Homogenization and Multiscaling of Granular Media for Different Microscopic Constraints

2010 ◽  
pp. 155-177 ◽  
Author(s):  
C. Miehe ◽  
J. Dettmar ◽  
D. Zäh
Keyword(s):  
Granular Media

Role of contact couples and couple stress in the behaviour of granular media

1998 ◽  
Vol 08 (PR8) ◽  
pp. Pr8-87-Pr8-94
Author(s):  
F. Dedecker ◽  
Ph. Dubujet ◽  
B. Cambou
Keyword(s):  
Couple Stress ◽  
Granular Media

Avalanche Stratification - Experimental Tests of the “Metastable Wedge” and “Continuous Flow” Models

2000 ◽  
Vol 627 ◽  
Author(s):  
M. E. Swanson ◽  
M. Landreman ◽  
J. Michel ◽  
J. Kakalios
Keyword(s):  
Continuous Flow ◽  
Granular Media ◽  
Experimental Tests ◽  
Coarse Sand ◽  
Angle Of Repose ◽  
Flow Models ◽  
Maximum Angle ◽  
Stratification Effect ◽  
Upward Moving ◽  
Moving Layer

ABSTRACTWhen an initially homogeneous binary mixture of granular media such as fine and coarse sand is poured near the closed edge of a “quasi-two-dimensional” Hele-Shaw cell consisting of two vertical transparent plates held a narrow distance apart, the mixture spontaneously forms alternating segregated layers. Experimental measurements of this stratification effect are reported in order to determine which model, one which suggests that segregation only occurs when the granular material contained within a metastable heap between the critical and maximum angle of repose avalanches down the free surface, or one for which the segregation results from smaller particles becoming trapped in the top surface and being removed from the moving layer during continuous flow. The result reported here indicate that the Metastable Wedge model provides a natural explanation for the initial mixed zone which precedes the formation of the layers, while the Continuous Flow model explains the observed upward moving kink of segregated material for higher granular flux rates, and that both mechansims are necessary in order to understand the observed pairing of segregated layersfor intermediate flow rates and cell separations.

Stress fields in granular material and implications for performance of robot locomotion over granular media

2015 ◽  
Vol 8 (1) ◽  
pp. 2005-2009
Author(s):  
Diandong Ren ◽  
Lance M. Leslie ◽  
Congbin Fu
Keyword(s):  
Mechanical Properties ◽  
Granular Material ◽  
Granular Media ◽  
Rotation Frequency ◽  
Legged Locomotion ◽  
Working Environment ◽  
Navier Stokes ◽  
Maximum Speed ◽  
Sigmoid Curve ◽  
Multi Body

 Legged locomotion of robots has advantages in reducing payload in contexts such as travel over deserts or in planet surfaces. A recent study (Li et al. 2013) partially addresses this issue by examining legged locomotion over granular media (GM). However, they miss one extremely significant fact. When the robot’s wheels (legs) run over GM, the granules are set into motion. Hence, unlike the study of Li et al. (2013), the viscosity of the GM must be included to simulate the kinematic energy loss in striking and passing through the GM. Here the locomotion in their experiments is re-examined using an advanced Navier-Stokes framework with a parameterized granular viscosity. It is found that the performance efficiency of a robot, measured by the maximum speed attainable, follows a six-parameter sigmoid curve when plotted against rotating frequency. A correct scaling for the turning point of the sigmoid curve involves the footprint size, rotation frequency and weight of the robot. Our proposed granular response to a load, or the ‘influencing domain’ concept points out that there is no hydrostatic balance within granular material. The balance is a synergic action of multi-body solids. A solid (of whatever density) may stay in equilibrium at an arbitrary depth inside the GM. It is shown that there exists only a minimum set-in depth and there is no maximum or optimal depth. The set-in depth of a moving robot is a combination of its weight, footprint, thrusting/stroking frequency, surface property of the legs against GM with which it has direct contact, and internal mechanical properties of the GM. If the vehicle’s working environment is known, the wheel-granular interaction and the granular mechanical properties can be grouped together. The unitless combination of the other three can form invariants to scale the performance of various designs of wheels/legs. Wider wheel/leg widths increase the maximum achievable speed if all other parameters are unchanged.

β-Cyclodextrin Polymers on Microcrystalline Cellulose as a Granular Media for Organic Micropollutant Removal from Water

2018 ◽  
Author(s):  
Diego Alzate-Sanchez ◽  
Yuhan Ling ◽  
Chenjun Li ◽  
Benjamin Frank ◽  
Reiner Bleher ◽  
...  
Keyword(s):  
Microcrystalline Cellulose ◽  
Continuous Flow ◽  
Granular Media ◽  
Anaerobic Biodegradation ◽  
Thin Coating ◽  
Micropollutant Removal ◽  
Cyclodextrin Polymers ◽  
Flow Experiments ◽  
Aerobic And Anaerobic ◽  
Cellulose Composite

This manuscript describes cyclodextrin polymers formed as a thin coating on microcrystalline cellulose. The resulting polymer/cellulose composite shows promising performance for removing organic pollutants from water and can be packed into columns for continuous-flow experiments. The polymer/cellulose composite also shows excellent resistance to aerobic and anaerobic biodegradation.

Analysis of process of emulsions transport in hydrophilic/oleophilic granular porous media driven by capillary force

2018 ◽  
Vol 2 (21) ◽  
pp. 85-101
Author(s):  
Olga Shtyka ◽  
Łukasz Przybysz ◽  
Mariola Błaszczyk ◽  
Jerzy P. Sęk
Keyword(s):  
Porous Media ◽  
Experimental Research ◽  
Granular Media ◽  
Single Phase ◽  
Influential Factor ◽  
Dispersed Phase ◽  
Porous Structures ◽  
Phase Concentration ◽  
Granular Porous Media ◽  
Kinetics Of

The research focuses on the issues concerning a process of multiphase liquids transport in granular porous media driven by the capillary pressure. The current publication is meant to introduce the results of experimental research conducted to evaluate the kinetics of the imbibition and emulsions behavior inside the porous structures. Moreover, the influence of the dispersed phase concentration and granular media structure on the mentioned process was considered. The medium imbibition with emulsifier-stabilized emulsions composed of oil as the dispersed phase in concentrations of 10 vol%, 30 vol%, and 50 vol%, was investigated. The porous media consisted of oleophilic/hydrophilic beads with a fraction of 200–300 and 600–800 μm. The experimental results provided that the emulsions imbibition in such media depended stronger on its structure compare to single-phase liquids. The increase of the dispersed phase concentration caused an insignificant mass decreasing of the imbibed emulsions and height of its penetration in a sorptive medium. The concentrations of the imbibed dispersions exceeded their initial values, but reduced with permeants front raise in the granular structures that can be defined as the influential factor for wicking process kinetics.

Root Growth in 2D Wet Granular Media Modified by Intrusions

2013 ◽  
Vol 10 (1) ◽  
pp. 0
Author(s):  
Remi Dreyfus
Keyword(s):  
Root Growth ◽  
Granular Media

Tunnel excavation in granular media: the role of force chains

2021 ◽  
Vol 23 (4) ◽  
Author(s):  
Raj Kumar Pal ◽  
Robert Buraque de Macedo ◽  
José E Andrade
Keyword(s):  
Granular Media ◽  
Force Chains ◽  
Tunnel Excavation

scholarly journals Waterfall Algorithm as a tool of investigation the geometrical features of granular porous media

2021 ◽  
Author(s):  
Wojciech Sobieski
Keyword(s):  
Particle Size ◽  
Porous Media ◽  
Lattice Boltzmann ◽  
Granular Media ◽  
Density Ratio ◽  
Geometrical Features ◽  
Granular Porous Media ◽  
Collision Density ◽  
Boltzmann Method ◽  
The Impact

AbstractThe paper describes the so-called Waterfall Algorithm, which may be used to calculate a set of parameters characterising the spatial structure of granular porous media, such as shift ratio, collision density ratio, consolidation ratio, path length and minimum tortuosity. The study is performed for 1800 different two-dimensional random pore structures. In each geometry, 100 individual paths are calculated. The impact of porosity and the particle size on the above-mentioned parameters is investigated. It was stated in the paper, that the minimum tortuosity calculated by the Waterfall Algorithm cannot be used directly as a representative tortuosity of pore channels in the Kozeny or the Carman meaning. However, it may be used indirect by making the assumption that a unambiguous relationship between the representative tortuosity and the minimum tortuosity exists. It was also stated, that the new parameters defined in the present study are sensitive on the porosity and the particle size and may be therefore applied as indicators of the geometry structure of granular media. The Waterfall Algorithm is compared with other methods of determining the tortuosity: A-Star Algorithm, Path Searching Algorithm, Random Walk technique, Path Tracking Method and the methodology of calculating the hydraulic tortuosity based on the Lattice Boltzmann Method. A very short calculation time is the main advantage of the Waterfall Algorithm, what meant, that it may be applied in a very large granular porous media.

scholarly journals Propulsion by reciprocal motion into granular media

2021 ◽  
Vol 6 (3) ◽  
Author(s):  
Baptiste Darbois Texier ◽  
Alejandro Ibarra ◽  
Francisco Melo
Keyword(s):  
Granular Media

scholarly journals Under pressure: Hydrogel swelling in a granular medium

2021 ◽  
Vol 7 (7) ◽  
pp. eabd2711
Author(s):  
Jean-François Louf ◽  
Nancy B. Lu ◽  
Margaret G. O’Connell ◽  
H. Jeremy Cho ◽  
Sujit S. Datta
Keyword(s):  
Oil Recovery ◽  
Granular Medium ◽  
Granular Media ◽  
Three Dimensional ◽  
Osmotic Swelling ◽  
Widespread Adoption ◽  
Dry Soil ◽  
Hydrogel Swelling

Hydrogels hold promise in agriculture as reservoirs of water in dry soil, potentially alleviating the burden of irrigation. However, confinement in soil can markedly reduce the ability of hydrogels to absorb water and swell, limiting their widespread adoption. Unfortunately, the underlying reason remains unknown. By directly visualizing the swelling of hydrogels confined in three-dimensional granular media, we demonstrate that the extent of hydrogel swelling is determined by the competition between the force exerted by the hydrogel due to osmotic swelling and the confining force transmitted by the surrounding grains. Furthermore, the medium can itself be restructured by hydrogel swelling, as set by the balance between the osmotic swelling force, the confining force, and intergrain friction. Together, our results provide quantitative principles to predict how hydrogels behave in confinement, potentially improving their use in agriculture as well as informing other applications such as oil recovery, construction, mechanobiology, and filtration.

Sign in / Sign up

Export Citation Format

Share Document