P-BN48 Utilising spatial geometry to obtain the ideal needle mount for laparoscopic intracorporeal suturing

Background Intracorporeal suturing is an essential component of any advanced laparoscopic procedure like fundoplication, bypass surgery or common bile duct exploration. Obtaining the appropriate needle mount during suturing can be challenging. Spatial geometry defines points in three-dimensional space. Ergonomics in laparoscopic surgery identifies a manipulation angle of 60o to target as being optimal. This knowledge, in combination with the principles of light reflection can be used to understand needle orientation in laparoscopic suturing. Methods An experiment was designed on a laparoscopic trainer with three participants. Using the principles of spatial geometry and light reflection, four different points were identified on an angle chart and labelled for a right-hand dominant participant as; centre, right off-centre (5.5cm), right lateral (10 cm) and left off-centre (5.5cm). Each participant was instructed to mount the needle at the defined points using light reflection on the needle shaft as a reference guide. Three readings were taken for each position. Mounted angle was defined as the angle between the shaft of needle holder and long axis of the needle. This was measured using a special application and an average value determined for each position. Results The average values for the mounted angle measurements for each spatial position were: Centre(112o), Right off centre(101o), Right lateral (88.8o) and Left off centre (124.6o). Conclusions This study describes a novel and reproducible technique to obtain an ideal needle mount. For a needle mount greater than 100o either the centre position or the left off-centre position should be considered.

Ultrasonographic percutaneous nephrolithotomy, with or without ureteral catheter

Introduction: Access by ultrasonography rather than fluoroscopy in addition to reducing radiation exposure to the patient and staff, is safe and effective. Access by ultrasonography is bi-planar and real-time compared to fluoroscopy, because it provides fewer side effects and more stone free rate. Objectives: To study the complications and outcome of PCNL (percutaneous nephrolithotomy) with or without using ureteral catheter. Patients and Methods: We studied 59 patients with at least 2 cm diameter of renal stone from January to December of 2018. After general anesthesia, 35 patients in the ureteral stent group were prepared in bladder lithotomy position. Then 5-French (Fr) ureteral catheters were introduced endoscopically in stone affected side and fixed to 16 Fr urethral Foley catheters in the patients. Other 24 patients in the non-stent group following anesthesia were directed to prone position instantly. In all of the patients, ultrasonography was performed in posterior auxiliary line below the ribs in prone position. Retrograde instillation of normal saline was performed through ureteral catheter in stent-group. Then we inserted 18G Chiba needle to desired calyx without needle holder guidance in all patients. Our approach according to probe was transverse. Results: Our patients comprised of 24 men and 35 women aged 24 to 66 years. Thirteen of them had no hydronephrosis and their stone sizes ranged from 21 mm to 65 mm. Patients in the ureteral stent group were more obese compared to the non-stent group (P=0.02) in addition to significantly more operation time (P=0.03). However hydronephrosis was not significantly different between groups (P=0.3). Postoperative residual stone rate, hospital stay days and complications (Fever, blood transfusion) were the same between both groups. Only urinary leak was more common in the non-stent group (P=0.04) Conclusion: Ultra-sonographic-PCNL without inserting ureteral catheter before surgery is conceivable especially in patients with lower body mass index (BMI). Advantages and complications are same in ureteral stent and non-stent patients except urinary leak that is more common in non-stent patients.

Effect of three different needle holders on gastrointestinal anastomosis construction time and bursting pressure in equine jejunal segments

Background Equine small intestinal resection and anastomosis is a procedure where optimizing speed, without compromising integrity, is advantageous. There are a range of different needle holders available, but little is published on the impact surgical instrumentation has on surgical technique in veterinary medicine. The objectives of this study were to investigate if the needle holder type influences the anastomosis construction time, the anastomosis bursting pressure and whether the bursting pressure is influenced by the anastomosis construction time. Single layer end-to-end jejunojejunal anastomoses were performed on jejunal segments harvested from equine cadavers. These segments were randomly allocated to four groups. Three groups based on the needle holder type that was used: 16.5 cm Frimand (Group 1), 16 cm Mayo-Hegar (Group 2) or 20.5 cm Mayo-Hegar (Group 3) needle holders. One (Group 4) as control without anastomoses. Anastomosis construction time was recorded. Bursting pressure was determined by pumping green coloured fluid progressively into the lumen whilst recording intraluminal pressures. Maximum pressure reached prior to failure was recorded as bursting pressure. Construction times and bursting pressures were compared between needle holder, and the correlation between bursting pressure and construction time was estimated. Results Construction times were not statistically different between groups (P = 0.784). Segments from Group 2 and Group 3 burst at a statistically significantly lower pressure than those from Group 4; P = 0.031 and P = 0.001 respectively. Group 4 and Group 1 were not different (P = 0.125). The mean bursting pressure was highest in Group 4 (189 ± 61.9 mmHg), followed by Group 1 (166 ± 31 mmHg) and Group 2 (156 ± 42 mmHg), with Group 3 (139 ± 34 mmHg) having the lowest mean bursting pressure. Anastomosis construction time and bursting pressure were not correlated (P = 0.792). Conclusions The tested needle holders had a significant effect on bursting pressure, but not on anastomosis construction time. In an experimental setting, the Frimand needle holder produced anastomoses with higher bursting pressures. Further studies are required to determine clinical implications.

Trans-urethral bladder suture in female patients: Not a tour de force but a quick and realistic answer to complex situations

Introduction: Trans-urethral bladder surgery has gained popularity in the fields of electro-resection and laser lithotripsy, with endoscopic suturing being overlooked. Bladder defect closure using a pure trans-urethral suturing technique can provide a quick and effective solution in situations where conventional management options are not feasible. Methods: Here we describe this innovative novel technique developed by our group that was used to treat two different cases with bladder perforation at two different institutions. We used a 5 mm laparoscopic port with gas insufflation and a laparoscopic needle holder trans-urethrally to achieve defect closure with a monofilament 2/0 monocryl mattress suture on a small 22 mm needle. Results: The defects were successfully closed without any intraoperative complications. Average operative time for the technique was 18 min with minimal blood loss. Bladder closure was sustained at a median follow-up of 2 years for one of these cases. Conclusions: We claim that transurethral bladder suturing is quick, safe in expert hands and provides an effective option where the clinical condition/situation of the patient warrants a minimally invasive surgery approach.

A Novel Mixed Reality Solution Based on Learning Environment for Sutures in Minor Surgery

Minor Surgery Sutures is a fundamental skill for healthcare professionals. However, in the educational field, the practice of suturing is sometimes limited and reduced, with more theoretical than practical study. In order to facilitate learning, our goal is to develop an immersive and interactive educational tool that complements theoretical study, called Suture MR. This application could enhance suture procedural skills in the fields of nursing and medicine. Applying Mixed Reality techniques, we generate a 3D model of an arm with a full-scale wound. Realistically, the user will simulate the suture movements as part of the learning process. The application has surgical clamps and a needle holder that are virtually visualized in the user’s hands, allowing gestures and movements faithful to the real ones. In this article, we want to demonstrate the usability of our environment and the feasibility of using Mixed Reality learning experiences in clinical practical training as a complement to theoretical training. The results of the study reveal a greater perception of learning and the willingness of students to use this methodology.

Laparoscopic removal of an aberrant acupuncture needle in the gluteus that reached the pelvic cavity: a case report

Background Intrapelvic aberrant needles are rare in clinical practice. Long-term foreign bodies in the abdominal cavity may form granulation tissue or an abscess, and may cause organ injury. Therefore, such foreign bodies need prompt removal. Case presentation A 26-year-old male athlete was referred to our hospital for investigation of an aberrant acupuncture needle in the gluteus. The needle was unable to be removed during acupuncture treatment, and the end broke off and remained in the gluteus. Abdominal X-ray examination showed a thin, 40-mm-long, metallic foreign body resembling an acupuncture needle. Abdominal computed tomography showed an abnormal shadow in the gluteus. However, it was unclear whether the tip of the needle reached the pelvic cavity. Thus, it was decided to surgically extract the needle via laparoscopic surgery under X-ray guidance as a safe and minimally invasive method. Although X-ray fluoroscopy confirmed that the aberrant needle was located in the gluteus, the needle could not be felt with the forceps, as the peritoneum surrounding the needle had granulomatous changes due to inflammation. Therefore, the retroperitoneum was further dissected to search for the needle. Once the needle was identified, its flexibility enabled it to be easily removed by grasping it directly with a needle holder. The length of the aberrant needle was 40 mm. The postoperative course was uneventful, and the patient was discharged from hospital on postoperative day 2. Conclusions When a foreign body remains in the gluteus and its tip touches intrapelvic organs, such as the rectum, it is critical to determine the best approach for its safe removal. Given the anatomical location of the foreign body and the patient background, laparoscopic removal was considered the best approach in the present case.