Impact of hybridization on the pollutant emissions behavior of gasoline and diesel vehicles

Author(s):  
Sven Eberts ◽  
Hans-Jürgen Berner ◽  
Michael Bargende
2020 ◽  
Vol 12 (12) ◽  
pp. 4875 ◽  
Author(s):  
José Carlos Curvelo Santana ◽  
Amanda Carvalho Miranda ◽  
Charles Lincoln Kenji Yamamura ◽  
Silvério Catureba da Silva Filho ◽  
Elias Basile Tambourgi ◽  
...  

This study focused on verifying whether the emission of air pollutants in São Paulo increases the costs and number of hospitalizations for respiratory diseases in Brazil. Data on pollutant emissions, hospitalizations, and hospital costs were collected from 2008 to 2017 and correlated with air quality standards. The results showed that the concentration of particulate matter increased each year during the study period and was highly correlated with hospitalizations due to respiratory diseases. Ozone (O3) was within the quality standard throughout the study period but registered an increase in the mean and a positive correlation with hospitalizations due to respiratory diseases. The carbon monoxide (CO), sulfur dioxide (SO2), and nitrogen dioxide (NO2) levels were within the quality standards throughout the study period with a decrease in the last years studied, but showed a positive correlation with hospitalizations due to respiratory diseases. The pollutant emissions and hospitalizations due to respiratory diseases had an inverse relationship with the monthly rainfall curve for São Paulo, which indicates that rainfall tended to reduce pollutant emissions and consequently hospitalizations due to inhalation of these pollutants. Because costs are directly associated with hospitalizations, both increased during the study period—302,000 hospitalizations at an average cost of 368 USD resulted in a total cost of 111 million USD. To reduce these costs, Brazil should implement stricter policies to improve the air quality of its major cities and develop a viable alternative to diesel vehicles.


Author(s):  
Sehee Han ◽  
Seunguk Na ◽  
Nam-Gi Lim

Since the life cycle of a building spans more than 50 years, studies of the environmental impacts in the construction industry have focused on reducing the energy consumption and greenhouse gas emissions during the operation and maintenance phase. The products of the construction industry are assembled using various building materials manufactured outside of the construction site. Consequently, it is essential that the manufactured building materials be transported to the construction site using various types of transportation methods. However, there is a lack of studies that assess the pollutant emissions of road transport while executing a construction project. The purpose of this study is to investigate the changes in the road pollutant emissions when the old diesel vehicles for transporting building materials are replaced according to enhanced pollutant emission regulations. In this study, we found that approximately 89, 64, 77, and 64% of NOx, VOC, PM, and CO, respectively, were emitted during transportation of building materials as a proportion of the emissions during the construction of the structure. The analyzed results also show that about 10, 35, 23, and 35% of NOx, VOC, PM, and CO, respectively, were generated from material transportation as a proportion of the emissions from finishing the work. It is expected that a reduction in pollutant emissions from transporting building materials of up to approximately 64, 39, 49, and 27% of NOx, VOC, PM, and CO, respectively, can be achieved when vehicles registered before 2003 are replaced with ones that adhere to the tightened regulations.


2020 ◽  
pp. 124927 ◽  
Author(s):  
Reyes García-Contreras ◽  
José A. Soriano ◽  
Pablo Fernández-Yáñez ◽  
Luis Sánchez-Rodríguez ◽  
Carmen Mata ◽  
...  

Author(s):  
Serhii Kovbasenko ◽  
Andriy Holyk ◽  
Serhii Hutarevych

The features of an advanced mathematical model of motion of a truck with a diesel engine operating on the diesel and diesel gas cycles are presented in the article. As a result of calculations using the mathematical model, a decrease in total mass emissions as a result of carbon monoxide emissions is observed due to a decrease in emissions of nitrogen oxides and emissions of soot in the diesel gas cycle compared to the diesel cycle. The mathematical model of a motion of a truck on a city driving cycle according to GOST 20306-90 allows to study the fuel-economic, environmental and energy indicators of a diesel and diesel gas vehicle. The results of the calculations on the mathematical model will make it possible to conclude on the feasibility of converting diesel vehicles to using compressed natural gas. Object of the study – the fuel-economic, environmental and energy performance diesel engine that runs on dual fuel system using CNG. Purpose of the study – study of changes in fuel, economic, environmental and energy performance of vehicles with diesel engines operating on diesel and diesel gas cycles, according to urban driving cycle modes. Method of the study – calculations on a mathematical model and comparison of results with road tests. Bench and road tests, results of calculations on the mathematical model of motion of a truck with diesel, working on diesel and diesel gas cycles, show the improvement of environmental performance of diesel vehicles during the converting to compressed natural gas in operation. Improvement of environmental performance is obtained mainly through the reduction of soot emissions and nitrogen oxides emissions from diesel gas cycle operations compared to diesel cycle operations. The results of the article can be used to further develop dual fuel system using CNG. Keywords: diesel engine, diesel gas engine, CNG


1994 ◽  
Author(s):  
Joseph Zelina ◽  
Richard Striebich ◽  
Dilip Ballal

Author(s):  
Naiara Lima Costa ◽  
Ramon Eduardo Pereira Silva ◽  
Letícia Schneider Ferrari

2008 ◽  
Vol 7 (2) ◽  
pp. 103-110
Author(s):  
Mishra Rajeev Kumar ◽  
Pandey Govind ◽  
Manoranjan Parida
Keyword(s):  

2017 ◽  
Vol 16 (4) ◽  
pp. 809-819 ◽  
Author(s):  
Gabriel Lazar ◽  
Iulia Carmen Ciobotici Terryn ◽  
Andreea Cocarcea

2018 ◽  
Author(s):  
Z. Gerald Liu ◽  
Devin R. Berg ◽  
Thaddeus A. Swor ◽  
James J. Schauer‡

Two methods, diesel particulate filter (DPF) and selective catalytic reduction (SCR) systems, for controlling diesel emissions have become widely used, either independently or together, for meeting increasingly stringent emissions regulations world-wide. Each of these systems is designed for the reduction of primary pollutant emissions including particulate matter (PM) for the DPF and nitrogen oxides (NOx) for the SCR. However, there have been growing concerns regarding the secondary reactions that these aftertreatment systems may promote involving unregulated species emissions. This study was performed to gain an understanding of the effects that these aftertreatment systems may have on the emission levels of a wide spectrum of chemical species found in diesel engine exhaust. Samples were extracted using a source dilution sampling system designed to collect exhaust samples representative of real-world emissions. Testing was conducted on a heavy-duty diesel engine with no aftertreatment devices to establish a baseline measurement and also on the same engine equipped first with a DPF system and then a SCR system. Each of the samples was analyzed for a wide variety of chemical species, including elemental and organic carbon, metals, ions, n-alkanes, aldehydes, and polycyclic aromatic hydrocarbons, in addition to the primary pollutants, due to the potential risks they pose to the environment and public health. The results show that the DPF and SCR systems were capable of substantially reducing PM and NOx emissions, respectively. Further, each of the systems significantly reduced the emission levels of the unregulated chemical species, while the notable formation of new chemical species was not observed. It is expected that a combination of the two systems in some future engine applications would reduce both primary and secondary emissions significantly.


Sign in / Sign up

Export Citation Format

Share Document