Probabilistic Models of the Functioning of Composite Structures with Thin-Sheet Cladding and Material-Energy-Saving Heat Insulation

Author(s):  
Victor Bobryashov ◽  
Nikolay Bushuev
Coatings ◽  
2020 ◽  
Vol 10 (9) ◽  
pp. 829
Author(s):  
Xian Rong ◽  
Lichao Jiao ◽  
Xiangfei Kong ◽  
Guangpu Yuan

In this article, we mixed hollow glass beads with nano-TiO2 and iron oxide red in a certain proportion to prepare a low-brightness, high-reflective, safe, and durable cooling coating throughout the experiments. The coating is suitable for energy-saving in tropical areas. To discuss the energy saving effects of the coating on an exterior envelope in tropical areas, a comparative analysis for two scenario models of a two-story residential building in Kuala Lumpur, Malaysia was conducted. The results indicated that the heat reflective insulation coating could reduce the exterior envelope surface temperature effectively, and the maximum temperature change was about 6–8 °C. Through calculations, it was found that the annual energy saving rate was 12.9%, which showed that the energy saving effect of the heat insulation coating was obvious in Kuala Lumpur. The brightness of the coating was less than 50%, and its comfort and safety met the requirements.


2012 ◽  
Vol 174-177 ◽  
pp. 988-992
Author(s):  
Shuang Mei Cao

This thesis analyzes the current situation of the heat insulation system of composite wall in China. Through comparison, it points out that heat insulation system is the trend of the development for heat preservation and energy saving, and meanwhile, it gives direction for further research to several different new type heat insulation systems.


2011 ◽  
Vol 314-316 ◽  
pp. 10-16 ◽  
Author(s):  
Ching Mu Chen ◽  
Shen Yuar Chen ◽  
Wei Ching Chuang ◽  
Jen Yu Shieh

This paper proposes capabilities of transparent glass window design with energy-saving and heat insulation for carbon reduction issues. An optical thin film coating technology is used for coating multilayered dielectric materials on the transparent glass to achieve an infrared ray shielding effect; especially to prevent rising temperature easily of indoor room. That is infrared ray incidence from outdoor and the thermal flux effect of the transparent window influent the indoor room temperature. In winter, the outdoor temperature is increased more easily by infrared ray incidence. However, the heat insulation window allows 98% of visible light penetration through the window and also allows 90% of infrared light reflection and roughly 10% of infrared light penetration into indoor.


2011 ◽  
Vol 105-107 ◽  
pp. 922-925 ◽  
Author(s):  
Chao He ◽  
Wei Lin Guo ◽  
Yi Yun Huang

To discuss the effect of energy saving of heat-reflective insulation coating on exterior walls of building, the wall temperature change of two test rooms with heat insulation or not in Hangzhou has been monitored in summer, and the heat flux data of east, south and west walls were analyzed. The results indicate that the temperature of outside wall surface with the heat reflective insulation coating is reduced effectively, and the maximum temperature change was about 9, 10°C. There is a positive proportional between the mean daily air temperature and heat gain that the heat gain increases with the mean daily air temperature. By calculating, the higher the air temperature, the more the cooling effect of coating in summer. But the higher the mean daily temperature do not mean that the more heat gain in summer. The result shows the energy saving effect of the heat insulation coating on building wall was very obvious in summer in Hangzhou.


2013 ◽  
Vol 689 ◽  
pp. 176-179 ◽  
Author(s):  
Jae Sik Kang ◽  
Tae Jung Kim ◽  
Gyeong Seok Choi ◽  
Seung Eon Lee

The purpose of this study is to develop the measurement system for SHGC that has the biggest effect on the cooling energy saving in buildings and prove the validity of the measurement result through the experiment using the device. In this study, solar simulator using artificial light source, external environment chamber that can control the external environmental condition and calorimetric chamber that can measure the amount of irradiance coming indoors by using heat flow meter were developed. In this study, it is considered to be possible to measure the SHGC of high performance glass, shading device, heat insulation film


Author(s):  
Hyungchul Kim ◽  
Junghoon Jang ◽  
Sungkwon Shin ◽  
Yongsub Park ◽  
Sangam Kim ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document