Effect of Ce Addition on MgAl Mixed Oxides for the Total Oxidation of CO and Toluene

2018 ◽  
Vol 62 (1-4) ◽  
pp. 397-402
Author(s):  
E. Genty ◽  
H. Dib ◽  
J. Brunet ◽  
C. Poupin ◽  
S. Siffert ◽  
...  
2009 ◽  
Vol 363 (1-2) ◽  
pp. 135-142 ◽  
Author(s):  
Serghei Tanasoi ◽  
Nathalie Tanchoux ◽  
Adriana Urdă ◽  
Didier Tichit ◽  
Ioan Săndulescu ◽  
...  
Keyword(s):  

2021 ◽  
Vol 10 (4) ◽  
pp. 39-45
Author(s):  
Phuong Pham Thi Mai ◽  
Hoan Nguyen Quoc ◽  
Quan Do Quoc ◽  
Hung Nguyen Thanh

In this paper, the Au doped Mn1Co9Ox was investigated for total oxidation of CO. The sol-gel method was applied to prepare this catalyst and some modern analysis methods as XRD, EPR, TPx, SEM were utilized to characterize its properties. The XRD patterns showed only Co3O4 phase without any peaks belonging to Mn or Au. However, the presence of Au and Mn was confirmed by EPR and O2-TPD results. With the aim to further apply catalyst in reality, the Au doped Mn1Co9Ox was deposited on ceramic by sol-gel, wet impregnation. The SEM images displayed the successful coating of active phase on substrate. However, the complete catalyst system didn’t have the high activity in total CO oxidation like the catalyst powder because of large agglomerations on coatings.


2006 ◽  
Vol 113 (3-4) ◽  
pp. 182-186 ◽  
Author(s):  
Svetlana Ivanova ◽  
Corinne Petit ◽  
Véronique Pitchon

2020 ◽  
Vol 15 (2) ◽  
pp. 490-500
Author(s):  
Neha Neha ◽  
Ram Prasad ◽  
Satya Vir Singh

A series of nickel-cobalt bimetal oxides in varying molar ratios and its single metal oxides were synthesized by reactive calcination of coprecipitated basic-carbonates. Several characterization techniques, such as: Bruneuer Emmett Teller (BET), X-ray Diffraction (XRD), Scanning Electron Microscopy (SEM), Fourier Transform Infra Red (FTIR), and Hydrogen Temperature Programmed Reduction (H2-TPR), were performed over the oxides. Activities of oxides were evaluated in methane total oxidation in the presence or the absence of CO. The best catalytic performance was observed over NiCo catalyst with a Ni/Co molar ratio of 1:1, and the complete conversion of CO-CH4 mixture was achieved at 390 °C. Moreover, the presence of carbon monoxide improves CH4 total oxidation over nickel-cobalt mixed oxides. Structural analysis reveals that the insertion of nickel into the spinel lattice of cobalt oxide causes the structural disorder, which probably caused the increase of the amount of octahedrally coordinated divalent nickel cations that are responsible for catalytic activity. Stability of the best-performed catalyst has been tested in the two conditions, showing remarkable long-term stability and thermal stability, however, showed deactivation after thermally ageing at 700 °C. Copyright © 2020 BCREC Group. All rights reserved 


Author(s):  
Zheng Wang ◽  
Omeir Khalid ◽  
Wei Wang ◽  
Yu Wang ◽  
Tim Weber ◽  
...  

The effect of the carrier material on the intrinsic activity of three catalytic total oxidation reactions, namely CO oxidation as well as methane and propane combustion over highly dispersed RuO2...


Catalysts ◽  
2020 ◽  
Vol 10 (6) ◽  
pp. 613
Author(s):  
Hussein Mahdi S. Al-Aani ◽  
Mihaela M. Trandafir ◽  
Ioana Fechete ◽  
Lucia N. Leonat ◽  
Mihaela Badea ◽  
...  

To improve the catalytic performance of an active layered double hydroxide (LDH)-derived CuCeMgAlO mixed oxide catalyst in the total oxidation of methane, it was promoted with different transition-metal cations. Thus, two series of multicationic mixed oxides were prepared by the thermal decomposition at 750 °C of their corresponding LDH precursors synthesized by coprecipitation at constant pH of 10 under ambient atmosphere. The first series of catalysts consisted of four M(3)CuCeMgAlO mixed oxides containing 3 at.% M (M = Mn, Fe, Co, Ni), 15 at.% Cu, 10 at.% Ce (at.% with respect to cations), and with Mg/Al atomic ratio fixed to 3. The second series consisted of four Co(x)CuCeMgAlO mixed oxides with x = 1, 3, 6, and 9 at.% Co, while keeping constant the Cu and Ce contents and the Mg/Al atomic ratio. All the mixed oxides were characterized by powder X-ray diffraction (XRD), transmission electron microscopy (TEM), scanning electron microscopy (SEM) coupled with X-ray energy dispersion analysis (EDX), X-ray photoelectron spectroscopy (XPS), nitrogen adsorption-desorption at −196 °C, temperature-programmed reduction under hydrogen (H2-TPR), and diffuse reflectance UV-VIS spectroscopy (DR UV-VIS), while thermogravimetric and differential thermal analyses (TG-DTG-DTA) together with XRD were used for the LDH precursors. The catalysts were evaluated in the total oxidation of methane, a test reaction for volatile organic compounds (VOC) abatement. Their catalytic performance was explained in correlation with their physicochemical properties and was compared with that of a reference Pd/Al2O3 catalyst. Among the mixed oxides studied, Co(3)CuCeMgAlO was found to be the most active catalyst, with a temperature corresponding to 50% methane conversion (T50) of 438 °C, which was only 19 °C higher than that of a reference Pd/Al2O3 catalyst. On the other hand, this T50 value was ca. 25 °C lower than that observed for the unpromoted CuCeMgAlO system, accounting for the improved performance of the Co-promoted catalyst, which also showed a good stability on stream.


2019 ◽  
Vol 256 ◽  
pp. 117807 ◽  
Author(s):  
Honggen Peng ◽  
Tao Dong ◽  
Li Zhang ◽  
Caili Wang ◽  
Wenming Liu ◽  
...  

2013 ◽  
Vol 464-465 ◽  
pp. 181-190 ◽  
Author(s):  
František Kovanda ◽  
Květa Jirátová ◽  
Jana Ludvíková ◽  
Helena Raabová

Sign in / Sign up

Export Citation Format

Share Document