. Chaiba ◽  
S. Belkacem
Keyword(s):  
Fuzzy Logic ◽  
Induction Motor ◽  
Fuzzy Logic Control ◽  
High Performance ◽  
Fuzzy Logic Controller ◽  
Dynamic Performance ◽  
Voltage Source ◽  
Switching Frequency ◽  
Logic Control

In this paper, a high-performance indirect field-oriented controlled dual Induction Motor (IM) drive fed by a single inverter using type-2 fuzzy logic control will be presented. At first, the mathematical model of the IM is implemented in the d-q reference frame. Then, the speed control of the Dual Induction Motor (DIM) operating in parallel configuration with Indirect Field Oriented Control (IFOC) using PI and type-2 Fuzzy Logic Controller (T2-FLC) will be presented. For the control of this system, a DC supply and a Space Vector Pulse Width Modulation (SVPWM) voltage source inverter are introduced with constant switching frequency. Also, the performance of T2-FLC, which is based on the IFOC, is tested and compared to those achieved using the PI controller. The simulation results demonstrate that the T2-FLC is more robust, efficient, and has superior dynamic performance for traction system applications.

Comparative Study of Three Phase Grid Connected Photovoltaic Inverter Using PI and Fuzzy Logic Controller with Switching Losses Calculation

2016 ◽  
Vol 7 (2) ◽  
pp. 543 ◽  
Author(s):  
M. Venkatesan ◽  
R. Rajeshwari ◽  
N. Deverajan ◽  
M. Kaliyamoorthy
Keyword(s):  
Fuzzy Logic ◽  
Comparative Study ◽  
Fuzzy Logic Controller ◽  
Pulse Width Modulation ◽  
Harmonic Distortion ◽  
Maximum Power ◽  
Pv System ◽  
Pv Inverter ◽  
Switching Losses ◽  
Three Phase

A comparative study of three phase grid connected photovoltaic (PV) inverter using Proprotional Controller (PI) and Fuzzy Logic Controller (FLC) is presented in this paper. Proposed three phase inverter with single DC source employing three phase transformer for grid connected PV system controlled by using Space Vector Pulse Width Modulation (SVPWM) technique.  PI and FLC are used as current controller for regulating the current. Perturb and observe Maximum Power Point Technique (MPPT) is used for tracking of maximum power from the PV panel. Finally Total Harmonic Distortion (THD) comparison made between two controllers for validation of results. Furthermore swithing losses of inverter are also presented. The simulation results are obtained using MATLAB simulink.

Sign in / Sign up

Export Citation Format

Share Document