Hydrogen and Ethanol as Potential Alternative Fuels Compared to Gasoline under Improved Exhaust Gas Recirculation

2014 ◽  
Vol 27 (3 (C)) ◽  
REAKTOR ◽  
2017 ◽  
Vol 16 (3) ◽  
pp. 116
Author(s):  
S Syaiful ◽  
S Sobri

Diesel engines have been widely used as a mode of public transport and private vehicles because of several advantages compared to gasoline engines including greater power, fuel economy, high reliability and durability of the engine and lower CO emissions. However, diesel engines release more NOx and soot emissions into the atmosphere. This is a serious problem with the strict regulations regarding exhaust emissions. Besides problems of depletion of fossil fuel reserves require various parties to seek alternative fuels derived diesel fuel. Therefore, this work is intended to reduce soot emissions by adding LPM (low purity methanol) or wet methanol and HPM (high purity methanol) into a mixture of jatropha and diesel fuels. From this research, it is also desirable to observe the effect of methanol additive to the specific fuel consumption. Experiment method was conducted to obtain the correlation between the percentage of methanol to a brake specific fuel consumption (BSFC) and soot emissions. Methanol (LPM and HPM) was varied in the range of 5 to 15% by volume. Jatropha is in the range of 10% to 30%. The rate of EGR (exhaust gas recirculation) expressed by OEV (opening EGR valve) was varied at the opening of 0 to 100%. Engine load was varied from 25 to 100% at intervals of 25%. The engine speed was kept constant of 2000 rpm. The results show that the use of fuel mixture increases evenly BSFC of 5.2% and soot emissions of 65%. Keywords: LPM and HPM, BSFC, soot emissions, jatropha, cold EGR and diesel engine  Abstrak Mesin diesel telah banyak digunakan sebagai moda transportasi umum dan kendaraan pribadi oleh karena beberapa kelebihannya dibandingkan dengan mesin bensin diantaranya daya yang lebih besar, hemat bahan bakar, kehandalan dan ketahanan mesin yang tinggi (high realibility and durability), dan emisi CO yang lebih rendah. Akan tetapi mesin diesel melepaskan lebih banyak emisi NOx dan jelaga ke atmosfir. Hal ini menjadi permasalahan serius dengan semakin ketatnya regulasi menyangkut emisi gas buang. Selain itu permasalahan menipisnya cadangan bahan bakar fosil menuntut berbagai pihak untuk mencari bahan bakar alternatif pengganti solar. Oleh karena itu, penelitian ini bermaksud untuk mereduksi emisi jelaga dengan menambahkan LPM (low purity methanol) atau wet methanol dan HPM (high purity methanol)kedalam campuran bahan bakar jatropha dan solar. Dari penelitian ini juga diinginkan untuk mengamati pengaruh aditif metanol terhadap konsumsi bahan bakar spesifik. Metode eksperimen dilakukan untuk mendapatkan keterkaitan antara prosentase metanol terhadap brake specific fuel consumption (BSFC)dan emisi jelaga. Metanol (LPM dan HPM) divariasikan pada rentang 5% sampai 15%. Jatropha adalah pada rentang 10% sampai 30%. Laju EGR (exhaust gas recirculation) yang dinyatakan oleh OEV (opening EGR valve) divariasikan pada bukaan 0% sampai 100%. Beban mesin divariasikan dari 25% sampai 100% dengan interval 25%. Putaran mesin dipertahankan konstan 2000 rpm. Hasil-hasil penelitian menunjukkan bahwa penggunaan bahan bakar campuran rata-rata meningkatkan BSFC 5,2% dan menurunkan emisi jelaga sampai 65%.


Author(s):  
Peter Kutne ◽  
Judith Richter ◽  
James D. Gounder ◽  
Clemens Naumann ◽  
Wolfgang Meier

To reduce CO2 emissions from the combustion of fossil and alternative fuels, carbon capture technologies present a promising approach. But the efficiency of the capture process depends on the CO2 concentration in the exhaust gas which is relatively low for gas turbine power plants. Exhaust gas recirculation (EGR) is a promising approach to increase the CO2 concentration in the exhaust gas stream and thus reduce the energy losses. In this study a FLOX® combustor was used to investigate the influence of EGR on the combustion process of natural gas at elevated pressure. The combustor stabilizes the flame without use of swirl, by creating a strong recirculation through high momentum injection of the fresh gas into the combustion chamber. This enables the establishment of a distributed combustion zone, which promises advantages for the use of gas mixtures with low reactivity like those occurring in EGR processes. At a pressure of 5 bar it was possible to increase the CO2 concentration in the exhaust gas up to 7 vol%, which is already enough to realize an efficient CO2 capture process. At 10 bar the CO2 concentration could be increased to 9 vol%. The changes in flame stabilization due to pressure increase and different EGR rates are investigated by OH*-chemiluminescence imaging and discussed. The contribution of auto-ignition and flame propagation to flame stabilization is estimated by a kinetic model calculation.


Sign in / Sign up

Export Citation Format

Share Document