lamb wave
Recently Published Documents


TOTAL DOCUMENTS

2075
(FIVE YEARS 399)

H-INDEX

62
(FIVE YEARS 8)

2022 ◽  
Vol 166 ◽  
pp. 108462
Author(s):  
Zhi-Bo Yang ◽  
Ming-Feng Zhu ◽  
Yan-Feng Lang ◽  
Xue-Feng Chen
Keyword(s):  

2022 ◽  
Vol 187 ◽  
pp. 108480
Author(s):  
Zhe Wang ◽  
Shen Wang ◽  
Qing Wang ◽  
Zaifu Zhan ◽  
Wei Zhao ◽  
...  

2022 ◽  
Vol 164 ◽  
pp. 108242
Author(s):  
Caibin Xu ◽  
Jishuo Wang ◽  
Shenxin Yin ◽  
Mingxi Deng

2022 ◽  
Vol 12 (2) ◽  
pp. 849
Author(s):  
Rymantas Jonas Kazys ◽  
Justina Sestoke ◽  
Egidijus Zukauskas

Ultrasonic-guided waves are widely used for the non-destructive testing and material characterization of plates and thin films. In the case of thin plastic polyvinyl chloride (PVC), films up to 3.2 MHz with only two Lamb wave modes, antisymmetrical A0 and symmetrical S0, may propagate. At frequencies lower that 240 kHz, the velocity of the A0 mode becomes slower than the ultrasonic velocity in air which makes excitation and reception of such mode complicated. For excitation of both modes, we propose instead a single air-coupled ultrasonic transducer to use linear air-coupled arrays, which can be electronically readjusted to optimally excite and receive the A0 and S0 guided wave modes. The objective of this article was the numerical investigation of feasibility to excite different types of ultrasonic-guided waves, such as S0 and A0 modes in thin plastic films with the same electronically readjusted linear phased array. Three-dimensional and two-dimensional simulations of A0 and S0 Lamb wave modes using a single ultrasonic transducer and a linear phased array were performed. The obtained results clearly demonstrate feasibility to excite efficiently different guided wave modes in thin plastic films with readjusted phased array.


Micromachines ◽  
2022 ◽  
Vol 13 (1) ◽  
pp. 87
Author(s):  
Tiancheng Luo ◽  
Yan Liu ◽  
Yang Zou ◽  
Jie Zhou ◽  
Wenjuan Liu ◽  
...  

Radio frequency (RF) filters with multiple passbands can meet the needs of miniaturization and integration for 5G communications. This paper reports a dual-mode Lamb wave resonator (DLWR) and a dual-passband filter based on DLWRs. The DLWR consists of a piezoelectric film and two interdigital electrode (IDT) arrays with different thicknesses, which leads to the coexistence of two main modes in the resonator. The resonance frequencies of the two modes can be adjusted separately by changing the thicknesses of the IDTs, which greatly satisfies the requirements of the dual-passband filter. Four DLWRs with different electrode configurations are designed, and the influences of the periodic length and thicknesses of the IDTs on the performance of the DLWR are studied. When the thickness of the piezoelectric layer is 0.75 μm and the two thicknesses of the IDTs are 0.1 μm and 0.3 μm, the resonance frequency of the second main mode is 1.27 GHz higher than the resonance frequency of the first main mode in the DLWR. Furthermore, a dual-passband filter based on the proposed DLWRs is demonstrated with an insertion loss less than 1 dB and a band rejection of about 15 dB. Moreover, two passbands at 2.45 GHz and 3.88 GHz with bandwidths of 66 MHz and 112 MHz, respectively, are achieved. The presented DLWR shows a potential application that can be used to obtain RF filters with adjustable dual passbands.


Author(s):  
Caibin Xu ◽  
Hao Zuo ◽  
Mingxi Deng

Abstract By controlling the excitation time delay on each element, the conventional phased array can physically focus signals transmitted by different elements on a desired point in turn. An alternative and time-saving strategy is that every element takes turns to transmit the excitation and the remaining elements receive the corresponding response signals, which is known as the full matrix capture (FMC) method for data acquisition, and then let the signals virtually focus on every desired point by post-processing technique. In this study, based on the FMC, a dispersive multiple signal classification (MUSIC) algorithm for Lamb wave phased array is developed to locate defects. The virtual time reversal is implemented to back propagate the wave packets corresponding to the desired focusing point and a window function is adopted to adaptively isolate the desired packets from the other components. Then those wave packets are forward propagated to the original focusing point at a constant velocity. For every potential focusing point and all receivers, the virtual array focuses the signals from all transmitters so as to obtain the focusing signals. The MUSIC algorithm with the obtained focusing signals is adopted to achieve Lamb wave imaging. Benefiting from the post-processing operations, the baseline subtraction as well as the estimation for the number of the scattering sources is no longer required in the proposed algorithm. Experiments on an aluminum plate with three artificial defects and a compact circular PZT array are implemented and the results demonstrate the efficacy of the proposed algorithm.


2022 ◽  
Vol 185 ◽  
pp. 108378
Author(s):  
Arash Ebrahiminejad ◽  
Ali Mardanshahi ◽  
Siavash Kazemirad

2022 ◽  
Vol 317 ◽  
pp. 125628
Author(s):  
Zhe Wang ◽  
Songling Huang ◽  
Gongtian Shen ◽  
Shen Wang ◽  
Wei Zhao

Sign in / Sign up

Export Citation Format

Share Document