Conventional DMTL Phase Shifter is Designed Without Meta-material and with Meta-material

2017 ◽  
pp. 21-32
Author(s):  
V. Singh ◽  
G. Anitha ◽  
K. Usha Kiran
Keyword(s):  
Phase Shifter

An L-Band 4-Bit RL/RC-Switched Active Phase Shifter Using Differential Switches

2009 ◽  
Vol E92-C (9) ◽  
pp. 1170-1175 ◽  
Author(s):  
Kenji NAKAMURA ◽  
Yasushi ITOH
Keyword(s):  
Phase Shifter ◽  
Active Phase ◽  
L Band ◽  
Active Phase Shifter

An Improved Design for Ka-Band Phase Shifter Using Distributed MEMS Transmission Line Structure

PIERS Online ◽  
2005 ◽  
Vol 1 (5) ◽  
pp. 594-597 ◽  
Author(s):  
Boshi Jin ◽  
Haoyuan She ◽  
Yuemei Qin ◽  
Jiahui Fu ◽  
Qun Wu ◽  
...  
Keyword(s):  
Transmission Line ◽  
Phase Shifter ◽  
Ka Band ◽  
Line Structure ◽  
Improved Design

Analysis of Optimum Precoding schemes in Millimeter Wave System

2020 ◽  
Vol 13 ◽  
Author(s):  
Divya Singh ◽  
Aasheesh Shukla
Keyword(s):  
Power Consumption ◽  
Millimeter Wave ◽  
Spectral Efficiency ◽  
Phase Shifter ◽  
Phase Shifters ◽  
Achievable Rate ◽  
Wave System ◽  
Digital To Analog Converter ◽  
Hybrid Precoding ◽  
Analog Converter

Background : Millimeter wave technology is the emerging technology in wireless communication due to increased demand for data traffic and its numerous advantages however it suffers from severe attenuation. To mitigate this attenuation, phased antenna arrays are used for unidirectional power distribution. An initial access is needed to make a connection between the base station and users in millimeter wave system. The high complexity and cost can be mitigated by the use of hybrid precoding schemes. Hybrid precoding techniques are developed to reduce the complexity, power consumption and cost by using phase shifters in place of converters. The use of phase shifters also increases the spectral efficiency. Objective: Analysis of Optimum Precoding schemes in Millimeter Wave System. Method: In this paper, the suitability of existing hybrid precoding solutions are explored on the basis of the different algorithms and the architecture to increase the average achievable rate. Previous work done in hybrid precoding is also compared on the basis of the resolution of the phase shifter and digital to analog converter. Results: A comparison of the previous work is done on the basis of different parameters like the resolution of phase shifters, digital to analog converter, amount of power consumption and spectral efficiency. Table 2 shows the average achievable rate of different algorithms at SNR= 0 dB and 5 dB. Table 3 also compares the performance achieved by the hybrid precoder in the fully connected structure with two existing approaches, dynamic subarray structure with and without switch and sub connected or partially connected structure. Table 4 gives the comparative analysis of hybrid precoding with the different resolutions of the phase shifter and DAC. Conclusion: In this paper, some available literature is reviewed and summarized about hybrid precoding in millimeter wave communication. Current solutions of hybrid precoding are also reviewed and compared in terms of their efficiency, power consumption, and effectiveness. The limitations of the existing hybrid precoding algorithms are the selection of group and resolution of phase shifters. The mm wave massive MIMO is only feasible due to hybrid precoding.

РАЗРАБОТКА СВЧ МОНОЛИТНЫХ ИНТЕГРАЛЬНЫХ СХЕМ МИЛЛИМЕТРОВОГО ДИАПАЗОНА НА ОСНОВЕ GAAS ДЛЯ ПРИМЕНЕНИЯ В СОВРЕМЕННЫХ ИНФОРМАЦИОННОКОММУНИКАЦИОННЫХ СИСТЕМАХ НОВОГО ПОКОЛЕНИЯ (5G)

2020 ◽  
Vol 96 (3s) ◽  
pp. 321-324
Author(s):  
Е.В. Ерофеев ◽  
Д.А. Шишкин ◽  
В.В. Курикалов ◽  
А.В. Когай ◽  
И.В. Федин
Keyword(s):  
Output Power ◽  
Power Amplifier ◽  
Integrated Circuit ◽  
Phase Shifter ◽  
Phase Error ◽  
Microwave Integrated Circuit ◽  
Gain Compression ◽  
Monolithic Microwave Integrated Circuit ◽  
And Performance ◽  
Power Capability

В данной работе представлены результаты разработки СВЧ монолитной интегральной схемы шестиразрядного фазовращателя и усилителя мощности диапазона частот 26-30 ГГц. СКО ошибки по фазе и амплитуде фазовращателя составили 1,2 град. и 0,13 дБ соответственно. Максимальная выходная мощность и КПД по добавленной мощности усилителя в точке сжатия Ку на 1 дБ составили 30 дБм и 20 % соответственно. This paper describes the design, layout, and performance of 6-bit phase shifter and power amplifier monolithic microwave integrated circuit (MMIC), 26-30 GHz band. Phase shifter MMIC has RMS phase error of 1.2 deg. And RMD amplitude error is 0.13 dB. MMIC power amplifier has output power capability of 30 dBm at 1 dB gain compression (P-1dB) and PAE of 20 %.

Voltage controlled monolithic s.a.w. phase shifter using m.z.o.s. structure

1980 ◽  
Vol 16 (20) ◽  
pp. 777 ◽  
Author(s):  
S. Urabe ◽  
S. Uki
Keyword(s):  
Phase Shifter

Rigorous theoretical study of longitudinally magnetised partially filled TEM phase shifter

1990 ◽  
Vol 26 (17) ◽  
pp. 1329 ◽  
Author(s):  
J.W. Tao ◽  
B. Chan ◽  
H. Baudrand
Keyword(s):  
Phase Shifter ◽  
Theoretical Study

Microwave phase shifter based on fibre Bragg grating

1998 ◽  
Vol 34 (21) ◽  
pp. 2051 ◽  
Author(s):  
B. Ortega ◽  
J.L. Cruz ◽  
M.V. Andrés ◽  
A. Díez ◽  
D. Pastor ◽  
...  
Keyword(s):  
Phase Shifter ◽  
Bragg Grating ◽  
Fibre Bragg Grating ◽  
Microwave Phase Shifter

scholarly journals Design of multi limb phase shifter

2010 ◽  
Vol 208 ◽  
pp. 012032
Author(s):  
Sunil Dani ◽  
Raj Singh ◽  
S V Kulkarni ◽  
Icrh-Rf Group
Keyword(s):  
Phase Shifter

scholarly journals Performance analysis of carrier depletion silicon PIN phase shifter

2020 ◽  
Vol 0 (0) ◽  
Author(s):  
Jesuwanth Sugesh Ramesh Gabriel ◽  
Sivasubramanian Arunagiri
Keyword(s):  
Performance Analysis ◽  
Bit Error Rate ◽  
Error Rate ◽  
Phase Shifter ◽  
Extinction Ratio ◽  
Fibre Length ◽  
Data Rate ◽  
Operating Voltage ◽  
Data Centre ◽  
Mach Zehnder Modulator

AbstractIn this paper, we report the performance of a carrier depletion Silicon PIN phase shifter with over layer of 130 nm. It is observed that an optimum intrinsic gap of 250 nm for a device length of 5 mm at 2 V, resulted in Extinction Ratio (ER) of 23.41 dB and Bit Error Rate (BER) of 1.00 × 10−7 is obtained for 50 Gbps. The phase shifter is also designed for length 2 mm with an intrinsic gap of 100 nm at an operating voltage <4 V. The study also reveals that the proposed design for Mach-Zehnder modulator operating at a data rate of 100 Gbps for the concentration of P = 7 × 1017 cm−3 and N = 5 × 1017 cm−3 gives better BER and phase performance. The proposed design was also analysed in an intra-data centre communication setup of fibre length 15 km.

Sign in / Sign up

Export Citation Format

Share Document