Transient Thrust Analysis of Rigid Rotors in Forward Flight

The purpose of this study was to investigate and quantify the transient thrust response of two small rigid rotors in forward flight. This was accomplished using a distributed doublet-based potential flow method, which was validated against wind-tunnel experimentation and a transient CFD analysis. The investigation showed that for both rotors, advancing and retreating blade effects were predicted to contribute to transient thrust amplitudes of 5–30% of the mean rotor thrust. The thrust output amplitudes of individual rotors blades were observed to be 15–45% of the mean rotor thrust, indicating that it is not uncommon for the thrust output variation of an individual rotor blade to approach the same value as the mean thrust output of the rotor itself. In addition to this, the theoretical analysis also illustrated that higher blade thrust oscillations resulted in pronounced asymmetric rotor wake structures.

Aerodynamic investigation on shifted-back vertical stroke plane of flapping wing in forward flight

In order to properly understand aerodynamic characteristics in a flapping wing in forward flight, additional aerodynamic parameters apart from those in hover—an inclined stroke plane, a shifted-back stroke plane, and an advance ratio—must be comprehended in advance. This paper deals with the aerodynamic characteristics of a flapping wing in a shifted-back vertical stroke plane in freestream. A scaled-up robotic arm in a water towing tank was used to collect time-varying forces of a model flapping wing, and a semi-empirical quasi-steady aerodynamic model, which can decompose the forces into steady, quasi-steady, and unsteady components, was used to estimate the forces of the model flapping wing. It was found that the shifted-back stroke plane left a part of freestream as a non-perpendicular component, giving rise to a time-course change in the aerodynamic forces during the stroke. This also brought out two quasi-steady components (rotational and added-mass forces) apart from the steady one, even the wing moved with a constant stroke velocity. The aerodynamic model underestimated the actual forces of the model flapping wing even it can cover the increasingly distributed angle of attack of the vertical stroke plane with a blade element theory. The locations of the centers of pressure suggested a greater pressure gradient and an elongated leading-edge vortex along a wingspan than that of the estimation, which may explain the higher actual force in forward flight.

Relative rotor phasing for multicopter vibratory load minimisation

This study focuses on vibration reduction for quadcopters and octocopters with elastic, two-bladed, fixed-speed, variable-pitch rotors through the use of relative rotor phasing. The study defines phase modes such as a pitch phase mode with relative phasing between the front and aft rotors, a roll phase mode with relative phasing between the left and right rotors, and a differential phase mode with relative phasing between the clockwise and counter-clockwise spinning rotors for both the quadcopter and the octocopter, as well as additional higher harmonic phase modes for the octocopter. Parametric studies on individual phase modes indicate that, for the quadcopter in forward flight, the pitch and roll phase modes can almost entirely eliminate the 2/rev vibratory forces (at the aircraft level), but the 2/rev vibratory moments cannot be minimised at the same time. By simultaneously using multiple phase modes, a Pareto front can be generated and a solution selected based on the relative emphasis on force or moment vibration reduction. For the octocopter, it was observed that individual higher harmonic modes (specifically the 2c or 2s modes) could almost entirely eliminate both the 2/rev vibratory forces and moments, simultaneously. Compared with vibration levels in forward flight that might, on average, be expected if the rotors were randomly phased, a 62% reduction of a composite vibration index can be achieved on a quadcopter, and complete elimination of vibration was achievable on an octocopter, with appropriate rotor phasing.