scholarly journals Implementasi Kontrol Proportional - Integral Pada Bidirectional Converter Untuk Sistem Pengisian Baterai Turbin Angin

2021 ◽  
Vol 2 (01) ◽  
pp. 30-35
Author(s):  
Hamlah Nadela Ilif Baridatul Jannah ◽  
Herman Hariyadi
Keyword(s):  
Renewable Energy ◽  
Error Control ◽  
Electrical Energy ◽  
Pi Control ◽  
Switching Circuit ◽  
Battery Charging ◽  
Integral Control ◽  
Proportional Integral ◽  
Initial Voltage ◽  
Bidirectional Converter

The level of demand for electrical energy in Indonesia is currently getting higher and will continue with the increase in population so that it is required to conduct research in the field of renewable energy. To be able to support renewable energy research, a switching circuit is needed for the battery charging system. The switching circuit used is a converter bidirectional circuit controlled by an Arduino Uno microcontroller based on PI (Proportional-Integral) control. PI control functions to regulate the voltage so that it has a stable output voltage value. From the research results of the Konverter bidirectional circuit, using trial and error control constants Kp: 2,6 and Ki: 5,6, it was found that the battery charging time was obtained with an initial voltage of 22.9 Volt to 24 Volt battery without using PI control, which was 6 hours 57 minutes, whereas if using the PI control with Kp: 2,6 and Ki: 5,6 with the initial battery voltage of 22.9 Volt to 24 Volt, the battery charging becomes faster, which is 2 hours 45 minutes.

scholarly journals Performance Evaluation Zeta Converter Using PI Controller for Energy Management in DC Nanogrid Isolated System

2021 ◽  
Vol 8 (1) ◽  
pp. 37
Author(s):  
Farid Dwi Murdianto ◽  
Indhana Sudiharto ◽  
Eni Wulandari
Keyword(s):  
Renewable Energy ◽  
Output Power ◽  
Alternative Energy ◽  
Good Control ◽  
Electrical Energy ◽  
Pi Controller ◽  
Pi Control ◽  
Alternative Energy Source ◽  
System Output ◽  
Output System

Renewable energy is needed as an alternative energy source. One of the implementations of renewable energy is the Solar Power Plant (PLTS). PLTS is a component that uses solar cells to convert solar energy into electrical energy. Unfortunately, the output power of this solar cell depends on the intensity of the light which causes the output power to enter the load to be unstable. Sometimes the PV power decrease because of the shading effect. From this problem a converter is needed to keep the system output voltage. The converter used in this research is the zeta converter. This Zeta converter can operate like a buck boost converter. The output of the system used is not stable. So that to stabilize it requires good control. In this paper using PI controller to control this system in order to keep the output system stable. 3. The error generated using the PI Control on the system is only 0.34%.

scholarly journals Fractional Order PI Control in Hybrid Renewable Power Generation System to Three Phase Grid Connection

2020 ◽  
Vol 12 (3) ◽  
pp. 470-493
Author(s):  
Ali Mohamed Yousef ◽  
◽  
Farag K. Abo-Elyousr ◽  
Ahmed Elnozohy ◽  
Moayed Mohamed ◽  
...  
Keyword(s):  
Renewable Energy ◽  
Fractional Order ◽  
Renewable Energy Sources ◽  
Operating Conditions ◽  
Renewable Energy Resources ◽  
Integral Control ◽  
Proportional Integral ◽  
Hybrid Renewable Energy System ◽  
Three Phase ◽  
Fopi Controller

The main objective of this paper is to allow renewable energy sources (RES) to actively participate within hybrid microgrid by proposing a new control system based on fractional order proportional integral (FOPI) controller. Fractional order proportional integral controller is a classical proportional integral (PI) in which the integral part is a fraction instead of integer numbers. The paper introduces a hybrid photovoltaic (PV), wind turbine and battery storage system connected to a three-phase grid. Three types of controller are considered and compared for a hybrid renewable energy system (HRES), namely, FOPI, PI, and the fractional order integral control (FIC). For the PV resource, maximum power point tracking (MPPT) controller was designed using the incremental conductance plus integral regulator technique. A DC/DC boost converter was utilized to connect the renewable energy resources to a point of common coupling. MATLAB/Simulink is adopted to perform the simulation results of the developed HRES. The results show that the FOPI controller outperforms other controllers under several operating conditions. The paper also includes experimental results from a prototype real scale.

On Energy Status indicators and the role of renewableEnergy under Economic Crisis

2014 ◽  
pp. 92-105
Author(s):  
P. Bezrukikh ◽  
P. Bezrukikh (Jr.)
Keyword(s):  
Renewable Energy ◽  
World Economy ◽  
Electrical Energy ◽  
Primary Energy ◽  
Primary Energy Consumption ◽  
Energy Status ◽  
Economy Growth ◽  
The World ◽  
Production Regime

The article analyzes the dynamics of consumption of primary energy and production of electrical energy in the world for 1973-2012 and the volume of renewable energy. It is shown that in the crisis year of 20 0 9 there was a significant reduction in primary energy consumption and production of electrical energy. At the same time, renewable energy has developed rapidly, well above the rate of the world economy growth. The development of renewable energy is one of the most effective ways out of the crisis, taking into account its production regime, energy, environmental, social and economic efficiency. The forecast for the development of renewable energy for the period up to 2020, compiled by the IEA, is analyzed. It is shown that its assessment rates are conservative; the authors justify higher rates of development of renewable energy.

scholarly journals A Sizing Method for PV–Battery–Generator Systems for Off-Grid Applications Based on the LCOE

Energies ◽  
2021 ◽  
Vol 14 (7) ◽  
pp. 1988
Author(s):  
Ioannis E. Kosmadakis ◽  
Costas Elmasides
Keyword(s):  
Renewable Energy ◽  
Energy Demand ◽  
Renewable Energy Sources ◽  
Temporal Distribution ◽  
Electrical Energy ◽  
Optimal Number ◽  
Diesel Generator ◽  
Levelized Cost Of Electricity ◽  
Sufficient Power ◽  
Battery Energy

Electricity supply in nonelectrified areas can be covered by distributed renewable energy systems. The main disadvantage of these systems is the intermittent and often unpredictable nature of renewable energy sources. Moreover, the temporal distribution of renewable energy may not match that of energy demand. Systems that combine photovoltaic modules with electrical energy storage (EES) can eliminate the above disadvantages. However, the adoption of such solutions is often financially prohibitive. Therefore, all parameters that lead to a functionally reliable and self-sufficient power generation system should be carefully considered during the design phase of such systems. This study proposes a sizing method for off-grid electrification systems consisting of photovoltaics (PV), batteries, and a diesel generator set. The method is based on the optimal number of PV panels and battery energy capacity whilst minimizing the levelized cost of electricity (LCOE) for a period of 25 years. Validations against a synthesized load profile produced grid-independent systems backed by different accumulator technologies, with LCOEs ranging from 0.34 EUR/kWh to 0.46 EUR/kWh. The applied algorithm emphasizes a parameter of useful energy as a key output parameter for which the solar harvest is maximized in parallel with the minimization of the LCOE.

Power Cycles of Generation III and III+ Nuclear Power Plants

2014 ◽  
Author(s):  
Alexey Dragunov ◽  
Eugene Saltanov ◽  
Igor Pioro ◽  
Pavel Kirillov ◽  
Romney Duffey
Keyword(s):  
Renewable Energy ◽  
Natural Gas ◽  
Thermal Efficiency ◽  
Nuclear Power ◽  
Power Plants ◽  
Renewable Energy Sources ◽  
Thermal Power ◽  
Electrical Energy ◽  
Energy Sources ◽  
Thermal Power Plants

It is well known that the electrical-power generation is the key factor for advances in any other industries, agriculture and level of living. In general, electrical energy can be generated by: 1) non-renewable-energy sources such as coal, natural gas, oil, and nuclear; and 2) renewable-energy sources such as hydro, wind, solar, biomass, geothermal and marine. However, the main sources for electrical-energy generation are: 1) thermal - primary coal and secondary natural gas; 2) “large” hydro and 3) nuclear. The rest of the energy sources might have visible impact just in some countries. Modern advanced thermal power plants have reached very high thermal efficiencies (55–62%). In spite of that they are still the largest emitters of carbon dioxide into atmosphere. Due to that, reliable non-fossil-fuel energy generation, such as nuclear power, becomes more and more attractive. However, current Nuclear Power Plants (NPPs) are way behind by thermal efficiency (30–42%) compared to that of advanced thermal power plants. Therefore, it is important to consider various ways to enhance thermal efficiency of NPPs. The paper presents comparison of thermodynamic cycles and layouts of modern NPPs and discusses ways to improve their thermal efficiencies.

Sign in / Sign up

Export Citation Format

Share Document