Bearing capacity behaviour of prestressed anchor cable under slope blasting excavation

2021 ◽  
Vol 14 (9) ◽  
Author(s):  
Guofeng Li ◽  
Ning Li ◽  
Chong Yu ◽  
Mingming He
2018 ◽  
Vol 38 ◽  
pp. 03007
Author(s):  
Yong Xing Ji ◽  
Yuan Jie Xiang ◽  
Xiao Yong Zhao

The P-S curves of prestressed anchor cable are obtained by field pull-out tests in the red-clay stratum in Guiyang area. The P-S curves of different theoretical models are discussed base on the theoretical analysis. The elastic and plastic displacement of prestressed anchor cable are analyzed. The results shows that, the anchoring effect are mainly effected by the red-clay mechanic properties in the red-clay stratum; the P-S curve of anchor bolt can be fitted well by the exponential model and conformed to the actual; the plastic displacement is used to anchor’s damage index are more truthfulness in the red-clay stratum.


2013 ◽  
Vol 477-478 ◽  
pp. 596-599
Author(s):  
Jian Qing Wu ◽  
Hong Bo Zhang ◽  
Xiu Guang Song ◽  
Yi Fan Yu ◽  
Chao Li

With the highway subgrade fill increasing, traditional retaining wall cannot meet the requirements for supporting. To meet this requirement, the prestressed opposite-pull retaining wall was put forward. Due to the anchor pull of the new-style retaining wall, its bearing capacity was enhanced, but the stress is not clear. In order to reveal the stress distribution of the prestressed opposite-pull retaining wall, FLAC3D was adept to do numerical simulation on the new-style retaining wall. It simulated three conditions of the wall with no anchor, with anchor but without prestress and with prestressed anchor. The results showed that, after the layout of prestressed anchor, the lateral earth pressure of the region near the anchor increased with the increase of prestress, the lateral earth pressure of the wall is parabola distribution. The lateral earth pressure was larger than that of the wall with no anchor and with anchor but without prestress. The bearing capacity of the retaining wall was effectively improved.


2019 ◽  
Vol 10 (1) ◽  
pp. 266
Author(s):  
Jian Li ◽  
Shanxiong Chen ◽  
Fei Yu ◽  
Lingfa Jiang

Using prestressed anchor cables is one of the most common approaches for reinforcing slopes. By establishing a calculation model for a high and steep slope, the changes of displacement of slope foot and increment of force on the cables under different prestresses were calculated. Furthermore, the influence of prestress on the changes of displacement of slope foot and force on the cables was analysed. By analysing the changes in force on cables in different parts of the slope, the reinforcement mechanism of a prestressed anchor cable on the slope was attained. The result showed that the reinforcement effect of prestressed anchor cable on the slope was mainly attributed to it effectively restricting the displacement of sliding mass in the slope, while the effect of cables in the lower part of the slope was more significant than that of those in the upper part of the slope. Therefore, to reduce the number of cables, decrease the construction difficulty of cables and save money, it is feasible to remove cables in the range of the upper-third of the slope. Afterwards, by improving the cable prestress in the range of the lower-third and reducing the cable prestress in the middle, the safety factor of the slope can satisfy design requirements, thus reinforcing the slope.


2016 ◽  
Vol 858 ◽  
pp. 10-14
Author(s):  
Jun Chao Ma ◽  
Cheng Bin Yang ◽  
Hong Ming Yu

To solve the anti-float problems of underground buildings (structures) more economically, environmentally and effectively. The paper putted forward a construction technology of revolving conical pullout anchors based on researching and improving to the traditional pullout measures. That was a method that the conical anchor head was installed on the drilling pipe and screwed into the stable soil under the influence of drilling pipe. When pulling the drilling pipe, the fine aggregate concrete were poured into the edge. Furthermore, prestressed anchor cable should be strained which connected with the anchor head to keep a good connect with the beam so that it could improve pullout capacity. The conundrums of long construction period and high cost had effectively solved. This technique also had provided great reference values for the congener construction.


2012 ◽  
Vol 557-559 ◽  
pp. 366-370 ◽  
Author(s):  
Jiang Tao Xia ◽  
Cheng Zhong Yang ◽  
Shu Fang Wang

Based on the investigation and analysis of the causes of Dongchuan landslide, as well as on the stability analysis of Dongchuan landslide No. 1 and No. 2,it was presented by use of surface drainage, anchor pile, prestressed anchor cable lattice beam and other engineering measures on Dongchuan landslide to conduct comprehensive management. The deformations of treatment landslide were monitored and analyzed. The monitoring results show: the greatest deformation of the landslide is 8mm and the slope is a basically stable. Therefore, combined anchor piles, prestressed anchor cable lattice beam with drainage can well manage landslid


2020 ◽  
Vol 2020 ◽  
pp. 1-10
Author(s):  
Ping Wang ◽  
Li Ding ◽  
Yuan-jun Ma ◽  
Tao Feng ◽  
Guang-jing Sun ◽  
...  

Through the analysis of the project of gob-side entry retaining in the deep gangue filling 2305S-2# working face of the Xinjulong coal mine, the principle and technology of surrounding rock control of gob-side entry retaining along the deep mining face are discussed. It is found that the use of gangue to fill the goaf of the deep mining face can effectively alleviate the occurrence of violent strata pressure, which is the basis for realizing entry retaining along the goaf. In the Xinjulong coal mine, the gangue wall and concrete-filled steel tube columns are used as roadside support structure. Anchor bolt + W steel belt are used as advance support, monomer column + hinged beam are used as temporary support, and long anchor cable + beam are used as permanent support. Gob-side entry retaining of deep mining working face is successfully realized. The actual measurement results show that the bearing capacity of gangue wall increases slowly, and the deformation is large. The concrete-filled steel tube column has a certain drilling bottom, and the roof cable is easily broken on the side of the remaining roadway. It is necessary to strengthen the lateral constraint of the gangue wall, limit the deformation of the gangue wall, and improve the bearing capacity of the gangue wall. The bottom of the concrete-filled steel tube column needs to be installed with a large backing plate to control the bottom drilling amount, and the roof anchor cable of the roadway must have a certain elongation to realize the coordinated deformation of the anchor cable and the roof.


2021 ◽  
Vol 2021 ◽  
pp. 1-13
Author(s):  
Zuo-ju Wu ◽  
Zhi-jia Wang ◽  
Jun-wei Bi ◽  
Xiao Fu ◽  
Yong Yao

The combined retaining structure has gradually received considerable attention in the slope engineering, due to its good reinforcement effects. However, most of the published research studies were focused on the seismic responses of the single-formal supporting structure only. The investigations of dynamic responses of the combined retaining structures are scarce, and the current seismic design is conducted mainly based on experiences. In this work, a series of large-scale shaking table tests were conducted to investigate the seismic responses of the combined retaining structures (i.e., prestressed anchor cables and double-row antisliding piles) and the reinforced slope under seismic excitations, including amplification effect of internal and surface acceleration of the reinforced slope, distribution and change of prestress of the anchor cable, dynamic response of soil pressure behind the antislide pile, and horizontal displacement of the reinforced slope surface. Test results show that, supported by the reinforcement of composite support system, the slope with the multilayer weak sliding surface can experience strong ground motion of 0.9 g. The load of the antisliding pile has reached 80% of its bearing capacity, and the load of the anchor cable has reached 75.0% of its bearing capacity. When the seismic intensity reaches 0.5 g, the slope surface has an obvious downward trend, which will make the corresponding soil pressure suddenly increase after the antislide pile. At the potential sliding zone, the axial force of the anchor cable will increase suddenly under the action of earthquake; after the earthquake, the initial prestress of the anchor cable will be lost, with the loss range of 17.0%∼23.0%. These test results would provide an important reference for the further study of the seismic performance of such composite support structure.


2021 ◽  
Vol 2021 ◽  
pp. 1-10
Author(s):  
Xuhe Gao ◽  
Weiping Tian ◽  
Jiachun Li ◽  
Hongliang Qi ◽  
Zhipei Zhang

The establishment of the prestressed cable loss prediction model is a difficult problem faced by the popularization and use. This article aims at the problem of the loss of anchor cable prestress over time in the soil-rock dual-structure slope. We relied on the soil-rock dual-structure slope treatment project of section K5 + 220-K5 + 770 of Jiangwen Expressway and monitored the prestress loss of the anchor cable in the slope through the anchor cable meter with built-in vibrating wire sensor. Using regression analysis and segmented modelling methods, we established a comprehensive mathematical improvement model, analyzed the applicability of the improved model, and obtained the error range, 0.04%–8.9%. This work offers a new approach for predicting anchor cable prestress loss, which has certain practical value for the use of prestressed anchor cables.


Sign in / Sign up

Export Citation Format

Share Document