Thermal effects on red muscle contractile performance in deep-diving, large-bodied fishes

2020 ◽  
Vol 46 (5) ◽  
pp. 1833-1845
Author(s):  
Ashley A. Stoehr ◽  
Jeanine M. Donley ◽  
Scott A. Aalbers ◽  
Douglas A. Syme ◽  
Chugey Sepulveda ◽  
...  
Keyword(s):  
Thermal Effects ◽  
Deep Diving ◽  
Red Muscle ◽  
Muscle Contractile ◽  
Contractile Performance

Skeletal muscle contractile performance and ADP accumulation in adenylate kinase-deficient mice

2005 ◽  
Vol 288 (6) ◽  
pp. C1287-C1297 ◽  
Author(s):  
Chad R. Hancock ◽  
Edwin Janssen ◽  
Ronald L. Terjung
Keyword(s):  
Skeletal Muscle ◽  
Adenylate Kinase ◽  
Energy Demand ◽  
Adenine Nucleotide ◽  
Formation Rate ◽  
High Energy ◽  
Energy Demands ◽  
Whole Muscle ◽  
Muscle Contractile ◽  
Contractile Performance

The production of AMP by adenylate kinase (AK) and subsequent deamination by AMP deaminase limits ADP accumulation during conditions of high-energy demand in skeletal muscle. The goal of this study was to investigate the consequences of AK deficiency (−/−) on adenine nucleotide management and whole muscle function at high-energy demands. To do this, we examined isometric tetanic contractile performance of the gastrocnemius-plantaris-soleus (GPS) muscle group in situ in AK1−/− mice and wild-type (WT) controls over a range of contraction frequencies (30–120 tetani/min). We found that AK1−/− muscle exhibited a diminished inosine 5′-monophosphate formation rate (14% of WT) and an inordinate accumulation of ADP (∼1.5 mM) at the highest energy demands, compared with WT controls. AK-deficient muscle exhibited similar initial contractile performance (521 ± 9 and 521 ± 10 g tension in WT and AK1−/− muscle, respectively), followed by a significant slowing of relaxation kinetics at the highest energy demands relative to WT controls. This is consistent with a depressed capacity to sequester calcium in the presence of high ADP. However, the overall pattern of fatigue in AK1−/− mice was similar to WT control muscle. Our findings directly demonstrate the importance of AMP formation and subsequent deamination in limiting ADP accumulation. Whole muscle contractile performance was, however, remarkably tolerant of ADP accumulation markedly in excess of what normally occurs in skeletal muscle.

scholarly journals The effects of RSR13 on microvascular Po2 kinetics and muscle contractile performance in the rat arterial ligation model of peripheral arterial disease

2017 ◽  
Vol 123 (4) ◽  
pp. 764-772 ◽  
Author(s):  
Aiko Watanabe ◽  
David C. Poole ◽  
Yutaka Kano
Keyword(s):  
Peripheral Arterial Disease ◽  
Contractile Function ◽  
Tibialis Anterior Muscle ◽  
Oxygen Affinity ◽  
Arterial Disease ◽  
Arterial Ligation ◽  
Hemoglobin Oxygen Affinity ◽  
Peripheral Arterial ◽  
Muscle Contractile ◽  
Contractile Performance

Exercise intolerance and claudication are symptomatic of peripheral arterial disease. There is a close relationship between muscle O2 delivery, microvascular oxygen partial pressure (P mvO2), and contractile performance. We therefore hypothesized that a reduction of hemoglobin-oxygen affinity via RSR13 would maintain a higher P mvO2 and enhance blood-muscle O2 transport and contractile function. In male Wistar rats (12 wk of age), we created hindlimb ischemia via right-side iliac artery ligation (AL). The contralateral (left) muscle served as control (CONT). Seven days after AL, phosphorescence-quenching techniques were used to measure P mvO2 at rest and during contractions (electrical stimulation; 1 Hz, 300 s) in tibialis anterior muscle (TA) under saline ( n = 10) or RSR13 ( n = 10) conditions. RSR13 at rest increased TA P mvO2 in CONT (13.9 ± 1.6 to 19.3 ± 1.9 Torr, P < 0.05) and AL (9.0 ± 0.5 to 9.9 ± 0.7 Torr, P < 0.05). Furthermore, RSR13 extended maintenance of the initial TA force (i.e., improved contractile performance) such that force was not decreased significantly until contraction 240 vs. 150 in CONT and 80 vs. 20 in AL. This improved muscle endurance with RSR13 was accompanied by a greater ΔP mvO2 (P mvO2 decrease from baseline) (CONT, 7.4 ± 1.0 to 11.2 ± 1.3; AL, 6.9 ± 0.5 to 8.6 ± 0.6 Torr, both P < 0.05). Whereas RSR13 did not alter the kinetics profile of P mvO2 (i.e., mean response time) substantially during contractions, muscle force was elevated, and the ratio of muscle force to P mvO2 increased. In conclusion, reduction of hemoglobin-oxygen affinity via RSR13 in AL increased P mvO2 and improved muscle contractile performance most likely via enhanced blood-muscle O2 diffusion. NEW & NOTEWORTHY This is the first investigation to examine the effect of RSR13 (erythrocyte allosteric effector) on skeletal muscle microvascular oxygen partial pressure kinetics and contractile function using an arterial ligation model of peripheral arterial disease in experimental animals. The present results provide strong support for the concept that reducing hemoglobin-O2 affinity via RSR13 improved tibialis anterior muscle contractile performance most likely via enhanced blood-muscle O2 diffusion.

Thermal Considerations in Lens Regulator Systems

1970 ◽  
Vol 28 ◽  
pp. 358-359
Author(s):  
K.C. Newton
Keyword(s):  
Electron Microscope ◽  
Thermal Effects ◽  
Environmental Control ◽  
Reference Networks ◽  
Better Than

Thermal effects in lens regulator systems have become a major problem with the extension of electron microscope resolution capabilities below 5 Angstrom units. Larger columns with immersion lenses and increased accelerating potentials have made solutions more difficult by increasing the power being handled. Environmental control, component choice, and wiring design provide answers, however. Figure 1 indicates with broken lines where thermal problems develop in regulator systemsExtensive environmental control is required in the sampling and reference networks. In each case, stability better than I ppm/min. is required. Components with thermal coefficients satisfactory for these applications without environmental control are either not available or priced prohibitively.

Direct measurement of electron-diffraction-pattern intensities using an energy loss spectrometer

1989 ◽  
Vol 47 ◽  
pp. 668-669
Author(s):  
A. G. Jackson ◽  
M. Rowe
Keyword(s):  
Thermal Effects ◽  
Dynamic Range ◽  
Scattering Amplitude ◽  
Dynamical Theory ◽  
Site Symmetry ◽  
Proof Of Concept ◽  
Parallel Acquisition ◽  
Kinematic Approximation ◽  
Speed Up ◽  
Structure Calculations

Diffraction intensities from intermetallic compounds are, in the kinematic approximation, proportional to the scattering amplitude from the element doing the scattering. More detailed calculations have shown that site symmetry and occupation by various atom species also affects the intensity in a diffracted beam. [1] Hence, by measuring the intensities of beams, or their ratios, the occupancy can be estimated. Measurement of the intensity values also allows structure calculations to be made to determine the spatial distribution of the potentials doing the scattering. Thermal effects are also present as a background contribution. Inelastic effects such as loss or absorption/excitation complicate the intensity behavior, and dynamical theory is required to estimate the intensity value.The dynamic range of currents in diffracted beams can be 104or 105:1. Hence, detection of such information requires a means for collecting the intensity over a signal-to-noise range beyond that obtainable with a single film plate, which has a S/N of about 103:1. Although such a collection system is not available currently, a simple system consisting of instrumentation on an existing STEM can be used as a proof of concept which has a S/N of about 255:1, limited by the 8 bit pixel attributes used in the electronics. Use of 24 bit pixel attributes would easily allowthe desired noise range to be attained in the processing instrumentation. The S/N of the scintillator used by the photoelectron sensor is about 106 to 1, well beyond the S/N goal. The trade-off that must be made is the time for acquiring the signal, since the pattern can be obtained in seconds using film plates, compared to 10 to 20 minutes for a pattern to be acquired using the digital scan. Parallel acquisition would, of course, speed up this process immensely.

Maximum Interlabial Pressures in Normal Speakers

1997 ◽  
Vol 40 (2) ◽  
pp. 400-404 ◽  
Author(s):  
Virginia A. Hinton ◽  
Winston M. C. Arokiasamy
Keyword(s):  
Speech Production ◽  
Contact Pressure ◽  
Direct Evidence ◽  
Unit Area ◽  
Jaw Movement ◽  
Contractile Forces ◽  
Contact Pressures ◽  
Muscle Contractile

It has been hypothesized that typical speech movements do not involve large muscular forces and that normal speakers use less than 20% of the maximum orofacial muscle contractile forces that are available (e.g., Amerman, 1993; Barlow & Abbs, 1984; Barlow & Netsell, 1986; DePaul & Brooks, 1993). However, no direct evidence for this hypothesis has been provided. This study investigated the percentage of maximum interlabial contact pressures (force per unit area) typically used during speech production. The primary conclusion of this study is that normal speakers typically use less than 20% of the available interlabial contact pressure, whether or not the jaw contributes to bilabial closure. Production of the phone [p] at conversational rate and intensity generated an average of 10.56% of maximum available interlabial pressure (MILP) when jaw movement was not restricted and 14.62% when jaw movement was eliminated.

Sign in / Sign up

Export Citation Format

Share Document