Investigation of sloshing damping in baffled rectangular tanks subjected to the dynamic excitation

2009 ◽  
Vol 8 (4) ◽  
pp. 1055-1072 ◽  
Author(s):  
M. A. Goudarzi ◽  
S. R. Sabbagh-Yazdi ◽  
W. Marx
1979 ◽  
Vol 19 (6) ◽  
pp. 2274-2287 ◽  
Author(s):  
Z. Paltiel ◽  
Z. Fraenkel
Keyword(s):  

2021 ◽  
pp. 107754632110458
Author(s):  
Hamze Mousavi ◽  
Moein Mirzaei ◽  
Samira Jalilvand

The present work investigates the vibrational properties of a DNA-like structure by means of a harmonic Hamiltonian and the Green’s function formalism. The DNA sequence is considered as a quasi one-dimensional system in which the mass-spring pairs are randomly distributed inside each crystalline unit. The sizes of the units inside the system are increased, in a step-by-step approach, so that the actual condition of the DNA could be modeled more accurately. The linear-elastic forces mimicking the bonds between the pairs are initially considered constant along the entire length of the system. In the next step, these forces are randomly shuffled so as to take into account the inherent randomness of the DNA. The results reveal that increasing the number of mass-spring pairs in the crystalline structure decreases the influence of randomness on the mechanical behavior of the structure. This also holds true for systems with larger crystalline units. The obtained results can be used to investigate the mechanical behavior of similar macro-systems.


2021 ◽  
Vol 8 ◽  
Author(s):  
Xuejing Liu ◽  
Yu Xing ◽  
Wenjie Sun ◽  
Zhouqiang Zhang ◽  
Shengqi Guan ◽  
...  

The dielectric elastomer (DE) is a new kind of functional polymer that can be used as a smart actuator due to the large deformation induced by voltage excitation. Dielectric elastomer actuators (DEAs) are usually excited by dynamic voltages to generate alternating motions. DEAs are prone to premature breakdown failure during the dynamic excitation, while the research on the breakdown of DEAs under cyclic voltage excitation is still not fully revealed. In this paper, the dynamic breakdown behaviors of DEAs made from VHB4910 film were experimentally investigated. The factors affecting the breakdown behavior of DEAs under dynamic voltages were determined, and the relevant changing laws were summarized accordingly. The experimental results show that under dynamic voltage excitation, the critical breakdown voltage of DEAs were augmented slowly with voltage frequency and showed a substantial dispersion. In addition, the maximum cycle numbers before breakdown were significantly affected by voltage parameters (such as frequency, amplitude, waveform). Finally, the underlying mechanisms of breakdown under cyclic voltages were discussed qualitatively, a power-law equation was proposed to characterize the maximum cycle number for the dynamic breakdown of DEAs, and related parameters were fitted. This study provides a new path to predict the service life of DEAs under dynamic voltage.


Author(s):  
Milan Moravčík

The paper presents an analysis of an actual problem related to dynamic effects to road bridges due to travelling a heavy vehicle over the bridge. Numerical simulations of the dynamic response are applied on a fictitious simple beam of the length Lb = 52 m with an artificial irregularity at midspan, corresponding to a characteristic span L (b5) = 52 m of the ten-span continuous box girder bridge. A heavy four-axle truck m v = 32 t is used for dynamic excitation, travelling over the bridge at passing speed of 70km / h. The obtained results are compared to results of the experimentally tested ten-span continuous pre-stressed reinforced concrete girder bridge at the same speed.


Sign in / Sign up

Export Citation Format

Share Document