Advances in chemical methods of crop protection

1950 ◽  
Vol 1 (6) ◽  
pp. 163-167 ◽  
Author(s):  
Hubert Martin

Ideally crop protection should prevent damaging effects of pests, diseases and weeds economically, safely and without harming the environment or inducing subsequent control problems. Present methods, based mainly on pesticides and resistant crop varieties, control many damaging organisms effectively but have important limitations. Vulnerability to the emergence of tolerant strains of pest or pathogen is probably the most severe; chemical methods are also often insufficiently selective and very wasteful. Dependence on these methods will continue, however, and it is therefore essential to seek ways of minimizing their deficiencies. The prospects for improvement are discussed in relation to the need for better intelligence about infestations and their consequences, the need to ensure that control measures remain effective and the need to improve the efficiency of utilization of crop protection agents. Implementation of the suggestions for improvement could require fundamental changes in the organization of crop protection practices.


Agrology ◽  
2021 ◽  
Vol 4 (4) ◽  
pp. 165-173
Author(s):  
Yu. I. Tkalich ◽  
O. I. Тsyliuryk ◽  
Yu. М. Rudakov ◽  
V. I. Kozechko

Loss of soybean yields from weeds can reach 30–50%. Chemical methods of their control are of primary importance for obtaining the maximum grain yield. The critical period for weed control is stage from the first to third true leaf of the crop. The most active growth of unwanted vegetation in soybean crops is observed in the spring-summer period. And if during this period you can mainly suppress weeds, then in the future the crops will be relatively clean. In years when there is a sharp lack of moisture at the beginning of the growing season, a significant part of the plant seedlings appear at a later date, which creates additional problems for crop protection. In order to optimize weed protection measures, it is first necessary to know clearly the species composition of weeds in each specific agrocenosis. The development of highly effective systems of chemical protection of soybean crops against weeds largely depends on the application of highly effective herbicides. The maximum results in the control of weeds, in particular Сommon ragweed, at the time of renewal of spring vegetation, among the preparations used by as were provided by herbicides and their tank mixtures in variants with application of tank mixtures: Harmony: 8–10 g/ha + Command – 0,20–0,25 l/ha + Trend – 300 ml/ha. Here the technical efficiency was at the level of 70,0–72,0%. The increase of technical efficiency in variants with the application of tank mixtures of preparations was determined: Harmony – 8 g/ha + Command – 0,25 l/ha + Trend – 300 ml/ha; Harmony – 10 g/ha + Team – 0,20 l/ha + Trend – 300 ml/ha; Harmony – 10 g/ha + Team – 0,25 l/ha + Trend – 300 ml/ha and Harmony – 8 g/ha + Bazagran – 2,0 l/ha + Trend – 300 ml/ha. Spraying with herbicides and their tank mixtures in general made it possible to save from 0,81 to 1,01 t/ha of soybean grain, compared with the control without herbicides. Herbicide preparations differed slightly regarding the effect on the grain yield. It is necessary to distinguish only tank mixtures: Harmony – 10 g/ha + Commands – 0,20 l/ha + Trend –300 ml/ha; Harmony – 10 g/ha + Team – 0,25 l/ha + Trend – 300 ml/ha; Harmony – 8 g/ha + Bazagran – 2,0 l/ha + + Trend – 300 ml/ha, as well as Harmony – 12 g/ha. The indices of yields on these variants were maximum and amounted to 2,28; 2,31; 2,31 and 2,29 t/ha, which was more than the control by 43, 44, 44 and 43%, respectively.


1992 ◽  
Vol 40 (3) ◽  
pp. 225-238 ◽  
Author(s):  
F.G. Wijnands ◽  
P. Vereijken

In the Netherlands integrated arable farming systems (IFS) are being developed at three regional experimental farms, with region-specific crop rotations and cropping systems. Most pesticide and fertilizer inputs appear to be replaceable by non-chemical methods and organic manure, with economic results similar to conventional systems. The targeted reductions in pesticide use in the Netherlands' Multi-Year Crop Protection Plan for the year 2000 can already clearly be met. Further improvements of the prototype systems are considered. Recently started farming systems research for outdoor horticulture is briefly discussed. (Abstract retrieved from CAB Abstracts by CABI’s permission)


1980 ◽  
Vol 10 (4) ◽  
pp. 206-207 ◽  
Author(s):  
A A Smirnova

The USSR is currently the world's largest producer of raw cotton. Cotton crop protection is based on a system of forecasting and the use of cultural, biological and chemical methods of control as dictated by the situation in the field and prescribed by the USSR Ministry of Agriculture. Alternation of pesticides from different chemical groups during the growing season is important to protect the environment and to avoid or delay the development of resistant pest populations.


Author(s):  
Henry S. Slayter

Electron microscopic methods have been applied increasingly during the past fifteen years, to problems in structural molecular biology. Used in conjunction with physical chemical methods and/or Fourier methods of analysis, they constitute powerful tools for determining sizes, shapes and modes of aggregation of biopolymers with molecular weights greater than 50, 000. However, the application of the e.m. to the determination of very fine structure approaching the limit of instrumental resolving power in biological systems has not been productive, due to various difficulties such as the destructive effects of dehydration, damage to the specimen by the electron beam, and lack of adequate and specific contrast. One of the most satisfactory methods for contrasting individual macromolecules involves the deposition of heavy metal vapor upon the specimen. We have investigated this process, and present here what we believe to be the more important considerations for optimizing it. Results of the application of these methods to several biological systems including muscle proteins, fibrinogen, ribosomes and chromatin will be discussed.


Author(s):  
R. J. Narconis ◽  
G. L. Johnson

Analysis of the constituents of renal and biliary calculi may be of help in the management of patients with calculous disease. Several methods of analysis are available for identifying these constituents. Most common are chemical methods, optical crystallography, x-ray diffraction, and infrared spectroscopy. The application of a SEM with x-ray analysis capabilities should be considered as an additional alternative.A scanning electron microscope equipped with an x-ray “mapping” attachment offers an additional dimension in its ability to locate elemental constituents geographically, and thus, provide a clue in determination of possible metabolic etiology in calculus formation. The ability of this method to give an undisturbed view of adjacent layers of elements in their natural state is of advantage in determining the sequence of formation of subsequent layers of chemical constituents.


Planta Medica ◽  
2016 ◽  
Vol 81 (S 01) ◽  
pp. S1-S381 ◽  
Author(s):  
A Bruguière ◽  
AM Le Ray ◽  
D Bréard ◽  
N Blon ◽  
N Bataillé ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document