A review on the engine performance and exhaust emission characteristics of diesel engines fueled with biodiesel blends

2018 ◽  
Vol 25 (16) ◽  
pp. 15307-15325 ◽  
Author(s):  
Natalina Damanik ◽  
Hwai Chyuan Ong ◽  
Chong Wen Tong ◽  
Teuku Meurah Indra Mahlia ◽  
Arridina Susan Silitonga
2021 ◽  
Vol 143 (12) ◽  
Author(s):  
A. Anderson ◽  
Amal M. Al-Mohaimeed ◽  
Mohamed Soliman Elshikh ◽  
T. R. Praveenkumar ◽  
M. Sekar

Abstract The current study emphasis on the engine performance and emission characteristics of rapeseed and soya biodiesel dispersion on a novel nanocatalyst at different concentrations of 25 ppm and 50 ppm. The results of this study were compared with those of conventional diesel at varying load conditions on a combustion ignition engine. An α-Fe2O3-doped Al2O3 was mixed with rapeseed biodiesel and soya biodiesel using an ultrasonicator at a frequency of 25 kHz. This study revealed that the incorporation of nanoparticles in biodiesel enhanced the performance of the blends by reducing the content of lignin and other unsaturated fatty acids. The improvement in the performance of the engine is mainly attributed to the high area-to-volume ratio of the nanocatalyst. Emissions of NOx. hydrocarbon and carbon monoxide during the combustion reaction increased significantly when nanoparticles were added at higher concentrations. Contrastingly, the emission of NOx in pure biodiesel was higher than that in conventional diesel. The addition of nanoparticles reduced CO emissions due to the presence of extra oxygen molecules and converted carbon monoxide into carbon dioxide. Soya seed biodiesel blends with 50 ppm nanoparticles showed better engine performance and emission characteristics as compared with all other blends.


2021 ◽  
Vol 9 (1) ◽  
pp. 436-443
Author(s):  
M.Kannan, R.Balaji, R.T Sarath Babu, Chandrakant B. Shende, Ashish Selokar

The primary objective of this study is to discover the effects of injection timing on performance, emission and combustion characteristics effect of advanced and retarded injection timing of the engine fuelled with mahua oil biodiesel blends. The engine performance, combustion and emission characteristics of the mahua oil biodiesel blends (B20, B40, B60, B80and B100) are investigated in this experimentation without any modification of the diesel engine. At this advanced pressure t he efficiency of engine by means of CO, Unburned HC gases and smoke emissions with higher oxides of nitrogen was observed compared to diesel. The obtained results are compared with a neat diesel and mahua oil biodiesel blends are shown through the graphs. From this study, identifies optimum fuel blend of this work. Thus, the combustion of duration is similar in all variance in pressure. This research paved a way to bio-diesel in mahua oil mixture and draws best outcome in emission less and to maintain eco-friendly environment.  


2013 ◽  
Vol 774-776 ◽  
pp. 784-790
Author(s):  
S.M. Palash ◽  
M.A. Kalam ◽  
H.H. Masjuki ◽  
B.M. Masum

To meet stringent exhaust emission norms worldwide, various exhaust pre-treatment and post-treatment techniques have been employed in modern engines. Using antioxidant additives in biodiesel fuels is a promising and effective NOx reduction technology. Non-edible jatropha oil based methyl ester was produced and blended with conventional diesel. Five fuel samples (Diesel, JB5, JB5DPPD0.15%, JB15 and JB15DPPD0.15%) were tested for their use as substitute fuel for a radiator-cooled four cylinder diesel engine. Experiment results show that DPPD antioxidant additive could be reduced NOx emission significantly with slight penalty on engine performance as well as CO and HC emission. However, when compared to diesel combustion the emissions of HC and CO were found nearly same or below. By addition of 0.15% (m) DPPD additive in JB5 and JB15 reduction of NOx emission were 12.68% and 13.36 % compared to biodiesel blends without additive at full throttle position. As conclusion, JB5 and JB15 with addition of 0.15% (m) can be used in four cylinder diesel engine to reduce NOx and consequently overcome the barrier to market expansion of biodiesel fuels.


2012 ◽  
Vol 06 ◽  
pp. 425-430
Author(s):  
HYUNG-GON KIM ◽  
SEUNG-HUN CHOI ◽  
YOUNG-TAIG OH

Effect of oxygen components of fuels on exhaust emissions has been investigated by applying an indirect injection (IDI) diesel engine. This research analyzed variation and/or difference of the engine performance and exhaust emission characteristics of the IDI diesel engine by fueling the commercial diesel fuel and four different mixed ratios of oxygenated blended fuels. Effect of the exhaust gas recirculation (EGR) method was analyzed on the NOx emission characteristics. Ethylene glycol mono-n-butyl ether (EGBE) contains 27% of oxygen components in itself, and it is a kind of effective oxygenated fuel of mono-ether group. Smoke emission from the EGBE was reduced remarkably relative to the commercial diesel fuel. The EGBE can supply oxygen components sufficiently at higher diesel engine loads and speeds. It was found that a simultaneous reduction of the smoke and the NOx was achieved with the oxygenated fuel (10 vol-%) and the cooled EGR method (10%).


Author(s):  
Fatima Mohammed Ghanim ◽  
Ali Mohammed Hamdan Adam ◽  
Hazir Farouk

Abstract: There is growing interest to study the effect of blending various oxygenated additives with diesel or biodiesel fuel on engine performance and emission characteristics. This study aims to analyze the performance and exhaust emission of a four-stroke, four-cylinder diesel engine fueled with biodiesel-ethanol-diesel. Biodiesel was first produced from crude Jatropha oil, and then it was blended with ethanol and fossil diesel in different blend ratios (B10E10D80, B12.5E12.5D75, B15E15D70, B20E20D60 and B25E25D50). The engine performance and emission characteristics were studied at engine speeds ranging from 1200 to 2000 rpm. The results show that the brake specific fuel consumption increases while the brake power decreases as the percentage of biodiesel and ethanol increases in the blend. The exhaust emission analysis shows a reduction in CO2 emission and increase in NOx emission when the biodiesel -to- ethanol ratio increases in the blends, when compared with diesel as a reference fuel.


Author(s):  
Alex Y ◽  
Roji George Roy

Biodiesel has become more attractive recently, because of its environmental benefits and the fact that it is made from renewable resources. Over the past few decades, most of the countries depending on diesel engines for transportation. Some of its valuable advantages like highest thermal efficiency made it very popular. At the same time, the cost of diesel fuel is increasing, due to the depletion of fossil fuels. In this current scenario, we need an alternative fuel instead of diesel fuel. Many of the researchers have successfully placed several works on generating energy from different types of alternative sources including solar and some kind of conversion processes including renewable agricultural products into liquid fuel. One of the biggest challenges for developing countries in relation to energy consumption is to develop and implement technologies that help to improve efficiency of automobile engines, also to reduce the emissions of harmful gases and particulate matters. In order to avoid environmental impacts, emissions are reduced or eliminated by introducing renewable energy resources. The present research chronicles the production and testing of renewable biodiesel fuel derived from virgin coconut oil on a diesel engine, to analyses the engine performance and emission characteristics. In the first phase of work, production of biodiesel fuel from virgin coconut oil using transeterification process with two types of catalysts (homogenous and heterogeneous). The preliminary results shows that, with the addition of homogenous catalyst called Potassium Hydroxide (KOH) with methanol shows much higher activity than that of heterogeneous catalysts, and it shows more similar properties with diesel fuel. The results obtained from the chemical test and physicochemical properties of transesterified biodiesel fuel clearly proves the above-mentioned statement. The chemical tests such as GCMS and FT-IR clearly shows that the biodiesel fuel has sufficient amount of volatile components and functional groups. Then, physicochemical properties include, Fire point, Flashpoint, density, and viscosity were analyzed. Finally, Engine performance and Emission characteristics were analysed to confirm, whether this biodiesel fuel is suitable for diesel engines, without any engine modifications. It was found to be, the transesterified virgin coconut oil biodiesel has similar properties to that of the diesel fuel. From the physiochemical properties and engine performance clearly shows that, coconut oil biodiesel is suitable for diesel engine on blending, at a blending percentage level of 20% with conventional diesel fuel. Since the obtained transesterified biofuel can be used as an alternative fuel for diesel engines. The several journal reports and find outs from experimental investigation clearly depicts that the efficiency of the transesterified biofuel mainly depends upon the amount of catalyst adding and type of catalysts present in the biofuel, whether it is homogenous or heterogeneous catalyst is suitable with methanol. Finally, from the analysis made from biodiesel fuel. Coconut Oil Biodiesel fuel has less emission characteristics than that of the diesel fuels.


Sign in / Sign up

Export Citation Format

Share Document