Water adsorption and micropore structure of carbon adsorbents. 3. evaluation of the micropore structure parameters of activated carbons by water adsorption

1981 ◽  
Vol 30 (10) ◽  
pp. 1795-1799
Author(s):  
G. A. Andreeva ◽  
N. S. Polyakov ◽  
M. M. Dubinin ◽  
K. M. Nikolaev
Keyword(s):  
Water Adsorption ◽  
Activated Carbons ◽  
Carbon Adsorbents ◽  
Structure Parameters ◽  
Micropore Structure

scholarly journals Analysis of the Effect of Conditions of Preparation of Nitrogen-Doped Activated Carbons Derived from Lotus Leaves by Activation with Sodium Amide on the Formation of Their Porous Structure

Materials ◽  
2021 ◽  
Vol 14 (6) ◽  
pp. 1540
Author(s):  
Mirosław Kwiatkowski ◽  
Xin Hu
Keyword(s):  
Porous Structure ◽  
Activated Carbons ◽  
Structure Parameters ◽  
Mass Ratio ◽  
Nitrogen Doped ◽  
Adsorption Analysis ◽  
Lotus Leaves ◽  
The Impact ◽  
Sodium Amide ◽  
Numerical Clustering

This paper presents results of the analysis of the impact of activation temperature and mass ratio of activator to carbonized precursor R on the porous structure of nitrogen-doped activated carbons derived from lotus leaves by carbonization and chemical activation with sodium amide NaNH2. The analyses were carried out via the new numerical clustering-based adsorption analysis (LBET) method applied to nitrogen adsorption isotherms at −195.8 °C. On the basis of the results obtained it was shown that the amount of activator, as compared to activation temperatures, has a significantly greater influence on the formation of the porous structure of activated carbons. As shown in the study, the optimum values of the porous structure parameters are obtained for a mass ratio of R = 2. At a mass ratio of R = 3, a significant decrease in the values of the porous structure parameters was observed, indicating uncontrolled wall firing between adjacent micropores. The conducted analyses confirmed the validity of the new numerical clustering-based adsorption analysis (LBET) method, as it turned out that nitrogen-doped activated carbons prepared from lotus leaves are characterized by a high share of micropores and a significant degree of surface heterogeneity in most of the samples studied, which may, to some extent, undermine the reliability of the results obtained using classical methods of structure analysis that assume only a homogeneous pore structure.

scholarly journals Evaluation of Porous Carbon Adsorbents Made from Rice Husks for Virus Removal in Water

Water ◽  
2021 ◽  
Vol 13 (9) ◽  
pp. 1280
Author(s):  
Vu Duc Canh ◽  
Seiichiro Tabata ◽  
Shun Yamanoi ◽  
Yoichi Onaka ◽  
Toshiyuki Yokoi ◽  
...  
Keyword(s):  
Porous Carbon ◽  
Activated Carbons ◽  
Carbon Adsorbents ◽  
Rice Husks ◽  
Porous Carbons ◽  
Inorganic Pollutants ◽  
Steam Activation ◽  
Virus Removal ◽  
Silica Removal ◽  
Effective Removal

Porous carbons are well-known efficient adsorbents for a variety of organic and inorganic pollutants; however, they have difficulty in virus removal. In this study, novel porous carbons (NPCs) (NPC-A, NPC-B, and NPC-C) derived from rice husks were compared with commercially available activated carbons (ACs) for their ability to remove MS2 bacteriophages (MS2) in a batch experiment. NPC-A was produced by the silica removal process. NPC-B was prepared with an additional steam activation applied to NPC-A. NPC-C was obtained with an additional acid rinse applied to NPC-B. The NPCs (particularly NPC-C) exhibited effective removal of up to 5.3 log10 of MS2, which was greater than that of less than 2.7 log10 obtained by other ACs under 10 g/L during the same contact time (60 min). The pore size distribution of the porous carbon adsorbents was found to influence their virus removal performance. The adsorbents with a larger proportion of pores ranging from 200–4500 nm in diameter were able to achieve higher virus removal rates. Thus, NPCs (particularly NPC-C), which had a larger volume of pores ranging from 200–4500 nm in size, demonstrated the potential for use as efficient adsorbents for removing viruses during water purification.

Boron-Doped Edges as Active Sites for Water Adsorption in Activated Carbons

Langmuir ◽  
2021 ◽  
Author(s):  
Jae-Hyung Wee ◽  
Chang Hyo Kim ◽  
Tomohiro Tojo ◽  
Go Bong Choi ◽  
Cheol-Min Yang ◽  
...  
Keyword(s):  
Active Sites ◽  
Water Adsorption ◽  
Activated Carbons ◽  
Boron Doped
Sign in / Sign up

Export Citation Format

Share Document