scholarly journals Evaluation of Success Rate of Early Loading Versus Delayed Loading Single-Tooth Implants – Results after 2 Years of Clinical Function

2019 ◽  
Vol 11 (2) ◽  
Keyword(s):  
Success Rate ◽  
Early Loading ◽  
Single Tooth

scholarly journals Clinical and radiological evaluation of delayed and early loading of single-tooth implant placement: A 6-month, prospective, randomized, follow-up clinical study

2019 ◽  
Vol 11 (6) ◽  
pp. 278
Author(s):  
Santhosh Sekar ◽  
Thangakumaran Suthanthiran ◽  
Arthiie Thangavelu ◽  
SasiKumar Karupannan ◽  
Fairlin Prem ◽  
...  
Keyword(s):  
Clinical Study ◽  
Radiological Evaluation ◽  
Implant Placement ◽  
Early Loading ◽  
Single Tooth ◽  
Single Tooth Implant

Histomorphometric Evaluation of Six Dental Implant Surfaces After Early Loading in Augmented Human Sinuses

10.1563/812.1 ◽  
2006 ◽  
Vol 32 (4) ◽  
pp. 153-166 ◽  
Author(s):  
Marzio Todisco ◽  
Paolo Trisi
Keyword(s):  
Histomorphometric Analysis ◽  
Implant Surface ◽  
Native Bone ◽  
Early Loading ◽  
Single Tooth ◽  
Bone To Implant Contact ◽  
Etched Surface ◽  
Plasma Sprayed ◽  
The Impact ◽  
Limited Scope

Abstract This study investigated the bone-to-implant contact (BIC) and osteoconductive capacity (OC) of 6 different implant surfaces after early loading in humans. Two implants with different surfaces were placed side-by-side in the grafted (n = 5) and nongrafted (n = 1) sinuses of 3 volunteers. Single-tooth restorations were delivered 60 days later. After 6 months of full occlusal loading, implants were retrieved in block sections for histomorphometric analysis. One implant (acid etched) placed in grafted bone failed when loaded. There were no other complications. In grafted bone, the microtextured surface achieved the highest BIC value (94.08%), followed by the oxidized (77.32%), hydroxyapatite (HA) (74.51%), sandblasted and acid-etched (51.85%), and titanium plasma-sprayed (TPS) (41.48%) surfaces. In native bone, the acid-etched surface achieved a higher BIC value (69.03%) than the HA surface (59.03%). The highest OC value in grafted bone was exhibited by the microtextured surface (34.31%), followed by the HA (28.62%), sandblasted and acid-etched (25.08%), oxidized (17.55%), and TPS (−20.47%) surfaces. The HA surface exhibited a higher OC value (30.39%) in native bone compared with the acid-etched surface (24.0%). As a whole, highest BIC and OC values were exhibited by the microtextured surface, and lowest values were exhibited by the TPS surface. All other surfaces demonstrated excellent BIC (>50%) but varied in OC (range = 17.55%–28.62%). These findings are tempered by the limited scope and sample size of the study and should be considered preliminary. More research is needed to determine the impact of implant surface texture on BIC and OC.

scholarly journals Early Loading of Single-Piece Implant for Partially Edentulous Posterior Arch: A Prospective One-Year Case Report

2013 ◽  
Vol 2013 ◽  
pp. 1-5
Author(s):  
Amol Beldar ◽  
Manohar L. Bhongade ◽  
Girish Byakod ◽  
Chandrashekar Buregoni
Keyword(s):  
Case Report ◽  
Treatment Time ◽  
Healing Time ◽  
Posterior Arch ◽  
Early Loading ◽  
Single Piece ◽  
Single Tooth ◽  
Implant Therapy ◽  
One Year ◽  
Rehabilitation Time

Implant therapy is now well established, and there is an increasing need for shorter rehabilitation time. Original prerequisites of osseointegration have been reassessed to satisfy continuously increasing patient's expectation of reduced treatment time, improved esthetics, and increased comfort. Shorter healing time may be appropriate in some circumstances, and examples of early loading have been reported in animal and human studies. However, to date there are insufficient data to determine a universally acceptable opinion on early loading of implants for single-tooth replacement. This case report involves early loading, combined with construction of a restoration, inserted directly after 6 weeks of implant surgery and followup of one year.

Single-Tooth Replacements in the Esthetic Zone With an Immediate Function Implant: A Preliminary Report

2004 ◽  
Vol 30 (6) ◽  
pp. 369-375 ◽  
Author(s):  
William M. Locante
Keyword(s):  
Bone Density ◽  
Clinical Response ◽  
Success Rate ◽  
Preliminary Report ◽  
Single Tooth ◽  
Immediate Function

Abstract Patients demand an economic, esthetic, and expedient fashion to replace teeth that are missing in the esthetic zone. The clinical response of a 1-piece spiral immediate-function implant was evaluated for this purpose. The implants were placed into immediate extraction sites as well as healed sites and were provisionalized, and patients were put into immediate function the same day as surgery. Sites that qualified for this technique were based on bone density. Bone density in combination with its aggressive thread design and conservative surgical osteotomy preparation produced a 98.8% success rate over a 3-year period for 86 patients.

Success Rate of Immediate Nonfunctional Loaded Single-Tooth Implants: Immediate Versus Delayed Implantation

2008 ◽  
Vol 17 (1) ◽  
pp. 109-117 ◽  
Author(s):  
Fernando Salimon Ribeiro ◽  
Ana Emília Farias Pontes ◽  
Elcio Marcantonio ◽  
Adriano Piattelli ◽  
Rodolfo Jorge Boeck Neto ◽  
...  
Keyword(s):  
Success Rate ◽  
Delayed Implantation ◽  
Single Tooth

scholarly journals Effect of Combined Application of Growth Factors and Diode Laser Bio-Stimulation on the Osseo Integration of Dental Implants

2019 ◽  
Vol 7 (15) ◽  
pp. 2520-2527
Author(s):  
Mohamed Ali Ali Arakeeb ◽  
Ahmed Abbas Zaky ◽  
Tarek Abdel-Hamid Harhash ◽  
Walid S. Salem ◽  
Mohamed El-Mofty
Keyword(s):  
Success Rate ◽  
Dental Implants ◽  
Dental Implant ◽  
Implant Design ◽  
Control Group ◽  
New Techniques ◽  
Combined Application ◽  
Early Loading ◽  
Level Laser ◽  
Male Patients

BACKGROUND: The success of implants is associated first with their osseointegration, and later on with their survival rate. In recent years, many efforts have been exerted to develop implant design, geometry, materials and techniques to enhance the osseointegration process and also to increase the success rate of implant procedures. New techniques, like leukocyte and platelet-rich fibrin (L-PRF) and low-level laser treatment (LLLT), have been developed to enhance the osseointegration around dental implants. AIM: This study aims at accelerating bone osseointegration process around dental implant using new techniques to increase the success rate, to allow immediate or early loading of a dental implant, and to make a comparison between the various new techniques in dental implant procedures to figure out which technique will achieve the best results. METHODS: The study was conducted on a random sample of 40 male patients. Dental implants were placed in the posterior areas of the lower jaw. Patients were divided randomly into 4 groups; control group, LLLT group, L-PRF group and L-PRF plus LLLT group. They were assessed using cone-beam computed tomography (CBCT). RESULTS: The results showed significant differences between all groups over different measured times. All the groups showed improvement in comparison with Normal group, where L-PRF group showed the best result followed by (L-PRF+LLLT) group, while the LLLT group showed the least improvement in comparison with bothL-PRF group and (L-PRF+LLLT) group. CONCLUSION: The study demonstrates that L-PRF gives a better performance in the osseointegration around dental implants than LLLT.

scholarly journals Success Rate of Zygomatic Implants for Rehabilitation of Severely Atrophied Maxillae: A Review of the Literature

2018 ◽  
Vol 3 (1) ◽  
pp. 771-777
Author(s):  
Felipe Cid ◽  
Bárbara Soto
Keyword(s):  
Success Rate ◽  
Treatment Modalities ◽  
Gingival Hyperplasia ◽  
Prosthetic Reconstruction ◽  
Early Loading ◽  
Posterior Maxilla ◽  
Zygomatic Implants ◽  
Fixed Prosthesis ◽  
Therapeutic Alternatives ◽  
Zygomatic Implant

Severe resorption in the posterior maxilla sectors as a result of tooth loss along with the process of pneumatization of the maxillary sinus, difficult the prosthetic rehabilitation supported by conventional implants due to the shortage of vertical bone availability. So that over the years they have designed therapeutic alternatives to help overcome these drawbacks. The zygomatic implant was introduced in 1988 by Branemark. This implant has a design which allows it to be positioned over the ridge to the height of the first molar, reducing vestibular cantilever up to 20 % and reducing complications of peri-implant inflammation, infection and gingival hyperplasia, which may lead to perforation horizontal process of the palatine bone. The purpose of this review is to determine the success rate of zygomatic implants for rehabilitation of severely atrophied maxillae. A total of 1410 zygomatic implants and 1673 Traditional implants were included in selected articles. Of these 1410 zygomatic Implants, 365 were conventional loading and 1045 were immediately and early loading, these had a success rate of 98.3 % and 98.7 %, respectively. Of these 1673 Traditional Implants, 463 were conventional loading and 1210 were immediately and early loading, they had a success rate of 93.9 % and 97.8 %, respectively. The overall success rate of zygomatic implants and Conventional implants was 98.6 % and 96.8%, respectively. The rehabilitation of severely atrophied maxilla with fixed prosthesis immediately and conventional loaded by zygomatic implants gives excellent results in the medium term. When comparing traditional treatment modalities, proposals for prosthetic reconstruction of severely atrophied maxilla, the zygomatico implant has the highest success rate over conventional treatments.

scholarly journals 3D Considerations and Outcomes of Immediate Single Implant Insertion and Provisionalization at the Maxillary Esthetic Zone: A Long-Term Retrospective Follow-Up Study of Up to 18 Years

2021 ◽  
Vol 10 (18) ◽  
pp. 4138
Author(s):  
Eitan Mijiritsky ◽  
Antonio Barone ◽  
Ihsan Caglar Cinar ◽  
Katalin Nagy ◽  
Maayan Shacham
Keyword(s):  
Success Rate ◽  
Radiographic Evaluation ◽  
Marginal Bone Loss ◽  
Follow Up Study ◽  
Single Tooth ◽  
Bone Deposition ◽  
Immediate Implantation ◽  
Single Implant

Aim: Long-term studies addressing the outcomes of single immediate implantation and provisionalization at the maxillary esthetic zone are needed. The current study aimed to assess such outcomes along a follow-up period of up to 18 years. Materials and methods: The current study is a continuation follow-up of our previously published up to 6-year follow-up study, dated between the years 2002–2008, performed in a private clinical practice in Tel-Aviv, Israel. A total of 15 patients (23 implants) who had been treated for single-tooth replacement at the maxillary esthetic zone since 2002, underwent clinical and radiographic follow-up evaluations. Primary outcomes included mean Marginal Bone Levels (MBL), with Bleeding on Probing (BOP), implant success rate, prosthetic and esthetic complications evaluated as secondary outcomes. Results: The implant success rate was at 100%. Bone remodeling processes were observed over the follow-up period, with 0.9 mm mean marginal bone loss observed during the first 6 years of observation, followed by −0.13 ± 0.06 mm mean loss after 6 to 18 years. The last finding suggests bone deposition, as reported by other studies (Donati et al., 2012). At the final radiographic evaluation, a mean MBL of 1.35 mm ± 0.16 was demonstrated. No differences with respect to implant type or site were found. A generalized absence of BOP and esthetic complications occurred in two cases as a result of continuous adjacent teeth eruption versus obvious implant ankylosis. Conclusions: Adhering to careful clinical protocols and 3D bone to implant considerations while immediately placing an anterior implant, this treatment approach offers both stable and esthetically acceptable results for the replacement of missing teeth at the maxillary esthetic zone.

1335: Is there an Inherent Ceiling on the Success Rate of Slings?

2007 ◽  
Vol 177 (4S) ◽  
pp. 440-440
Author(s):  
Kathleen C. Kobashi ◽  
Fred E. Govier ◽  
Tanya M. Nazemi
Keyword(s):  
Success Rate
Sign in / Sign up

Export Citation Format

Share Document