Solvent effect and Activation Parameters: A Kinetic Reaction of Ethyl Caprylate in Water-Acetone Media

Author(s):  
A.K. Singh

The kinetic result of hydrolysis of Ethyl Caprlyate has been investigated at different composition of aqueous-organic solvent with Acetone (30-70% v/v) over the temperature range of 20 to 400c. The calculated result follows second order kinetics and is observed that the rate decreases with increasing proportion of Acetone. This behavior is attributed electrostatic nature that various solvent-solute interaction in reaction media. Linear plots of Logk against water concentration shows that equilibrium shifted from dense form to bulky form. Iso-kinetic temperature has been determined with the help of slopes of (ΔH*) versus (ΔS*). Thermodynamic parameter has been calculated with the help of Wynne-Jones and Eyring equation.

REAKTOR ◽  
2018 ◽  
Vol 18 (2) ◽  
pp. 71
Author(s):  
Astri Nur Istyami ◽  
Tatang Hernas Soerawidjaja ◽  
Tirto Prakoso ◽  
Tri Ari Penia Kresnowati

Fatty acids are intermediate substances in synthesis of oleochemical products. Enzymatic technology of fatty acids production (also known as lipolysis) is now developing as potential substitution for the conventional production of fatty acid, i.e. thermal hydrolysis of triglyceride. It offers more economical process condition, low energy consumption, and minimal product degradation compared to the conventional process. This research aims to evaluate performance of various organic solvents as reaction media in lipolysis with plant latex lipase. Organic solvents observed were chloroform, n-hexane, diethyl ether, benzene, acetone, ethanol, methanol, n-heptane, and isooctane. Analysis of each organic solvent effect on lipolysis was described based on solvents properties. Conversion of lipolysis with organic solvents is 0,10-1,25 times fold compared to conversion of non-solvent lipolysis. We suggest that dielectric constant and viscosity are the two main organic solvent properties affecting lipase performance in lipolysis. Overall, n-hexane, n-heptane, and isooctane are recommended to be used as reaction media in lipolysis with plant lipase because their effects to degree of lipolysis are positive.  Keywords: lipolysis; lipase; organic solvent; frangipani


2020 ◽  
Vol 16 (5) ◽  
pp. 72-77
Author(s):  
RENU KUMARI ◽  
◽  
R.T. SINGH ◽  

From the eenhancement observed in G* values with simultaneous decrease in the values of H and S* of the reaction, it is concluded that the organic co-solvent dimethyl formamide (DMF) acts as entropy controller and enthalpy stimulator solvent for alkali catalysed solvolysis of Methyl nicotinate. Form the evaluated values of water molecules associated with the activated complex of the reaction which are found to increase with increase in the temperature of the reaction, it is inferred that the bimolecular mechanistic path is changed to unimolecular in presence of the organic component (DMF) of the reaction media. The numerical value of Iso-Kinetic temperature of the reaction which comes to be nearly 287.5 (below 300) indicates that there is weak but considerable solvent-solute interaction in the aquo-DMF solvent system.


2021 ◽  
Author(s):  
Mandana Ehsanipour

This study compared two acidic pretreatments on Source-Separated Organic (SSO) waste preprocessed by Aufbereitungs Technology and System thermal-screw, on the basis of fermentable sugars for bioethanol production. The result showed that the SSO contained on average 27% glucan, 5.4% xylan, 1.2% arabinan, 5.7% mannan and 1.2% galactan. Dilute sulfuric acid pretreatment (at 121°C and 16.2 psi) was insufficient to solubilize cellulose and hemicellulose and did not remove much of the lignin. Cellulose-solvent and Organic Solvent-based Lignocellulose Fractionation (COSLIF) (at 50°C and atmospheric pressure) generated high glucose yield (70%). Substituting ethanol for acetone as organic solvent increased the yield to 89.5%. Fermentation using Zymomonas mobilis 8b with this hydrolysate confirmed the pretreatment is promising for the SSO conversion. Amenability of the SSO for biofuel production is validated. Enzymatic hydrolysis of both pretreatments using Accellerase 1500 is preferred over Celluclast 1.5L due to higher activity. Future work includes design of an appropriate batch and/or continuous bioreactor, and further understanding of Zymomonas mobilis 8b.


Author(s):  
Elizabeth Fatima de Souza ◽  
Silvia Dani ◽  
Lavinel G. IONESCU

The micellization of dilauryldimethylammonium bromide (DLDMAB) in water was studied by using surface tension measurements. The critical micellar concentration (CMC) was determined at 25°C, 32°C and 40°C and thermodynamic parameters such as the free energy of micellization (∆G°mic), enthalpy (∆H°mic), and entropy (∆S°mic) of micellization were measured. The CMC at 25°C was 4.93 x 10-5 M and the corresponding values of the thermodynamic parameters were: ∆G°mic = -5.87 kcal/mol; ∆H°mic = -1.12 kcal/mol and ∆S°mic = +16.00 e.u. Micelles of the surfactant DLDMAB act as catalysts for the alkaline hydrolysis of p-nitrophenyl diphenyl phosphate (NPDPP) with a maximum catalytic factor of approximately 120 compared to 80 for CTAB. Typical activation parameters measured for 1.00 x 10-3 M surfactant and 0.005 M NaOH were: Ea = 9.7 kcal/mo/; ∆H°≠ = 9.1 kcal/mol; ∆G°≠ = 19.6 kcal/mol and ∆S°≠ = -33.9 e.u. The kinetic results were also analyzed in terms of the pseudo-phase ion-exchange models (PPIE) and showed that the model is applicable to describe the experimental results.


Author(s):  
Jaruwan Damaurai ◽  
Thanchanok Preechakun ◽  
Marisa Raita ◽  
Verawat Champreda ◽  
Navadol Laosiripojana

2005 ◽  
Vol 83 (9) ◽  
pp. 1391-1399 ◽  
Author(s):  
Robin A Cox

The mechanisms given in textbooks for both ester and amide hydrolysis in acid media are in need of revision. To illustrate this, benzimidates were chosen as model compounds for oxygen protonated benzamides. In aqueous sulfuric acid media they hydrolyze either by a mechanism involving attack of two water molecules at the carbonyl carbon to give a neutral tetrahedral intermediate directly, as in ester hydrolysis, or by an SN2 attack of two water molecules at the alkyl group of the alkoxy oxygen to form the corresponding amide, or by both mechanisms, depending on the structure of the benzimidate. The major line of evidence leading to these conclusions is the behavior of the excess acidity plots resulting from the rate constants obtained for the hydrolyses as functions of acid concentration and temperature. The first of these mechanisms is in fact very similar to one found for the hydrolysis of benzamides, as inferred from: (1) similar excess acidity plot behaviour; and (2) the observed solvent isotope effects for amide hydrolysis, which are fully consistent with the involvement of two water molecules, but not with one or with three (or more). This mechanism starts out as essentially the same one as that found for ester hydrolysis under the same conditions. Differences arise because the neutral tetrahedral intermediate, formed directly as a result of the protonated substrate being attacked by two water molecules (not one), possesses an easily protonated nitrogen in the amide and benzimidate cases, explaining both the lack of 18O exchange observed for amide hydrolysis and the irreversibility of the reaction. Protonated tetrahedral intermediates are too unstable to exist in the reaction media; in fact, protonation of an sp3 hybridized oxygen to put a full positive charge on it is extremely difficult. (This means that individual protonated alcohol or ether species are unlikely to exist in these media either.) Thus, the reaction of the intermediate going to product or exchanged reactant is a general-acid-catalyzed process for esters. For amide hydrolysis, the situation is complicated by the fact that another, different, mechanism takes over in more strongly acidic media, according to the excess acidity plots. Some possibilities for this are given.Key words: esters, amides, benzimidates, hydrolysis, excess acidity, mechanism, acid media.


Sign in / Sign up

Export Citation Format

Share Document