scholarly journals Characterisation of the Contaminants Generated from a Large-Scale Ex-Situ Underground Coal Gasification Study Using High-Rank Coal from the South Wales Coalfield

2020 ◽  
Vol 231 (10) ◽  
Author(s):  
Sivachidambaram Sadasivam ◽  
Renato Zagorščak ◽  
Hywel Rhys Thomas ◽  
Krzysztof Kapusta ◽  
Krzysztof Stańczyk

Abstract This paper presents an analysis of contaminants generated from large-scale, laboratory-based, underground coal gasification (UCG) experiments using a high-rank coal from the South Wales Coalfield. The experiments were performed at atmospheric and elevated pressures (30 bar) by varying the oxidants’ composition. The experiments were designed to predict the amount of produced water and contaminants generated at each stage of the operating conditions. The mass balance of water supplied and produced in the experiments was accounted for. Chemical analyses of produced water, char and ash contents were performed to quantify the inorganic and organic chemical parameters. Most of the contaminant concentrations in the produced water from the 30-bar pressure experiment were lower than the concentrations generated from the atmospheric pressure experiment. The measured concentrations of the inorganic chemical species and the inorganic parameters of the coal seam water from the South Wales Coalfield were used in theoretical calculations to predict the dominant equilibrium species concentrations in a hypothetical scenario of effluent contaminated groundwater. The biodegradation of organic contaminants such as phenol, benzene and sorbed fractions of inorganic contaminants from the produced water on iron oxide in the ash residue was predicted using existing biotransformation kinetics and surface complexation models, respectively. The biodegradation of phenol and benzene would be a slow process even at optimum conditions and the iron oxide left in the cavity can act as a sorbent for a few inorganic species. The evidence from the present study suggests future work towards (i) developing an appropriate water treatment process during gas cleaning, (ii) operational procedure (pressure and proportions of oxidant) and (iii) developing UCG-specific experimental prediction of contaminant transportation and transformation kinetics.

Author(s):  
Sivachidambaram Sadasivam ◽  
Renato Zagorščak ◽  
Hywel Rhys Thomas ◽  
Krzysztof Kapusta ◽  
Krzysztof Stańczyk

AbstractThis paper deals with the characterisation of inorganic constitutions generated at various operating conditions in the context of underground coal gasification (UCG). The ex situ small-scale experiments were conducted with coal specimens of different rank, from the South Wales Coalfield, Wales, UK, and Upper Silesian Coal Basin, Poland. The experiments were conducted at various gaseous oxidant ratios (water: oxygen = 1:1 and 2:1), pressures (20 bar and 36 bar) and temperatures (650°C, 750°C and 850°C). Increasing the amount of water in the oxidants proportionately decreased the cationic elements but increased the concentrations of anionic species. The temperature played minor impact, while the high-pressure experiments at temperature optimum to produce methane-rich syngas (750°C) showed significant reduction in cationic element generation. However, both coal specimens produced high amount of anionic species (F, Cl, SO4 and NO3). The “Hard” bituminous coal from Poland produced less gasification residues and condensates than the South Wales anthracitic coal due to its higher reactivity. The inorganic composition found in the solid residue was used in the theoretical calculation to predict the dissolved product concentrations when the solid residue interacts with deep coal seam water in the event of UCG cavity flooding. It was evident from the solubility products of the Cr, Ni and Zn that changes in the groundwater geochemistry occur; hence, their transportation in the subsurface must be studied further.


Energies ◽  
2018 ◽  
Vol 11 (4) ◽  
pp. 898 ◽  
Author(s):  
Fa-qiang Su ◽  
Akihiro Hamanaka ◽  
Ken-ichi Itakura ◽  
Gota Deguchi ◽  
Wenyan Zhang ◽  
...  

The Underground Coal Gasification (UCG) system is a clean technology for obtaining energy from coal. The coaxial UCG system is supposed to be compact and flexible in order to adapt to complicated geological conditions caused by the existence of faults and folds in the ground. In this study, the application of a coaxial UCG system with a horizontal well is discussed, by means of an ex situ model UCG experiment in a large-scale simulated coal seam with dimensions of 550 × 600 × 2740 mm. A horizontal well with a 45-mm diameter and a 2600-mm length was used as an injection/production well. During the experiment, changes in temperature field and product gas compositions were observed when changing the outlet position of the injection pipe. It was found that the UCG reactor is unstable and expands continuously due to fracturing activity caused by coal crack initiation and extension under the influence of thermal stress. Therefore, acoustic emission (AE) is considered an effective tool to monitor fracturing activities and visualize the gasification zone of coal. The results gathered from monitoring of AEs agree with the measured data of temperatures; the source location of AE was detected around the region where temperature increased. The average calorific value of the produced gas was 6.85 MJ/Nm3, and the gasification efficiency, defined as the conversion efficiency of the gasified coal to syngas, was 65.43%, in the whole experimental process. The study results suggest that the recovered coal energy from a coaxial UCG system is comparable to that of a conventional UCG system. Therefore, a coaxial UCG system may be a feasible option to utilize abandoned underground coal resources without mining.


Fuel ◽  
2020 ◽  
Vol 270 ◽  
pp. 117490 ◽  
Author(s):  
Renato Zagorščak ◽  
Sivachidambaram Sadasivam ◽  
Hywel Rhys Thomas ◽  
Krzysztof Stańczyk ◽  
Krzysztof Kapusta

2008 ◽  
Vol 33 (4) ◽  
pp. 1275-1285 ◽  
Author(s):  
Lanhe Yang ◽  
Xing Zhang ◽  
Shuqin Liu ◽  
Li Yu ◽  
Weilian Zhang

2018 ◽  
Vol 223 ◽  
pp. 82-92 ◽  
Author(s):  
Fa-qiang Su ◽  
Akihiro Hamanaka ◽  
Ken-ichi Itakura ◽  
Wenyan Zhang ◽  
Gota Deguchi ◽  
...  

2012 ◽  
Vol 524-527 ◽  
pp. 56-62 ◽  
Author(s):  
Hong Tao Liu ◽  
Hong Yao ◽  
Kai Yao ◽  
Feng Chen ◽  
Guang Qian Luo

According to the temperature, major chemical reactions and gas compositions, the gasification process along the tunnel of underground coal gasification is divided into three zones, i.e. oxidation zone, reduction zone and dry distillation zone. A model test in the laboratory was carried out by using large-scale coal blocks to simulate the coal seam. The characteristics of the “three zones”, and the relation between the temperature and gas composition were also quantitative studied. It provided the necessary basic knowledge for further studying the process of underground coal gasification, including predicting compositions of product gas, life-cycle analyzing, selecting optimistic control parameters and determining suitable gasification craft.


2012 ◽  
Vol 223 (9) ◽  
pp. 5745-5758 ◽  
Author(s):  
Adam Smoliński ◽  
Krzysztof Stańczyk ◽  
Krzysztof Kapusta ◽  
Natalia Howaniec

Energies ◽  
2021 ◽  
Vol 14 (17) ◽  
pp. 5444
Author(s):  
Milan Durdán ◽  
Marta Benková ◽  
Marek Laciak ◽  
Ján Kačur ◽  
Patrik Flegner

The underground coal gasification represents a technology capable of obtaining synthetic coal gas from hard-reached coal deposits and coal beds with tectonic faults. This technology is also less expensive than conventional coal mining. The cavity is formed in the coal seam by converting coal to synthetic gas during the underground coal gasification process. The cavity growth rate and the gasification queue’s moving velocity are affected by controllable variables, i.e., the operation pressure, the gasification agent, and the laboratory coal seam geometry. These variables can be continuously measured by standard measuring devices and techniques as opposed to the underground temperature. This paper researches the possibility of the regression models utilization for temperature data prediction for this reason. Several regression models were proposed that were differed in their structures, i.e., the number and type of selected controllable variables as independent variables. The goal was to find such a regression model structure, where the underground temperature is predicted with the greatest possible accuracy. The regression model structures’ proposal was realized on data obtained from two laboratory measurements realized in the ex situ reactor. The obtained temperature data can be used for visualization of the cavity growth in the gasified coal seam.


2019 ◽  
Vol 59 (4) ◽  
pp. 322-351
Author(s):  
Ján Kačur ◽  
Milan Durdán ◽  
Marek Laciak ◽  
Patrik Flegner

Underground coal gasification (UCG) is a technological process, which converts solid coal into a gas in the underground, using injected gasification agents. In the UCG process, a lot of process variables can be measurable with common measuring devices, but there are variables that cannot be measured so easily, e.g., the temperature deep underground. It is also necessary to know the future impact of different control variables on the syngas calorific value in order to support a predictive control. This paper examines the possibility of utilizing Neural Networks, Multivariate Adaptive Regression Splines and Support Vector Regression in order to estimate the UCG process data, i.e., syngas calorific value and underground temperature. It was found that, during the training with the UCG data, the SVR and Gaussian kernel achieved the best results, but, during the prediction, the best result was obtained by the piecewise-cubic type of the MARS model. The analysis was performed on data obtained during an experimental UCG with an ex-situ reactor.


Sign in / Sign up

Export Citation Format

Share Document