scholarly journals Modulation of ecdysal cyst and toxin dynamics of two <i>Alexandrium</i> (Dinophyceae) species under small-scale turbulence

2007 ◽  
Vol 4 (4) ◽  
pp. 559-567 ◽  
Author(s):  
L. Bolli ◽  
G. Llaveria ◽  
E. Garcés ◽  
Ò. Guadayol ◽  
K. van Lenning ◽  
...  
Keyword(s):  
Growth Rate ◽  
Toxin Production ◽  
Thin Layers ◽  
Small Scale ◽  
Alexandrium Minutum ◽  
Cell Numbers ◽  
Cyst Production ◽  
Net Growth Rate ◽  
Scale Turbulence ◽  
Orbital Shaker

Abstract. Some dinoflagellate species have shown different physiological responses to certain turbulent conditions. Here we investigate how two levels of turbulent kinetic energy dissipation rates (ε = 0.4 and 27 cm² s−3) affect the PSP toxins and ecdysal cyst dynamics of two bloom forming species, Alexandrium minutum and A. catenella. The most striking responses were observed at the high ε generated by an orbital shaker. In the cultures of the two species shaken for more than 4 days, the cellular GTX(1+4) toxin contents were significantly lower than in the still control cultures. In A. minutum this trend was also observed in the C(1+2) toxin content. For the two species, inhibition of ecdysal cyst production occurred during the period of exposure of the cultures to stirring (4 or more days) at any time during their growth curve. Recovery of cyst abundances was always observed when turbulence stopped. When shaking persisted for more than 4 days, the net growth rate significantly decreased in A. minutum (from 0.25±0.01 day−1 to 0.19±0.02 day−1) and the final cell numbers were lower (ca. 55.4%) than in the still control cultures. In A. catenella, the net growth rate was not markedly modified by turbulence although under long exposure to shaking, the cultures entered earlier in the stationary phase and the final cell numbers were significantly lower (ca. 23%) than in the control flasks. The described responses were not observed in the experiments performed at the low turbulence intensities with an orbital grid system, where the population development was favoured. In those conditions, cells appeared to escape from the zone of the influence of the grids and concentrated in calmer thin layers either at the top or at the bottom of the containers. This ecophysiological study provides new evidences about the sensitivity to high levels of small-scale turbulence by two life cycle related processes, toxin production and encystment, in dinoflagellates. This can contribute to the understanding of the dynamics of those organisms in nature.

scholarly journals Modulation of ecdysal cyst and toxin dynamics of two <i>Alexandrium</i> (Dinophyceae) species under small-scale turbulence

2007 ◽  
Vol 4 (2) ◽  
pp. 893-908 ◽  
Author(s):  
L. Bolli ◽  
G. Llaveria ◽  
E. Garcés ◽  
Ó. Guadayol ◽  
K. van Lenning ◽  
...  
Keyword(s):  
Growth Rate ◽  
Biomass Yield ◽  
Statistical Significance ◽  
Small Scale ◽  
Alexandrium Minutum ◽  
Cyst Production ◽  
Physiological Processes ◽  
Net Growth Rate ◽  
Scale Turbulence ◽  
Orbital Shaker

Abstract. In some dinoflagellate species, physiological processes appear to be altered by exposure to certain turbulent conditions. Here we investigated how two levels of turbulent kinetic energy dissipation rates (ε = 0.4 and 27 cm2 s−3) affected the toxin and ecdysal cyst dynamics of two bloom forming species, Alexandrium minutum and A. catenella. The most striking responses were observed at the high ε generated by an orbital shaker. In A. catenella, lower cellular toxin content was measured in cultures shaken for more than 4 days. The same trend was observed in A. minutum, although variability masked statistical significance. For the two species, inhibition of ecdysal cyst production occurred immediately and during the period of exposure of the cultures to stirring (4 or more days) at any time during their growth curve. Recovery of cyst abundances was always observed when turbulence stopped. When turbulence persisted for more than 4 days the net growth rate significantly decreased and the final biomass yield was lower than in the unshaken cultures. This study suggests that high levels of small-scale turbulence would contribute to the modulation of the harmful bloom dynamics through the interaction at the level of toxin and encystment processes.

The effects of turbulence on the mean flow past square rods

1983 ◽  
Vol 137 ◽  
pp. 331-345 ◽  
Author(s):  
Y. Nakamura ◽  
Y. Ohya
Keyword(s):  
Growth Rate ◽  
Shear Layer ◽  
Cross Section ◽  
Large Scale ◽  
Small Scale ◽  
Mean Flow ◽  
Flow Past ◽  
The Mean ◽  
Scale Turbulence ◽  
Main Effects

There are two main effects of turbulence on the mean flow past rods of square cross-section aligned with the approaching flow. Small-scale turbulence increases the growth rate of the shear layer, while large-scale turbulence enhances the roll-up of the shear layer. The consequences of these depend on the length of a square rod. The mean base pressure of a square rod varies considerably with turbulence intensity and scale as well as with its length.

Shear Loss Characteristics of an Aerobic Biofilm

1992 ◽  
Vol 26 (3-4) ◽  
pp. 595-600 ◽  
Author(s):  
S. M. Rao Bhamidimarri ◽  
T. T. See
Keyword(s):  
Growth Rate ◽  
Shear Stress ◽  
Film Thickness ◽  
Removal Rate ◽  
Surface Growth ◽  
Phenol Removal ◽  
Concentric Cylinder ◽  
Substrate Utilisation ◽  
Utilisation Rate ◽  
Net Growth Rate

Growth and shear loss characteristics of phenol utilizing biofilm were studied in a concentric cylinder bioreactor. The net accumulation of the biofilm and the substrate utilisation were measured as a function of torque. Uniform biofilms were obtained up to a thickness of around 300 microns, beyond which the surface growth was non-uniform. The substrate utilisation rate, however, reached a constant value beyond film thickness of 50 to 100 microns depending on the operational torque. The maximum phenol removal rate was achieved at a shear stress of 3.5 Nm-2. The effect of shear stress on net growth rate was found to be described byand a zero net growth was obtained at a shear stress of 18.7 Nm-2.

Similarity of dissipation and enstrophy in particle-induced small-scale turbulence

2020 ◽  
Vol 5 (1) ◽  
Author(s):  
Zhuo Wang ◽  
Kun Luo ◽  
Junhua Tan ◽  
Dong Li ◽  
Jianren Fan
Keyword(s):  
Small Scale ◽  
Scale Turbulence

scholarly journals Role of large-scale advection and small-scale turbulence on vertical migration of gyrotactic swimmers

2019 ◽  
Vol 4 (12) ◽  
Author(s):  
C. Marchioli ◽  
H. Bhatia ◽  
G. Sardina ◽  
L. Brandt ◽  
A. Soldati
Keyword(s):  
Vertical Migration ◽  
Large Scale ◽  
Small Scale ◽  
Scale Turbulence

scholarly journals Fabrication of freestanding Pt nanowires for use as thermal anemometry probes in turbulence measurements

2021 ◽  
Vol 7 (1) ◽  
Author(s):  
Hai Le-The ◽  
Christian Küchler ◽  
Albert van den Berg ◽  
Eberhard Bodenschatz ◽  
Detlef Lohse ◽  
...  
Keyword(s):  
Room Temperature ◽  
Fluid Velocity ◽  
Current Mode ◽  
Constant Current ◽  
Small Scale ◽  
Turbulence Measurements ◽  
High Dynamic ◽  
Scale Turbulence ◽  
Constant Current Mode ◽  
Pt Nanowires

AbstractWe report a robust fabrication method for patterning freestanding Pt nanowires for use as thermal anemometry probes for small-scale turbulence measurements. Using e-beam lithography, high aspect ratio Pt nanowires (~300 nm width, ~70 µm length, ~100 nm thickness) were patterned on the surface of oxidized silicon (Si) wafers. Combining wet etching processes with dry etching processes, these Pt nanowires were successfully released, rendering them freestanding between two silicon dioxide (SiO2) beams supported on Si cantilevers. Moreover, the unique design of the bridge holding the device allowed gentle release of the device without damaging the Pt nanowires. The total fabrication time was minimized by restricting the use of e-beam lithography to the patterning of the Pt nanowires, while standard photolithography was employed for other parts of the devices. We demonstrate that the fabricated sensors are suitable for turbulence measurements when operated in constant-current mode. A robust calibration between the output voltage and the fluid velocity was established over the velocity range from 0.5 to 5 m s−1 in a SF6 atmosphere at a pressure of 2 bar and a temperature of 21 °C. The sensing signal from the nanowires showed negligible drift over a period of several hours. Moreover, we confirmed that the nanowires can withstand high dynamic pressures by testing them in air at room temperature for velocities up to 55 m s−1.

scholarly journals 3–D Models of Galaxy Magnetic Fields with Spiral Shocks

1990 ◽  
Vol 140 ◽  
pp. 133-134
Author(s):  
J. Panesar ◽  
A.H. Nelson
Keyword(s):  
Gas Flow ◽  
Density Wave ◽  
Shock Velocity ◽  
Small Scale ◽  
Hydrodynamic Simulation ◽  
Dynamo Equation ◽  
Scale Turbulence ◽  
Wave Induced ◽  
The Magnetic Field ◽  
Stellar Density

We report here some preliminary results of 3–D numerical simulations of an α–ω dynamo in galaxies with differential rotation, small–scale turbulence, and a shock wave induced by a stellar density wave. We obtain the magnetic field from the standard dynamo equation, but include the spiral shock velocity field from a hydrodynamic simulation of the gas flow in a gravitational field with a spiral perturbation (Johns and Nelson, 1986).

Sign in / Sign up

Export Citation Format

Share Document