Crystal growth and p-type conductivity control of AlGaN for high-efficiency nitride-based UV emitters

2009 ◽  
Vol 6 (12) ◽  
pp. 2621-2625 ◽  
Author(s):  
T. Mori ◽  
K. Nagamatsu ◽  
K. Nonaka ◽  
K. Takeda ◽  
M. Iwaya ◽  
...  
1996 ◽  
Vol 426 ◽  
Author(s):  
M. Altosaar ◽  
E. Mellikov ◽  
J. Hie ◽  
D. Meissner ◽  
T. Varema

AbstractThe recrystallization of CdTe powders in different fluxes was studied and the possibility to grow p- and n - type CdTe monograin powders of high conductivity was shown. It was determined that very important technological factors for creating p - type conductivity in CdTe are the cooling rate and the presence of Te in flux. NaCl content in CdCl2 flux was found to inhibit the crystal growth and to allow for doping CdTe with Na that acts as an effective acceptor impurity in CdTe. The region of most effective added Na concentrations was found.


2014 ◽  
Vol 28 (04) ◽  
pp. 1450028 ◽  
Author(s):  
XIYING MA ◽  
JIE HE ◽  
KANGYE CHEN ◽  
LA LIN

We present a study of the influence of annealing and doping on the electrical properties of few-layer (FL) MoS 2 films on Si and quartz substrates deposited using a self-designed metal sulfide chemical vapor deposition (MSCVD) system. FL MoS 2 slices obtained through MSCVD, in the size range of 50–200 nm, were found to be uniformly scattered on the substrates. The conductivity and mobility of these films are greatly enhanced after annealing at 650–850°C. The largest mobility measured for pure MoS 2 on quartz substrate is 6.4×103 cm 2/ Vs , almost two orders of magnitude larger than that of bulk MoS 2 (500 cm2/Vs). We deduce that the superior charge carrier mobility in our sample is mainly attributed to reduced phonon scattering because of a lower carrier density (1010-1011 cm -2) compared to previously documented values (1012-1013 cm -2). Additionally, the conductivity and carrier concentration of FL MoS 2 films were enhanced by about two orders of magnitude compared to those of the as-grown films doped with Cu , Na and Ag ions but not doped with B ions. The films doped with Na and Ag exhibit characteristic p-type conductivity, while those doped with Cu and B exhibit n-type conductivity. Moreover, the MoS 2/ Si heterojunction exhibited good rectification characteristics and excellent conductivity, indicating that the FL MoS 2 films will find many applications in high-efficiency nanodevices.


1990 ◽  
Vol 198 ◽  
Author(s):  
O. Briot ◽  
T. Cloitre ◽  
N. Tempier ◽  
R. Sauvezon ◽  
M. Averous ◽  
...  

ABSTRACTTogether with the advanced growth technologies of zinc selenide epitaxial films by MOVPE or MBE, severals workers have reported the observation of p-type conductivity in this material. However, there are some inconsistencies in most of the papers reporting such results.We report here the MOVPE crystal growth of nominaly undoped ZnSe/GaAs S.I. layers using alkyls as precursors, and their optical and electrical characterizations. We show the possibility to observe p-type conductivity in ZnSe due to a hole accumulation at the interface in the GaAs side. This is consistent with a simple model taking Into account the conduction and valence bands discontinuities at the ZnSe/GaAs interface.


2021 ◽  
Vol 118 (11) ◽  
pp. 112102
Author(s):  
Wang Fu ◽  
Mingkai Li ◽  
Jiashuai Li ◽  
Guojia Fang ◽  
Pan Ye ◽  
...  

RSC Advances ◽  
2020 ◽  
Vol 10 (9) ◽  
pp. 5134-5145
Author(s):  
Anand Roy ◽  
Anjali Singh ◽  
S. Assa Aravindh ◽  
Swaraj Servottam ◽  
Umesh V. Waghmare ◽  
...  

Mn2+ prefers the Cd-sites having larger number of tightly bounded Cl-ligands. Pure Cd7P4Cl6 exhibits n-type conductivity whereas Cd5.8Mn1.2P4Cl6 exhibits p-type conductivity. The HER activity of Cd7−yMnyP4Cl6 is superior to that of pristine Cd7P4Cl6.


2010 ◽  
Vol 97 (15) ◽  
pp. 153126 ◽  
Author(s):  
G. D. Yuan ◽  
T. W. Ng ◽  
Y. B. Zhou ◽  
F. Wang ◽  
W. J. Zhang ◽  
...  

2009 ◽  
Vol 1165 ◽  
Author(s):  
Vello Valdna ◽  
Maarja Grossberg ◽  
Hiie Jaan ◽  
Urve Kallavus ◽  
Valdek Mikli ◽  
...  

AbstractShort-bandgap group II-VI compound cadmium telluride is widely used for the infrared optics, radiation detectors, and solar cells where p-type CdTe is needed. p-type conductivity of CdTe is mainly caused by the chlorine-based A-centers, and in part, by the less stable copper-oxygen complexes. As a rule, CdTe films are recrystallized by the help of a cadmium chloride flux that saturates CdTe with chlorine. In chlorine-saturated CdTe A-centers are converted to isoelectronic complexes that cause resistivity increasement of CdTe up to 9 orders of magnitude. Excess copper and oxygen or group I elements as sodium also deteriorate the p-type conductivity of CdTe like excess chlorine. p-type conductivity of CdTe can be restored e.g. by the vacuum annealing which removes excess chlorine from the film. Unfortunately, treatment that betters p-type conductivity of the CdTe film degrades the junction of the superstrate configuration cells. In this work we investigate possibilities to prepare p-type CdTe films on the molybdenum coated glass substrates. Samples were prepared by the vacuum evaporation and dynamic recrystallization of 6N purity CdTe on the top of Mo-coated glass substrates. Then samples were recrystallized with cadmium chloride flux under tellurium vapour pressure. Results of the test studies on the structure and electronic parameters of samples are presented and discussed.


2006 ◽  
Vol 910 ◽  
Author(s):  
Qi Wang ◽  
Matt P. Page ◽  
Eugene Iwancizko ◽  
Yueqin Xu ◽  
Yanfa Yan ◽  
...  

AbstractWe have achieved an independently-confirmed 17.8% conversion efficiency in a 1-cm2, p-type, float-zone silicon (FZ-Si) based heterojunction solar cell. Both the front emitter and back contact are hydrogenated amorphous silicon (a-Si:H) deposited by hot-wire chemical vapor deposition (HWCVD). This is the highest reported efficiency for a HWCVD silicon heterojunction (SHJ) solar cell. Two main improvements lead to our most recent increases in efficiency: 1) the use of textured Si wafers, and 2) the application of a-Si:H heterojunctions on both sides of the cell. Despite the use of textured c-Si to increase the short-circuit current, we were able to maintain the same 0.65 V open-circuit voltage as on flat c-Si. This is achieved by coating a-Si:H conformally on the c-Si surfaces, including covering the tips of the anisotropically-etched pyramids. A brief atomic H treatment before emitter deposition is not necessary on the textured wafers, though it was helpful in the flat wafers. It is essential to high efficiency SHJ solar cells that the emitter grows abruptly as amorphous silicon, instead of as microcrystalline or epitaxial Si. The contact on each side of the cell comprises a thin (< 5 nm) low substrate temperature (~100°C) intrinsic a-Si:H layer, followed by a doped layer. Our intrinsic layers are deposited at 0.3-1.2 nm/s. The doped emitter and back-contact layers were deposited at a higher temperature (>200°C) and grown from PH3/SiH4/H2 and B2H6/SiH4/H2 doping gas mixtures, respectively. This combination of low (intrinsic) and high (doped layer) growth temperatures was optimized by lifetime and surface recombination velocity measurements. Our rapid efficiency advance suggests that HWCVD may have advantages over plasma-enhanced (PE) CVD in fabrication of high-efficiency heterojunction c-Si cells; there is no need for process optimization to avoid plasma damage to the delicate, high-quality, Si wafers.


2014 ◽  
Vol 1630 ◽  
Author(s):  
Riccardo Raccis ◽  
Laura Wortmann ◽  
Shaista Ilyas ◽  
Johannes Schläfer ◽  
Andreas Mettenbörger ◽  
...  

ABSTRACTHematite (α-Fe2O3) nanoparticles were diffused of two different shapes (spherical and cubical) in PEDOT:PSS matrices below the percolation threshold. Increases in conductivity within a distinct range in concentration were observed in the dark and under simulated solar illumination. The effect was ascribed to a generalized Poole-Frenkel effect in conjunction with basic properties of heterojunctions and electrostatic dipoles, and verified through data fitting. A difference in behaviour between sphere- and cube-based nanocomposites was also observed.


Sign in / Sign up

Export Citation Format

Share Document