size class
Recently Published Documents


TOTAL DOCUMENTS

626
(FIVE YEARS 117)

H-INDEX

41
(FIVE YEARS 5)

2022 ◽  
Vol 80 ◽  
pp. 26-30
Author(s):  
Stella M. Copeland ◽  
Erik P. Hamerlynck ◽  
Corinna M. Holfus ◽  
Emma E. Campbell ◽  
Chad S. Boyd

2021 ◽  
Vol 9 ◽  
Author(s):  
Le Wang ◽  
Dayu Wang ◽  
Alan Cuthbertson ◽  
Deyu Zhong ◽  
Gareth Pender

Differential parametric values associated with bed load sediment transport, that result at the same discharge levels on the rising and falling limbs of a flood hydrograph, are usually defined as bed load hysteresis. This hysteresis in bed load sediment transport rates is of considerable interest in the field of fluvial hydraulics. Within this study, a series of well-defined, symmetrical hydrograph flows are generated over a graded, mobile sediment bed to fully examine the hysteresis of the resulting bed load sediment transport in terms of the threshold of motion, and differential bed load transport rates and bed load yields during the hydrographs. The experiments are conducted in a titling flume without sediment supply specified at the upstream inlet, thereby representing typical river reach conditions immediately downstream of a dam that are exclusively subject to net in-channel bed degradation from sediment transport initiated during flood events. Our results show that the fractional bed load transport of defined fine, medium and coarse size classes within the graded sediment bed generally display clockwise, no/mixed and counter-clockwise hysteresis patterns, respectively, with clockwise hysteresis most commonly found for the coarse size class mobilised by hydrographs with long durations. By contrast, counter-clockwise hysteresis is usually observed for fine size class transported by hydrographs with short durations. Accordingly, the corresponding reference stresses for each size class vary between different hydrographs and are primarily controlled by the hydrograph flashiness (i.e. unsteadiness) and magnitude (i.e. total water work). Moreover, it is shown that the hysteresis effect, particularly for those size classes and hydrograph combinations that result in clockwise and counter-clockwise behaviour, should be fully accounted for when reproducing bed load transport rates using separate-limb based method. Finally, we investigate the relative fractions of the overall bed load yields generated during the rising and falling limbs of all symmetrical hydrographs (i.e. the bed load yield ratio), which are found to be primarily dependent on bed load transport hysteresis. Finally, the relationship between the bed load yield ratio and the ratio of reference stresses for the fractional sediment motion of each size class on both limbs is found to follow a power law.


Author(s):  
Arthertone Jere

Evaluating the food and feeding habits of fish is fundamental in fisheries and conservation biology research. In this study, the diet of exotic Oreochromis niloticus was compared with the 2 most abundant and aquaculture preferred native cichlids of native species (Orochromis macrochir and Coptodon rendalli) in the upper Kabompo River, Zambia. We hypothesized that exotic and native cichlids would show no dietary niche overlap. We analyzed the stomach contents of 114 specimens of the fishes sampled. Fishes were grouped into 3 major feeding groups: microphages, macrophages and carnivores, and omnivores. They were also grouped into size classes of <50, 51−100, 101−150, and 151−302 mm total length (TL). O. niloticus had a larger dietary niche than two native species (71% and 22%, respectively). The dietary niche overlap between O. niloticus and native C. rendalli species in size classes <50 was significant (F (2, 45) = 0.084, p < 0.05). Dietary niche overlap between the native O. macrochir species in size class <50 mm was low (F (2, 33) = 2.13, p > 0.05), while as in size classes 51−100 mm and 101−150 mm was high (F (2, 35) = 0.27, p < 0.05) for C. rendalli. There was no clear evidence of ontogenetic diet shift of native cichlids, with the exception of O. macrochir, which showed ontogenetic diet shifts within the 51−100 mm size class. The dietary overlap results indicate interspecific competition between exotic O. niloticus and native O. macrochir, which may have major impacts on food web structure in the upper Kabompo River and may explain population decreases of some native species.


2021 ◽  
Vol 267 ◽  
pp. 112729
Author(s):  
Kyle J. Turner ◽  
Colleen B. Mouw ◽  
Kimberly J.W. Hyde ◽  
Ryan Morse ◽  
Audrey B. Ciochetto

2021 ◽  
Vol 948 (1) ◽  
pp. 012088
Author(s):  
D Hutapea ◽  
I B Rahardjoa ◽  
M Thamrin

Abstract Synthetic insecticides are still widely used in gardens and greenhouses of ornamental crops to reduce populations of insect pests and preserve flower quality. The improper and unwise use of synthetic insecticides has caused various negative impacts on humans, insect pests, and the environment. Therefore, the quest for unharmed insecticides and environmentally friendly is being sought. The purpose of this study was to examine the effectiveness of botanical insecticide formulation of neem and citronella oil to control long-tailed mealybug Pseudococcus longispinus. Four insecticide concentrations of neem, citronella oil and its mixtures (0.5, 1, 1.5, 2 per cent) were tested for their effectiveness by adding each with Latron at 0.5% as an emulsifier. Bioassays were performed in the laboratory by spraying insecticides on Phalaenopsis leaves infested with P. longispinus groups of one size class, mostly represented by the third instar nymphs. The results revealed that all insecticides tested caused mortality after 24 hours. The combination of neem and citronella in 1.5% provided adequate protection by reducing P. longispinus populations by up to 86%. Thus, botanical insecticides can be recommended as a viable alternative to synthetic insecticides against P. longispinus which infested orchids.


2021 ◽  
Vol 2094 (4) ◽  
pp. 042013
Author(s):  
V A Gron ◽  
N V Medved ◽  
A V Galayko ◽  
M S Gron

Abstract In connection with the involvement in new deposits exploitation, represented by refractory oxidized ores with a fine-dispersed phase and valuable component low content, there have been trends in the processing of this type of raw material. The alluvial gold-bearing sands of Lower Angara region are of practical interest. The results of the material and mineralogical composition of gold-bearing ores made it possible to establish that most rock fragments are quartz-mica schists, which are dilapidated by weathering up to 15% of the sample mass and clay inclusions. Ore by 61.5% is presented with grain size of more than 20 mm. Gold is distributed almost evenly by size class. Basically, gold is found in intergrowths with quartz, mica, pyrite, and clay components. The size of the gold grains ranges from 0.03 to 0.05 mm to several microns. The content of the valuable component was about 3-5%. The result of gravity concentration of the original ores showed the possibility of obtaining gravity concentrates with a metal content of 220-250 g/t, with extraction up to 93-95% and obtaining tailings from 0.3-0.5 g/t, followed by leaching of cyanide and sulfur-alkaline solutions. The extraction of the valuable component into the solution was 80% and 98%, respectively. The results obtained indicate the possibility of processing these types of ores in Lower Angara region.


2021 ◽  
Vol 942 (1) ◽  
pp. 012004
Author(s):  
Z Y Kyaw ◽  
Z A Tiagalieva ◽  
Z O Htet ◽  
K K Phyo

Abstract Copper-zinc pyrite (Sulphide) and polymetallic ores of Russia are complex and difficult to process mineral raw materials. The main technology for the enrichment of this ores are flotation. Currently, the improvement of the flotation technology of this mineral raw materials is carried out in several way. It has been established by the practice of beneficiation of copper-zinc ores that obtaining high-quality zinc and pyrite concentrates is impossible without adding flotation modifiers of sphalerite and pyrite to various flotation operations. This reagent are copper (II) sulfates, zinc and iron (II) sulfates in an alkaline calcareous medium. Therefore, studies on the flotation of sphalerite and pyrite in an alkaline calcareous medium with the addition of one of these metal sulfates to the mineral flotation operation were performed. The effect of each copper (II) sulfates zinc, and iron (II) on the flotability of sphalerite and pyrite was studied during flotation of the mineral and xanthate and dithiophosphate at pH = 8, 10, and 12. The aim of this work was to study the effect of the flotation size class (- 0.074 + 0.044 mm) sphalerite and pyrite of one of the Russian deposits by sulfhydryl collectors in the presence of copper, zinc and iron sulfates in the liquid phase of flotation pulp


2021 ◽  
Author(s):  
Luuk C. M. van Dijk ◽  
Michiel E. de Vries ◽  
Willemien J. M. Lommen ◽  
Paul C. Struik

AbstractTo contribute to the development of a novel cropping system for potato grown from greenhouse-derived seedlings from hybrid true potato seeds, planting density trials were carried out under normal Dutch agronomic conditions. For two consecutive years, 5-week-old seedlings of two experimental genotypes were transplanted into farmers’ potato production fields at two contrasting locations: a flat-bed system on sandy soil and a traditional ridge system on clay soil. Planting densities were 6.25, 12.5, 25, 50, 100 and 200 plants/m2 in the flat-bed system, and 3.125, 4.688, 6.25, 12.5, 25 and 50 plants/m2 in the ridge system. In general, increasing planting density of hybrid seedlings per area decreased tuber fresh weight per plant and reduced the number of tubers per plant. On a per hectare basis, an increased planting density resulted in increased total tuber yield and number of tubers up to very high densities, but finally both parameters levelled off. Highest total tuber yields harvested were 107 and 45 Mg/ha for the flat-bed and ridge system, respectively. On flat-beds, the optimal planting density for total yield was 50 plants/m2. On ridges, planting density interacted with year and genotype, resulting in an optimum planting density of 25 plants/m2 to reach the maximum total yield. Obtained yields in the commercial size classes Baby Baker (20 < size class ≤ 35 mm) and Seed Tubers (28 < size class ≤ 50 mm) were in general very high on the flat-beds, with a maximum Seed Tuber yield of 64 Mg/ha at 50 plants/m2. The current study showed that transplanted hybrid seedlings are feasible alternatives for seed-tuber-grown systems for certain potato outlets.


2021 ◽  
Vol 890 (1) ◽  
pp. 012042
Author(s):  
I A Kadir ◽  
I Taeran ◽  
Z A Harahap

Abstract Pelagic fishery business in Ternate Sea are mainly based on FADs fishing operations. Increase of intensive fishing activities will also increase the pressures on local pelagic fish resources of Ternate Sea in the future. So far, there has been limited scientific information related to the fish caught by local fishers. The aim of the study was to investigate length distribution, gonad maturity level (GML), and catchable size of fishes caught around FADs. The research was conducted in August 2020 in Ternate. The research method was a survey research by collecting samples of fish caught from gill nets and hand lines for total 30 fishing trips. The study results showed that the catch consisted of mackerel scads and yellow scads. The mackerel scads caught by gill nets were between 13-26 cm in size and dominated by the 19-20 cm size class, while fishes sizes caught by hand line were between 14-27 cm which were dominated by the 18-19 cm size class. Yellow scads caught with both gill nets and handlines showed the same length range of 12-23 cm, which was dominated by the size class of 18-19 cm. Mackerel scads caught with gill nets and handlines were dominated by fish in GML II (47%) followed by GML III (32%). GML of yellow scads caught with gill nets was dominated by GML III by 75%, while for fishes caught by hand line the percentage of GML III is 68%. The mackerel scads caught with gill nets and handlines were dominated by the non-catchable size category (100% for gill nets and 98.79% for handlines). On the other hand, all yellow scads caught with both gill nets and handlines are entirely (100%) of catchable size.


Sign in / Sign up

Export Citation Format

Share Document