Developing a hospital electronic death record and storage system for deceased patients in developing countries

Author(s):  
Alfred Coleman
Author(s):  
Syeda Shafia Zehra ◽  
Aqeel Ur Rahman ◽  
Hammad Armghan ◽  
Iftikhar Ahmad ◽  
Umme Ammara

2020 ◽  
Vol 7 (1) ◽  
Author(s):  
Inês Melo ◽  
João Paulo Neto Torres ◽  
Carlos Alberto Ferreira Fernandes ◽  
Ricardo A. Marques Lameirinhas

2015 ◽  
Vol 9 (7) ◽  
pp. 161
Author(s):  
David Licindo ◽  
Arinne Christin Paramudita ◽  
Renanto Handogo ◽  
Juwari Purwo Sutikno

Carbon capture and storage (CCS) is one of the technologies to reduce greenhouse gas emissions (GHG) tocapture of CO2 from the flue gas of a power plant that typically use coal as a Source of energy and then store it ina suitable geological storage (in specific locations). In practice, these sites may not be readily available forstorage at the same time that the Sources (GHG producing) are operating which gives rise to multi – periodplanning problems. This study presents a mathematical approach by considering constraints limit flowratereceived by Sink, various time availability of Sink and Source and calculation with the purpose to determine theminimum cost network which is getting the maximum load that is exchanged from Source to Sink. Illustrativecase studies are given to demonstrate the application of mathematical models to obtained with the exact result ofthe exchange network from Source to Sink. Derived from network obtained from the calculation of theMaximum Load Source to Sink and results may vary in accordance with the limitations that exist in themathematical model. The case study has been prepared with 2 cases, first 6 Source and 3 Sink with value ofSource Load is greater than the amount available on the Sink. Also, second case is 2 Source and 5 Sinkwithvalue of Source Load is smaller than the amount available on the Sink. In addition, Case Studies tominimize the cost of pipeline construction and distribution of CO2 by plant and storage location determination inJava. Flowrate restriction factor that goes into Sink, Source and Sink establishment time and cost are taken intoaccount can affect the networks that can be exchanged from the Source to the Sink.


2013 ◽  
Vol 367 ◽  
pp. 541-543
Author(s):  
Yun Peng Li

This article focuses on research and implementation of a kind of solid storage system that is based on NAND flash which can store the data with high speed and huge capacity. A design with quad 1.25Gsps ADC and flash storage array with 1TB is demonstrated in the paper. The design is applied widely in many fields such as radar, communication and speech recognition. The detail of hardware development is also introduced in the thesis. In addition, a method is discussed to approve the reading and writing bandwidth by parallel operations on multiple pieces of flash. By using the method, the data bandwidth is arrived 6GB/S.


2014 ◽  
Vol 1070-1072 ◽  
pp. 24-29
Author(s):  
Xiao Di Qin ◽  
Rong Rong Zhou ◽  
Lie Xia ◽  
Liang Hui Xu

Based on practical project and application, the design scheme of small capacity of integrated PV and storage grid-connected generation system is presented in this paper. For demonstrative and experimental purpose in this project, it includes several typical PV modules, tracking system and grid-connected inverters. Entire design scheme covers system integration, grid-connected solution, PV array and bracket, monitoring system, energy storage system, and etc. Configuration and application prospect of energy storage system in grid-connected PV system are mainly introduced. The characteristics of lithium battery and vanadium redox flow battery, as well as their application in the field of distributed power generation are researched.


1985 ◽  
Vol 107 (3) ◽  
pp. 569-573 ◽  
Author(s):  
C. M. Harman ◽  
S. Loesch

A method for increasing the peak output of steam power plants through use of a low-pressure feedwater storage system is presented. The generalized availability analysis involves only the low-pressure turbine, low-pressure feedwater heaters, and the storage system. With daily cycling and storage charging at near base load conditions, the turnaround efficiency of the energy storage system was found to approach 100 percent. Storage system turnaround efficiency is decreased when the energy is stored during plant part-load operation.


2015 ◽  
Vol 713-715 ◽  
pp. 1448-1451
Author(s):  
Lin Lu ◽  
Yan Feng Zhang ◽  
Xiao Feng Li

The high-altitude missile and other special application occasions have requirements on image storage system, such as small size, high storage speed, low temperature resistance, etc. Commonly used image storage system in the market cannot meet such requirement. In the paper, real-time image storage system solutions on missile based on FPGA should be proposed. The system mainly consists of acquisition module and memory reading module. The whole system adopts FPGA as main control chip for mainly completing real-time decoding and acquisition on one path of PAL format video images, reading and writing of NandFlash chipset, erasure, bad block management and so on. The solution has passed various environmental tests with stable performance, large data storage capacity and easy expansion, which has been used in engineering practice.


2014 ◽  
Vol 651-653 ◽  
pp. 2296-2300
Author(s):  
Jing Huang ◽  
She Yu Zhou ◽  
Bing Lei Guan

Based on the theory of ultrasonic testing, an online data-acquisition and storage system is designed. The design scheme of hardware and software of the system is introduced in this paper, in which the embedded processor DSP and FPGA is used as its control core and the interface of PCI bus and DSP is designed. Thus a high speed and large-capacity ultrasonic signal can be processed, furthermore the pipelines defects can be analyze and evaluate.


Sign in / Sign up

Export Citation Format

Share Document