Stabilization of Marine Soft Clay with Two Industry By-products

Author(s):  
Yaolin Yi ◽  
Pengpeng Ni
Keyword(s):  
2020 ◽  
Vol 4 (1) ◽  
pp. 08-14
Author(s):  
Youdeowei, P.O. ◽  
Nwankwoala, H.O. ◽  
Ayibanimiworio, G.T

This study assesses the stabilization of marine clay soil using cement and lime to improve on the subgrade material. The tests conducted include: the natural moisture content, specific gravity, sieve analysis, Atterberg limit, compaction and California Bearing Ratio (CBR). The types of stabilization used were mechanical and chemical. The results obtained were classified using AASHTO classification system and based on the results the soil corresponds to group A-6 soils. The highest CBR values of 33.24% and 424.35% were obtained at 20% cement content for unsoaked and soaked and for lime the highest CBR values were 5.07 and 10.46 for 11% lime content for both unsoaked and unsoaked. Based on the results obtained, the addition of cement and lime to clay soil in the presence of water improved the CBR values for soft clay stabilization for highway construction with low traffic volume. It is therefore concluded that the addition of cement and lime to clay soil improved the bearing capacity and the maximum dry density of the clay soil. Further research should be carried out to examine the effects of industrial by-products on effective clay soil stabilization.


1997 ◽  
Vol 161 ◽  
pp. 179-187
Author(s):  
Clifford N. Matthews ◽  
Rose A. Pesce-Rodriguez ◽  
Shirley A. Liebman

AbstractHydrogen cyanide polymers – heterogeneous solids ranging in color from yellow to orange to brown to black – may be among the organic macromolecules most readily formed within the Solar System. The non-volatile black crust of comet Halley, for example, as well as the extensive orangebrown streaks in the atmosphere of Jupiter, might consist largely of such polymers synthesized from HCN formed by photolysis of methane and ammonia, the color observed depending on the concentration of HCN involved. Laboratory studies of these ubiquitous compounds point to the presence of polyamidine structures synthesized directly from hydrogen cyanide. These would be converted by water to polypeptides which can be further hydrolyzed to α-amino acids. Black polymers and multimers with conjugated ladder structures derived from HCN could also be formed and might well be the source of the many nitrogen heterocycles, adenine included, observed after pyrolysis. The dark brown color arising from the impacts of comet P/Shoemaker-Levy 9 on Jupiter might therefore be mainly caused by the presence of HCN polymers, whether originally present, deposited by the impactor or synthesized directly from HCN. Spectroscopic detection of these predicted macromolecules and their hydrolytic and pyrolytic by-products would strengthen significantly the hypothesis that cyanide polymerization is a preferred pathway for prebiotic and extraterrestrial chemistry.


Author(s):  
Sumio Iijima

We have developed a technique to prepare thin single crystal films of graphite for use as supporting films for high resolution electron microscopy. As we showed elsewhere (1), these films are completely noiseless and therefore can be used in the observation of phase objects by CTEM, such as single atoms or molecules as a means for overcoming the difficulties because of the background noise which appears with amorphous carbon supporting films, even though they are prepared so as to be less than 20Å thick. Since the graphite films are thinned by reaction with WO3 crystals under electron beam irradiation in the microscope, some small crystallites of WC or WC2 are inevitably left on the films as by-products. These particles are usually found to be over 10-20Å diameter but very fine particles are also formed on the film and these can serve as good test objects for studying the image formation of phase objects.


Planta Medica ◽  
2014 ◽  
Vol 80 (16) ◽  
Author(s):  
M Figueiredo ◽  
SM Cardoso ◽  
DF Wessel

Planta Medica ◽  
2007 ◽  
Vol 73 (09) ◽  
Author(s):  
MJ Jordán ◽  
C Martínez ◽  
MI Moñino ◽  
MB López ◽  
E Ferrandini ◽  
...  

2020 ◽  
Vol 3 (1) ◽  
pp. 20-25
Author(s):  
A.I. Zharinov ◽  
O.V. Kuznetsova ◽  
L.A. Tekutieva
Keyword(s):  

2003 ◽  
Vol 30 (2) ◽  
pp. 299-316 ◽  
Author(s):  
Hans-JüRgen Lechtreck

Two early nineteenth century texts treating the production and use of wax models of fruit reveal the history of these objects in the context of courtly decoration. Both sources emphasise the models' decorative qualities and their suitability for display, properties which were not simply by-products of the realism that the use of wax allowed. Thus, such models were not regarded merely as visual aids for educational purposes. The artists who created them sought to entice collectors of art and natural history objects, as well as teachers and scientists. Wax models of fruits are known to have been collected and displayed as early as the seventeenth century, although only one such collection is extant. Before the early nineteenth century models of fruits made from wax or other materials (glass, marble, faience) were considered worthy of display because contemporaries attached great importance to mastery of the cultivation and grafting of fruit trees. This skill could only be demonstrated by actually showing the fruits themselves. Therefore, wax models made before the early nineteenth century may also be regarded as attempts to preserve natural products beyond the point of decay.


Sign in / Sign up

Export Citation Format

Share Document