Development of a boom with an internal spring-type frame

2021 ◽  
pp. 105-114
Author(s):  
S.M. Sultanmagomedov ◽  
◽  
D.R. Khairullin ◽  
K.R. Nailevich ◽  
◽  
...  
Keyword(s):  
Petroleum Products ◽  
Steel Cable ◽  
Spring Type

The article considers the relevance of the use of inflatable booms. When they are installed using a steel cable previously stretched across the river, the threat of inflection of local sections of booms and, consequently, the overflow of oil and petroleum products over them is significantly reduced. It was proposed to use booms with a spring in the inner buoyancy chamber. Installation bona is made from a folded state to a compressed after disconnecting skirt, and compressed in the work, straightening of the spring. Adjust the shape of the boom two cables stretched along it. After connecting the sections of the booms, the installation of a full whip across the river.

Equipment dentifying Vapor Leakages and Recovery of Petroleum Product Vapor When Stored

2020 ◽  
Vol 05 ◽  
pp. 60-64
Author(s):  
Y.N. Rybakov ◽  
◽  
V.E. Danilov ◽  
I.V. Danilov ◽  
◽  
...  
Keyword(s):  
Environmental Pollution ◽  
Environmental Protection ◽  
Petroleum Product ◽  
Petroleum Products ◽  
Oil Products ◽  
Carnot Cycle ◽  
Oil Supply ◽  
Gas Stations ◽  
Environmental Situation ◽  
Vapor Absorption

The problem of losses of oil products from leaks during their storage and transportation at oil supply facilities is considered. The influence of oil product leaks on the environmental situation around oil depots and gas stations is shown. A detailed overview of existing methods and tools for detecting leaks of petroleum products from storage facilities is presented. The evaluation of their effectiveness. Two methods for detecting oil leaks and devices based on them are proposed. The first device monitors the movement of liquid in the tank, the second-detects petroleum products in wastewater. The problem of recovery of petroleum vapors and environmental pollution from the release of vapors of light fractions into the atmosphere is also considered. An overview of existing methods and means of recovery of petroleum vapors is presented. Two methods and devices for capturing oil vapors and returning them to the reservoir are proposed, based on different principles: vapor absorption in the cooled oil product and vapor recovery on the principle of the Carnot cycle. It is shown that these devices can provide effective detection of oil leaks and recovery of their vapors, as well as improve the effectiveness of environmental protection at modern gas stations and tank farms.

To the issue of water treatment by hydrocyclone on the systems of the combined irrigation

2020 ◽  
Vol 0 (2) ◽  
pp. 21-25
Author(s):  
Nikolay Dubenok ◽  
Andrey Novikov ◽  
Sergei Borodychev ◽  
Maria Lamskova
Keyword(s):  
Water Treatment ◽  
Organic Compounds ◽  
Irrigation Water ◽  
Irrigation System ◽  
Petroleum Products ◽  
Cylindrical Part ◽  
Agricultural Landscapes ◽  
Treatment Unit ◽  
Drain Pipe ◽  
Irrigation Network

At the stage of water treatment for irrigation systems, the efficiency capture coarse and fine mechanical impurities, as well as oil products and organic compounds affects the reliability of the equipment of the irrigation network and the safety of energy exchange processes in irrigated agricultural landscapes. The violation of work irrigation system can cause disruptions in irrigation schedules of agricultural crops, crop shortages, degradation phenomena on the soil and ecological tension. For the combined irrigation system, a water treatment unit has been developed, representing a hydrocyclone apparatus with a pipe filter in the case. For the capacity of 250 m3/h the main geometrical dimensions of hydrocyclone have been calculated. To organize the capture petroleum products and organic compounds, it has been proposed a modernization of a hydrocyclone unit, consisting in dividing the cylindrical part of the apparatus into two section. The first is section is for input irrigation water, the second one is for additional drainage of clarified irrigation water after sorption purification by the filter, placed on the disk and installed coaxially with the drain pipe and the pipe filter.

Energetic properties of peat saturated with petroleum products

2020 ◽  
Vol 13 (2) ◽  
pp. 105-109
Author(s):  
E. S. Dremicheva
Keyword(s):  
Crude Oil ◽  
Diesel Fuel ◽  
Energy Use ◽  
Experimental Studies ◽  
Calorific Value ◽  
Petroleum Products ◽  
Ash Content ◽  
Motor Oil ◽  
Initial Sample

This paper presents a method of sorption using peat for elimination of emergency spills of crude oil and petroleum products and the possibility of energy use of oil-saturated peat. The results of assessment of the sorbent capacity of peat are presented, with waste motor oil and diesel fuel chosen as petroleum products. Natural peat has been found to possess sorption properties in relation to petroleum products. The sorbent capacity of peat can be observed from the first minutes of contact with motor oil and diesel fuel, and significantly depends on their viscosity. For the evaluation of thermal properties of peat saturated with petroleum products, experimental studies have been conducted on determination of moisture and ash content of as-fired fuel. It is shown that adsorbed oil increases the moisture and ash content of peat in comparison with the initial sample. Therefore, when intended for energy use, peat saturated with petroleum products is to be subjected to additional drying. Simulation of net calorific value has been performed based on the calorific values of peat and petroleum products with different ratios of petroleum product content in peat and for a saturated peat sample. The obtained results are compared with those of experiments conducted in a calorimetric bomb and recalculated for net calorific value. A satisfactory discrepancy is obtained, which amounts to about 12%. Options have been considered providing for combustion of saturated peat as fuel (burnt per se and combined with a solid fuel) and processing it to produce liquid, gaseous and solid fuels. Peat can be used to solve environmental problems of elimination of emergency spills of crude oil and petroleum products and as an additional resource in solving the problem of finding affordable energy.

Comparative assessment of rubber steel cables for vertical mine hoists

2020 ◽  
pp. 85-93
Author(s):  
V. E. Perekutnev ◽  
V. V. Zotov
Keyword(s):  
Feasibility Study ◽  
Carrying Capacity ◽  
Load Distribution ◽  
Comparative Assessment ◽  
Life Extension ◽  
Steel Cable ◽  
Motion Stability ◽  
Cable Length ◽  
Steel Cables ◽  
Mine Hoist

Operation of inhaul rubber steel cables in vertical mine hoisting is discussed. The research in the field of mine hoisting is reviewed, and the further R&D directions are identified. Some studies concern life extension of hoisting ropes. One of the promising trends seems to be application of belt pullers as inhaul cables, which can essentially enhance mine hoist efficiency. In the meanwhile, capabilities of rubber steel cables suffer from deficient attention. The performance capabilities of rubber steel cables of top manufacturers (Promkanat and SAG) are compared, and application ranges in vertical mine hoisting are determined for such cables. It is found that the Polish manufacturer’s rubber steel cables offer a wider range of application. The analysis shows that rubber steel cables can be used as inhaul cables of vertical mine hoisters. Rubber steel cables possess suitable characteristics and are capable to elevate considerable loads to various hoisting heights. In particular, the existing rubber steel cables ensure carrying capacity of hoists up to 20-25 t at the hoisting heights to 400-500 m and sometimes can elevate skips with tonnage of 10 t to a height up to 1000 m and more. The further feasibility study of operation of inhaul steel rubber cables in hoisting units should address motion stability of a puller on a driving drum, load distribution in ropes of base of rubber steel cables, validation of hoister design, adjustability of rubber steel cable length during its operation, etc.

Sign in / Sign up

Export Citation Format

Share Document