flight velocity
Recently Published Documents


TOTAL DOCUMENTS

46
(FIVE YEARS 3)

H-INDEX

9
(FIVE YEARS 0)

2021 ◽  
Vol 263 (2) ◽  
pp. 4495-4501
Author(s):  
Incheol Lee

The effect of forward flight on jet noise is difficult to quantify through flyover tests since only the total noise is measured in a full-scale flyover test, and the contribution of the jet noise is difficult and sometimes nearly impossible to identify. Thus, most studies on the flight effect have been carried out through model-scale experiments with a single-stream jet simulator in a free jet facility. In this paper, the effect of forward flight was captured by using an adjusted flight velocity term (αV) to describe jet velocity in a new prediction of coaxial-jet noise. The new jet noise prediction method assumes that there are three components: primary, secondary, and mixed components with no filter functions. The coefficient α is determined by a thorough investigation of the model-scale data gained from an experiment in the anechoic wind tunnel of ONERA. The value of α is 1 for the primary component, 0.5 for the secondary component, and a linear function of the angle for the mixed component. The simple adjustment of the flight velocity successfully embodied the effect of forward flight at all angles, with no separate velocity exponent or an additional term.



2021 ◽  
Vol 11 (11) ◽  
pp. 5109
Author(s):  
Guozhi Li ◽  
Yihua Cao ◽  
Maosheng Wang

This article describes the results of modeling and analysis of a generic internal cargo system using a discretization method of the vector mechanics. The model can be easily incorporated into a tandem helicopter model and is intended for use of simulation and investigating the problems of flight dynamics, control, etc., both in flight operation loading a cargo and flight operation in the process of airdrops. The model is derived by considering the main descriptions of the cargo, including the linear and rotational dynamics, the kinematics, and the forces and moments acting on the helicopter. A simulation method embedded with a numerical trim algorithm is developed for the complete coupling helicopter/cargo nonlinear dynamics system. The simulation application of the model is illustrated, including the case of flight operation loading a cargo by considering three mass configurations of 3000, 4500, and 6000 kg, and the case of flight operation in the process of airdrops at velocities of 0, 40, 80, 120, and 160 knots. Stabilities of the helicopter in the process of airdrops are also analyzed. The major conclusions drawn are: (i) the tandem helicopter has a good attitude maintaining ability in the whole flight velocity envelope when it conducts a flight operation loading a cargo; (ii) in the process of airdrops, the increase in flight velocity will constantly decrease the helicopter pitching attitude and increases the total airdrop time and decreases the backward moving velocity of the cargo, and helicopter flying at a velocity between 80 and 120 knots might be acceptable; (iii) the stabilities of both the longitudinal and lateral periodic modes are continuing to decrease during the backward movement of the cargo.



Author(s):  
Yu-Hsiang Lai ◽  
Jui-Fu Ma ◽  
Jing-Tang Yang

Synopsis We developed a numerical model for four-wing self-propulsion to calculate effectively the flight velocity generated with varied wing motions, which satisfactorily verified biological experiments. Through this self-propulsion model, we analyzed the flight velocity of a damselfly (Matrona cyanoptera) at varied phases. The results show that after phase modulation of the wings, the aerodynamic performance of the forewing (FW) is affected by the incoming flow and an effective angle of attack, whereas that of the hindwing (HW) is dominated by the vortex interaction and induced flow generated by the shed vortex of the FW. Cooperating with the flow interaction, in stable flight, the HW in the lead phase has a larger vertical velocity, whereas the FW in the lead phase has a larger horizontal velocity. Regarding the aerodynamic efficiency, the FW in the lead phase has greater horizontal efficiency, whereas the HW in the lead phase has greater vertical efficiency; the overall efficiency does not vary with the phase. This work interprets that a dragonfly adopts the HW in the lead phase to generate a larger lift, thus supporting the larger body weight, whereas a damselfly adopts the FW in the lead phase to have a greater forward velocity, which can supplement the lack of flapping frequency.



2020 ◽  
Vol 28 (15) ◽  
pp. 21891 ◽  
Author(s):  
Yiyun Li ◽  
Kai Wang ◽  
Rafael Quintero-Torres ◽  
Robert Brick ◽  
Alexei V. Sokolov ◽  
...  


2020 ◽  
Vol 196 ◽  
pp. 104351
Author(s):  
Wenqing Zhu ◽  
Zhixiang Xiao ◽  
Song Fu


2016 ◽  
Vol 26 (1-2) ◽  
pp. 60-70 ◽  
Author(s):  
M. Meyer ◽  
S. Yin ◽  
R. Lupoi
Keyword(s):  


2015 ◽  
Vol 282 (1809) ◽  
pp. 20150483 ◽  
Author(s):  
Tasuku Kitamura ◽  
Michio Imafuku

Batesian mimics that show similar coloration to unpalatable models gain a fitness advantage of reduced predation. Beyond physical similarity, mimics often exhibit behaviour similar to their models, further enhancing their protection against predation by mimicking not only the model's physical appearance but also activity. In butterflies, there is a strong correlation between palatability and flight velocity, but there is only weak correlation between palatability and flight path. Little is known about how Batesian mimics fly. Here, we explored the flight behaviour of four butterfly species/morphs: unpalatable model Pachliopta aristolochiae , mimetic and non-mimetic females of female-limited mimic Papilio polytes , and palatable control Papilio xuthus . We demonstrated that the directional change (DC) generated by wingbeats and the standard deviation of directional change (SDDC) of mimetic females and their models were smaller than those of non-mimetic females and palatable controls. Furthermore, we found no significant difference in flight velocity among all species/morphs. By showing that DC and SDDC of mimetic females resemble those of models, we provide the first evidence for the existence of behavioural mimicry in flight path by a Batesian mimic butterfly.



2015 ◽  
Vol 90 ◽  
pp. 171-180
Author(s):  
Heidi Schwartz ◽  
Christian Prax ◽  
Jean-Philippe Pineau ◽  
Jean-Christophe Valière ◽  
Guy Feuillard


Author(s):  
Ali Akturk ◽  
Cengiz Camcı

This paper describes a novel ducted fan inlet flow conditioning concept that will significantly improve the performance and controllability of ducted fan systems operating at high angle of attack. High angle of attack operation of ducted fans is very common in VTOL (vertical take off and landing) UAV systems. The new concept that will significantly reduce the inlet lip separation related performance penalties in the edgewise/forward flight zone is named DOUBLE DUCTED FAN (DDF). The current concept uses a secondary stationary duct system to control inlet lip separation related momentum deficit at the inlet of the fan rotor occurring at elevated edgewise flight velocities. The DDF is self-adjusting in a wide edgewise flight velocity range and its corrective aerodynamic effect becomes more pronounced with increasing flight velocity due to its inherent design properties. Most axial flow fans are designed for an axial inlet flow with zero or minimal inlet flow distortion. The DDF concept is proven to be an effective way of dealing with inlet flow distortions occurring near the lip section of any axial flow fan system, especially at high angle of attack. In this present paper, a conventional baseline duct without any lip separation control feature is compared to two different double ducted fans named DDF CASE-A and DDF CASE-B via 3D, viscous and turbulent flow computational analysis. Both hover and edgewise flight conditions are considered. Significant relative improvements from DDF CASE-A and DDF CASE-B are in the areas of vertical force (thrust) enhancement, nose-up pitching moment control and recovery of fan through-flow mass flow rate in a wide horizontal flight range.



Sign in / Sign up

Export Citation Format

Share Document