scholarly journals Robustness Comparison of Synthetic Inertia Strategies for Doubly Fed Induction Generators under Different Operating Conditions

2020 ◽  
Author(s):  
Paulo Andrade Souza ◽  
Renan R. dos Santos ◽  
Manoelito C. N. Filho ◽  
Daniel Barbosa ◽  
Luciano Sales Barros
Keyword(s):  
Wind Energy ◽  
Large Scale ◽  
Control Strategies ◽  
Renewable Energy Sources ◽  
Operating Conditions ◽  
Wind Condition ◽  
Primary Control ◽  
Parameter Uncertainties ◽  
Doubly Fed ◽  
Frequency Behavior

Due to the increasing penetration of Renewable Energy Sources (RES) such as wind energy in electrical grids, Wind Energy Conversion Systems (WECS) participation in primary control is becoming required including the Doubly Fed Induction Generator (DFIG)-based WECS. High integration of large scale DFIG-based WECS brings new challenges to their primary control support, and more strongly due to the wind condition and grid parameter uncertainties. One of the most used types of control strategy for DFIG-based WECS primary support is the synthetic inertia, however, robustness of these techniques have not been tested. In this work three synthetic inertia control strategies will be tested under different operating conditions of wind speed, frequency and voltage sag. For testing the DFIG-based WECS, it was modeled on ATP including its control systems and the results quantified the controllers robustness on the tested controllers with respect to transient frequency behavior.

scholarly journals Fault Analysis using SFCL in the Convertor System at the Load Line

2021 ◽  
pp. 60-67
Author(s):  
Suman Baghel ◽  
Sanjeev Jarring
Keyword(s):  
Large Scale ◽  
Low Voltage ◽  
Control Strategies ◽  
Short Circuit ◽  
Renewable Energy Sources ◽  
Short Circuit Current ◽  
Fault Analysis ◽  
Residual Current ◽  
Operating Conditions ◽  
The Impact

Among many renewable energy sources, solar energy is considered one of the most promising resources for large-scale electricity generation. Here propose resistive SFCL if a fault occurs in a simple low voltage (LV) network. To assess the impact of SFCL in the power system under study, the space-time approach is used to evaluate the short-circuit current in force and spurious control strategies are suggested to achieve the goal. The results complement the feasibility of the proposed A-ACO-based rationalization control for transmission activity according to the limiting circuit and fault current analyzer. The second model of the bastard chassis concludes that the chassis with residual current limiting circuit and analyzer reduces the expansion of the residual current and prevents the voltage from dropping to zero, that no artificial and temporal innovation is used as before. Intelligence-based computer procedures further shorten the working time, which also makes the frame more efficient, as the voltage is restored to its typical value in a short time if the test frame is played for 1 second in a MATLAB climate / SIMULINK. The time taken by the ACO algorithm to restore normal operating conditions in the line was 0.197 seconds, 0.206 seconds and 0.27 seconds for LLLG, LLG and LG errors, respectively.

Control Strategy Used in DFIG and PMSG Based Wind Turbines an Overview

2017 ◽  
Vol 8 (3) ◽  
pp. 1160
Author(s):  
V. Meenakshi ◽  
S. Paramasivam
Keyword(s):  
Renewable Energy ◽  
Wind Energy ◽  
Control Strategies ◽  
Renewable Energy Sources ◽  
Synchronous Generator ◽  
Renewable Energies ◽  
Renewable Energy Resources ◽  
Tidal Waves ◽  
Power Electronics Converter ◽  
Doubly Fed

<p class="Abstract">Nowadays, the fossil combustibles are replaced by renewable energies sources .These renewable energies are nontoxic, dirt free, and protected and reasonably cheep for the user.   Renewable energy resources like bio-gas, geothermal, solar, tidal waves and wind have been found as the best alternatives energy source. Among those renewable energy sources, wind energy stands foremost for generating electricity. In order to have a constant utilization of wind energy and to extract maximum power from wind energy. In this paper, various control strategies prevalent to both the Doubly Fed Induction Generator (DFIG)and Permanent Magnet Synchronous Generator(PMSG) have been analyzed . In addition, control topology applicable to power electronics converter/inverter used in wind electric generators  are discussed.</p>

The Control Strategy Study of Doubly-Fed Wind Turbine Participated in Frequency Regulation

2012 ◽  
Vol 512-515 ◽  
pp. 788-793
Author(s):  
Xiao Hua Zhou ◽  
Ming Qiang Wang ◽  
Wei Wei Zou
Keyword(s):  
Wind Turbine ◽  
Control Strategy ◽  
Large Scale ◽  
Control Strategies ◽  
Frequency Control ◽  
Frequency Regulation ◽  
Strategy Study ◽  
Fuzzy Control Strategy ◽  
Doubly Fed ◽  
System Frequency

Traditional decoupling control strategy of doubly-fed induction generator (DFIG) wind turbine makes little contribution to system inertia and do not participate in the system frequency control, the synchronization of large-scale wind power requires wind turbine have the ability to participate in the regulation of power system frequency. This paper adds a frequency control segment to traditional DFIG wind turbine and considers the doubly-fed wind turbine operating on the state of the super-synchronous speed, by analysis the effect of inertia and proportional control strategies, a fuzzy control strategy which combines the advantages of the former two control strategies is proposed, simulation results show that this control strategy can more effectively improve the system frequency response.

scholarly journals Indirect Vector-Controlled Brushless Doubly-Fed Twin-Stator Induction Generator for Wind Energy Conversion Application

Energies ◽  
2020 ◽  
Vol 13 (16) ◽  
pp. 4174
Author(s):  
Mona I. Abdelkader ◽  
Ahmed K. Abdelsalam ◽  
Ahmed A. Hossameldin
Keyword(s):  
Wind Energy ◽  
Energy Conversion ◽  
Reactive Power ◽  
Operating Conditions ◽  
Velocity Variation ◽  
Induction Generator ◽  
Synchronous Generators ◽  
Wind Energy Conversion ◽  
Wide Range ◽  
Doubly Fed

Wind energy conversion systems (WECSs) seem certain to play a major part in the world’s energy future due to their known high power capacity. The maximum power tracking is unavoidable due to the wind velocity variation and the non-linear relation with the turbine mechanical power. Commercial wind turbines are commonly coupled to either doubly-fed induction generators (DFIGs), wound rotor synchronous generators (WRSG) or permanent magnet synchronous generators (PMSGs). The DFIG-based WECS has several advantages over others. One of which is the power converter in such systems only deals with rotor power, hence the converter rating can run at reduced power rating. However, DFIG has the famous disadvantage of the presence of slip rings which leads to increased maintenance costs and outage times. Hence, brushless doublyfed induction machines (BDFIMs) can be considered as a viable alternative at the penalty of complicated controller requirement and limited decoupling control capability due to the machine’s non-linearity. In this paper, an enhanced performance indirect vector controller is proposed for WECS based on brushless doubly-fed twin-stator induction generator (BDFTSIG). The presented controller offers (i) simplified implementation, (ii) decoupled active-reactive power control, and (iii) a wide range of operation. The proposed controller performance is investigated under various loading conditions showing enhanced transient and minimal steady-state oscillations in addition to complete active/reactive power decoupling. The rigorous simulation and experimental results verify the claimed controller effectiveness under all possible operating conditions for sub- and super-synchronous speed range.

A Study on Wind - Energy Storage Hybrid System

2011 ◽  
Vol 187 ◽  
pp. 97-102 ◽  
Author(s):  
Liang Liang ◽  
Jian Lin Li ◽  
Dong Hui
Keyword(s):  
Renewable Energy ◽  
Energy Storage ◽  
Power System ◽  
Wind Energy ◽  
Wind Power ◽  
Large Scale ◽  
Renewable Energy Sources ◽  
Storage System ◽  
Energy Storage System ◽  
Wind Power System

Recently, more and more people realize the importance of environment protection. Electric power generation systems using renewable energy sources have an advantage of no greenhouse effect gas emission. Among all the choices, wind power can offer an economic and environmentally friendly alternative to conventional methods of power supply. As a result, wind energy generation, utilization and its grid penetration in electrical grid is increasing world wide. The wind generated power is always fluctuating due to its time varying nature and causing stability problem. Inserting energy storage system into large scale wind farm to eliminate the fluctuation becomes a solution for developing large scale renewable energy system connected with grid. The topology diagram and control strategy are presented in this paper. According to the simulation result, it could be indicated that embedding energy storage system into wind power system could improve the access friendly and extend system functions. This paper shows that integrating energy storage system into wind power system will build a more reliable and flexible system for power grid.

scholarly journals An Ultra-Durable Windmill-Like Hybrid Nanogenerator for Steady and Efficient Harvesting of Low-Speed Wind Energy

2020 ◽  
Vol 12 (1) ◽  
Author(s):  
Ying Zhang ◽  
Qixuan Zeng ◽  
Yan Wu ◽  
Jun Wu ◽  
Songlei Yuan ◽  
...  
Keyword(s):  
Energy Harvesting ◽  
Wind Energy ◽  
Large Scale ◽  
Renewable Energy Sources ◽  
Low Speed ◽  
Hybrid Nanogenerator ◽  
Device Structures ◽  
Improved Performance ◽  
Triboelectric Nanogenerators ◽  
Output Characteristics

AbstractWind energy is one of the most promising and renewable energy sources; however, owing to the limitations of device structures, collecting low-speed wind energy by triboelectric nanogenerators (TENGs) is still a huge challenge. To solve this problem, an ultra-durable and highly efficient windmill-like hybrid nanogenerator (W-HNG) is developed. Herein, the W-HNG composes coupled TENG and electromagnetic generator (EMG) and adopts a rotational contact-separation mode. This unique design efficiently avoids the wear of friction materials and ensures a prolonged service life. Moreover, the generator group is separated from the wind-driven part, which successfully prevents rotation resistance induced by the friction between rotor and stator in the conventional structures, and realizes low-speed wind energy harvesting. Additionally, the output characteristics of TENG can be complementary to the different performance advantages of EMG to achieve a satisfactory power production. The device is successfully driven when the wind speed is 1.8 m s−1, and the output power of TENG and EMG can achieve 0.95 and 3.7 mW, respectively. After power management, the W-HNG has been successfully applied as a power source for electronic devices. This work provides a simple, reliable, and durable device for improved performance toward large-scale low-speed breeze energy harvesting.

scholarly journals Influences of Wind Energy Integration into the Distribution Network

2013 ◽  
Vol 2013 ◽  
pp. 1-21 ◽  
Author(s):  
G. M. Shafiullah ◽  
Amanullah M. T. Oo ◽  
A. B. M. Shawkat Ali ◽  
Alex Stojcevski
Keyword(s):  
Wind Energy ◽  
High Voltage ◽  
Large Scale ◽  
Low Voltage ◽  
Renewable Energy Sources ◽  
Distribution Network ◽  
Flow Characteristics ◽  
Simulation Models ◽  
Energy Sources ◽  
Energy Integration

Wind energy is one of the most promising renewable energy sources due to its availability and climate-friendly attributes. Large-scale integration of wind energy sources creates potential technical challenges due to the intermittent nature that needs to be investigated and mitigated as part of developing a sustainable power system for the future. Therefore, this study developed simulation models to investigate the potential challenges, in particular voltage fluctuations, zone substation, and distribution transformer loading, power flow characteristics, and harmonic emissions with the integration of wind energy into both the high voltage (HV) and low voltage (LV) distribution network (DN). From model analysis, it has been clearly indicated that influences of these problems increase with the increased integration of wind energy into both the high voltage and low voltage distribution network; however, the level of adverse impacts is higher in the LV DN compared to the HV DN.

Coordinated Control of Large Scale Offshore Wind Farms Integrating into VSC-HVDC System

2013 ◽  
Vol 724-725 ◽  
pp. 546-554
Author(s):  
Neng Qian Jiang ◽  
Yi Feng Xie
Keyword(s):  
Large Scale ◽  
Control Strategies ◽  
Current Model ◽  
Wind Farms ◽  
Offshore Wind ◽  
Doubly Fed Induction Generator ◽  
Constant Frequency ◽  
Offshore Wind Farms ◽  
Hvdc System ◽  
Doubly Fed

VSC-HVDC has become prior transmission way in delivering off-shore wind power. This paper studies offshore wind system based on DFIG (Doubly Fed Induction Generator) wind turbine. The control strategy of the system during the normal and fault condition are studied. In the normal condition, the GSVSC are operated by controlling constant frequency, voltage and phases. During the fault condition, the GSVSC converted to limit current model and dc voltage link are controlled by DFIG-RSC converter. These control strategies are validated in good performance in PSCAD/EMTDC platform.

Sign in / Sign up

Export Citation Format

Share Document