Drying characteristics of persimmon, cv. “Rojo Brillante”, slabs were experimentally determined in a hot air convective drier at drying temperatures of 45, 50, 55, 60, and 65 °C at a fixed air velocity of 2.3 m/s. It was observed that the drying temperature affected the drying time, shrinkage, and colour. Four empirical mathematical models namely, Enderson and Pabis, Page, Logarithmic, and Two term, were evaluated in order to deeply understand the drying process (moisture ratio). The Page model described the best representation of the experimental drying data at all investigated temperatures (45, 50, 55, 60, 65 °C). According to the evaluation of the shrinkage models, the Quadratic model provided the best representation of the volumetric shrinkage of persimmons as a function of moisture content. Overall, higher drying temperature (65 °C) improved the colour retention of dried persimmon slabs.
In order to solve the drying problems in the deep-processing of pepper, peppers were dried through blanching pre-treatment and hot-air drying process. Orthogonal test designs were carried out to investigate factors influencing the quality and moisture content of pepper. The results showed that the whole drying process was a reduction speed drying, hot-air temperature and wind speed have significantly affected on the drying rate of pepper, but the impact of hot-air temperature was more prominent than wind speed; hot-air temperature was found to be the primary parameter to affect the quality of the pepper, wind speed was the secondary one and followed by packing thickness; drying time was found to be the primary parameter to affect the moisture content of the pepper in the drying process, the best drying conditions were as follows: wind temperature was 80°C, wind speed was 10 m/s, packing thickness was 80 cm, drying time was 12 h after 100°C steam blanching pre-treatment
Abstract
Moisture content and carotenoid content are important indicators for evaluating the drying process of carrot slices. There are growing attention to develop non-destructive methods as effectively analytical tools in quality assurance of drying carrot slices. In this study, the characteristic wavelengths of moisture and carotenoid content in carrot slices during hot air drying were extracted based on hyperspectral imaging technology. A multispectral imaging equipment was built after that, and the wavelengths of filters were determined according to the characteristic wavelengths. Based on the successive projection algorithm (SPA), the optimal wavelengths of moisture and carotenoid content were further determined, and prediction models of both were established based on the system. There were 12 filters selected in this study. The results showed that a support vector machine (SVM) prediction model for moisture content was established based on seven optimal wavelengths with 0.991 for the coefficient of determination of prediction set (R
2
p
) and 10.318 for the residual prediction residual (RPD). Based on eight optimal wavelengths, a SVM prediction model for carotenoid content was also established with 0.968 for R
2
p
and 5.337 for RPD. The prediction performance is close to or even better than that based on hyperspectral. The study confirmed the feasibility of using the multispectral imaging equipment to measure the moisture and carotenoid content of carrot slices during drying based on selected wavelengths, laying a foundation for the further preparation of a portable multispectral detector for the quality of dry products.
Dried vegetables are considered convenient for storage, transportation and preservation. The different drying techniques could influence the quality of resulting products. This study aimed to evaluate the effects of three distinguish drying methods as hot-air drying, foam-mat drying and microwave drying on the color retention and chlorophyll of green vegetables powder. Fresh spinach(Spinacia oleraceaL.), celery (Apium graveolensL.), Malabar spinach (Basella albaL.) were dried by different methods: hot air at 60oC, foam-mat at 60oC and microwave at 270 W until the samples reached approximately 9% of moisture content (wb). The drying time of the dried samples by microwave, foam-mat and hot-air method were 60, 210 and 240 min, respectively. Foam-mat dried vegetables were found to have the best quality in terms of color and the residual chlorophyll content. The findings suggest that foam-mat drying is promising in dried vegetable processing
In this study, freeze vacuum drying (FVD), hot air drying (AD), and FVD combined with AD (FVD-AD) were used to dry kiwifruits. Dried products were analyzed comprehensively on their sensory quality, active components, moisture mobility, odors, and microstructure. Results showed that the FVD-AD saved time by 38.22% compared with FVD while maintaining an acceptable product quality. The antioxidant properties of FVD-AD were lower than those of FVD but significantly higher than those of AD. Moreover, compared with FVD products, FVD-AD products were moderately hard (5252.71 ± 33.53 g) and improved in color, bound water, and microstructure. Additionally, FVD-AD consumed lesser drying time and energy than FD. According to cluster analysis, the odors of FVD-AD products were similar to those of the fresh ones. Principal component analysis of physicochemical and drying cost indicated that FVD-AD was a promising processing technique for functional kiwifruit snacks.
In this study, the effects of two drying methods: hot-air and freeze drying for Thai green curry paste in a terms of drying time and qualities have been investigated. The hot-air drying was carried out in tray dryer at temperature of 50, 60 and 70 °C. The freeze drying was carried out in freeze dryer at freezing temperature of -20°C, primary drying temperature of -10°C and secondary drying temperature of 50°C. Moisture content, water activity, colour, bulk density, and total phenolic content (TPC) were determined in samples. Freeze dried sample had significantly (p<0.05) lower moisture content, water activity, bulk density, total colour difference and browning index than hot air dried samples. For antioxidant activity, the results showed hot-air drying at 70°C effected highest TPC similar to freeze drying.
AbstractThe aim of this study is to find a better drying method to replace conventional hot air drying (HAD) in terms of faster, energy efficient and better product quality. Two alternative drying techniques, microwave combined with hot air drying (MHD) and microwave vacuum drying (MVD), are compared in this study to dry peeled and destoned longan fruit. Both MHD and MVD reduced the drying time up to 48 % and energy consumption as compared to HAD. These techniques provided lower product redness, yellowness and shrinkage but higher lightness and porous structure as compared to HAD. MVD reduced hardness and toughness of the dried product. MHD provided the highest preference score in terms of colour and shape and was as acceptable as the commercial product dried by HAD. MHD is the most suitable method for longan drying.
In this work the authors have studied the effect of hot-air drying with or without a previous osmotic dehydration pretreatment to produce dried cut persimmon with a different geometry (slices and sectors). A kinetic study has been carried out analysing mass variation, colour and texture changes in samples. Two sensory analyses were also performed considering drying time and geometry. Furthermore, the influence of 35 days of storage on optical and mechanical properties was also determined. The results obtained showed that geometry did not affect the parameters analyzed. According to the results of the kinetic study, the selected drying times were 8 and 12 hours. Osmotic pretreatment does not imply improvements in the final product. Judges preferred slices dried for 8 hours without osmotic pretreatment. The time of storage did not influence the optical and mechanical properties.
Influence of Different Hot Air Drying Temperatures on Drying Kinetics, Shrinkage, and Colour of Persimmon Slices