Reaction kinetics of portland cement mortars hydrated at different temperatures

1992 ◽  
Vol 22 (1) ◽  
pp. 112-120 ◽  
Author(s):  
Knut O. Kjellsen ◽  
Rachel J. Detwiler
Keyword(s):  
Portland Cement ◽  
Reaction Kinetics ◽  
Cement Mortars ◽  
Different Temperatures ◽  
Kinetics Of

scholarly journals Reaction Kinetics of Iron Oxides in Ok Tedi Magnetite Skarn Ore

2020 ◽  
pp. 1-13
Author(s):  
Mary Kama ◽  
Kaul Gena ◽  
Tindi Seje Nuru
Keyword(s):  
Reaction Kinetics ◽  
Papua New Guinea ◽  
Iron Reduction ◽  
New Guinea ◽  
Reaction Rate Constant ◽  
Close Monitoring ◽  
Significant Difference ◽  
Different Temperatures ◽  
C 30 ◽  
Kinetics Of

Magnetic skarn ore (MSO) is one of the major copper bearing ore extracted by the Ok Tedi Copper Mine in Papua New Guinea (PNG). Copper minerals are recovered by flotation while the iron not associated with copper are discarded as tailings. The objective of this investigation was to determine the iron ore reduction kinetics for the Ok Tedi MSO and ascertain if it can be processed to produce sponge iron for a mini steel plant in Papua New Guinea. SEM-EDAX analyses of the Ok Tedi MSO indicated 10.1% C, 30% O, 0.6% Mg, 1.1% Si, 21.1% S, 0.8% Ca and 36.2 % Fe. Most of the iron is in sulfide form. Both naturally occurring and roasted sinters of Ok Tedi MSO samples of different particle sizes were reduced by charcoal carbon at three different temperatures and seven different reduction times. Analyses of the reduced products indicated a metallic iron content of more than 65 wt. % on average. Results showed that there was no significant difference in reduction between fluxed and control materials. Only a slight increase in kinetics with reduced particle size, hence the reaction rate constant (K) did not vary much within the temperatures investigated. Reaction kinetics increases with increasing reduction time at 900°C. Therefore, more iron reduction is observed with particles of 106 µm size. In addition, the results also confirmed that the reduction energy used was higher at 800°C and lower at 1000°C. In conclusion, iron reduction can be improved but close monitoring of temperature and reduction times are essential to determine the reaction kinetics of the Ok Tedi MSO.

scholarly journals Degradation Kinetics of Anthocyanins in Shalgam Beverage

2019 ◽  
Vol 7 (2) ◽  
pp. 282
Author(s):  
Adnan Bozdoğan ◽  
Kurban Yaşar
Keyword(s):  
Activation Energy ◽  
Reaction Kinetics ◽  
Half Life ◽  
Degradation Kinetics ◽  
Production Method ◽  
Order Reaction ◽  
Different Temperatures ◽  
Traditional Production ◽  
Effects Of Temperature ◽  
Kinetics Of

This research was performed to elucidate the effects of temperature on the degradation kinetics of anthocyanins in shalgam beverage. Shalgam beverage was produced according to traditional production method. Then, it was kept at three different temperatures (65°C, 75°C, and 85°C) for 12 hours, and the relevant quantities of anthocyanins were determined thereafter. The research revealed that degradation of the anthocyanins was well described with a 1st-order reaction kinetics model and the R2 values varied in the range of 0.9059-0.9715. Activation energy of the reaction was determined to be 48537 Joule/mole. The half-lives of anthocyanins at 65°C and 75° C, and 85°C were found to be 138.63, 136.72, and 51.57, respectively. Compared the half-life periods at different temperatures, anthocyanins were found to be more resistant at 65°C and 75°C than at 85°C.

5-hydroxymethyl furfural formation and reaction kinetics of different pekmez samples: effect of temperature and storage

2012 ◽  
Vol 8 (4) ◽  
Author(s):  
Rasim Alper Oral ◽  
Mahmut Dogan ◽  
Kemal Sarioglu ◽  
Ömer Said Toker
Keyword(s):  
Reaction Kinetics ◽  
Arrhenius Equation ◽  
Storage Period ◽  
Effect Of Temperature ◽  
Temperature Changes ◽  
Juniperus Communis ◽  
Hydroxymethyl Furfural ◽  
Different Temperatures ◽  
And Storage ◽  
Kinetics Of

Abstract Pekmez (molasses) is a traditional food commonly produced from grape and other kind of fruit juices by evaporation processes. In this study, 5-Hydroxymethylfurfural (HMF) level of various pekmez samples was investigated during storage at different temperatures. HMF content of apricot, mulberry, carob, grape, Juniperus communis pekmez changed from 133.0 ppm to 1060.5 ppm, from 88.2 to 1921.5 ppm, from 11.1 to 1153.6 ppm, from 75.5 to 2077.0 ppm, from 19.9 to 280.1 ppm throughout eight months storage period, respectively. Samples of pekmez from the Juniperus communis had the minimum k values for each temperature that means HMF formation in these samples were slower than other pekmez types. The kinetic data analysis for HMF formation during storage was performed and an Arrhenius equation was used to determine the effect of temperature on reaction kinetics of 5-HMF formation in pekmez samples. Ea values were found between 10.58–37.73 (kcal/mol). Apricot pekmez was found as the least sensitive sample to HMF formation resulted from temperature changes.

Change in reaction kinetics of a Portland cement caused by a superplasticizer — Calculation of heat flow curves from XRD data

2012 ◽  
Vol 42 (2) ◽  
pp. 327-332 ◽  
Author(s):  
D. Jansen ◽  
J. Neubauer ◽  
F. Goetz-Neunhoeffer ◽  
R. Haerzschel ◽  
W.-D. Hergeth
Keyword(s):  
Heat Flow ◽  
Portland Cement ◽  
Reaction Kinetics ◽  
Flow Curves ◽  
Kinetics Of ◽  
Heat Flow Curves

Comparative Labelling and Biokinetic Studies of 99mTc-EDTA(Sn) and 99mTc-DTPA(Sn)

1977 ◽  
Vol 16 (01) ◽  
pp. 30-35 ◽  
Author(s):  
N. Agha ◽  
R. B. R. Persson
Keyword(s):  
Complex Formation ◽  
Significant Influence ◽  
Room Temperature ◽  
Ph Value ◽  
Maximum Activity ◽  
Reduction Step ◽  
Labelling Yield ◽  
Different Temperatures ◽  
Kinetics Of

SummaryGelchromatography column scanning has been used to study the fractions of 99mTc-pertechnetate, 99mTcchelate and reduced hydrolyzed 99mTc in preparations of 99mTc-EDTA(Sn) and 99mTc-DTPA(Sn). The labelling yield of 99mTc-EDTA(Sn) chelate was as high as 90—95% when 100 μmol EDTA · H4 and 0.5 (Amol SnCl2 was incubated with 10 ml 99mTceluate for 30—60 min at room temperature. The study of the influence of the pH-value on the fraction of 99mTc-EDTA shows that pH 2.8—2.9 gave the best labelling yield. In a comparative study of the labelling kinetics of 99mTc-EDTA(Sn) and 99mTc- DTPA(Sn) at different temperatures (7, 22 and 37°C), no significant influence on the reduction step was found. The rate constant for complex formation, however, increased more rapidly with increased temperature for 99mTc-DTPA(Sn). At room temperature only a few minutes was required to achieve a high labelling yield with 99mTc-DTPA(Sn) whereas about 60 min was required for 99mTc-EDTA(Sn). Comparative biokinetic studies in rabbits showed that the maximum activity in kidneys is achieved after 12 min with 99mTc-EDTA(Sn) but already after 6 min with 99mTc-DTPA(Sn). The long-term disappearance of 99mTc-DTPA(Sn) from the kidneys is about five times faster than that for 99mTc-EDTA(Sn).

Impact Of Synthesis Route on the Water Oxidation Kinetics of Hematite Photoanodes

2020 ◽  
Author(s):  
Camilo A. Mesa ◽  
Ludmilla Steier ◽  
Benjamin Moss ◽  
Laia Francàs ◽  
James E. Thorne ◽  
...  
Keyword(s):  
Oxygen Vacancy ◽  
Reaction Kinetics ◽  
Water Oxidation ◽  
Oxidation Kinetics ◽  
Oxidation Reaction ◽  
Charge Accumulation ◽  
Optical Signals ◽  
Current Voltage ◽  
Voltage Performance ◽  
Kinetics Of

<p><i>Operando</i> spectroelectrochemical analysis is used to determine the water oxidation reaction kinetics for hematite photoanodes prepared using four different synthetic procedures. Whilst these photoanodes exhibit very different current / voltage performance, their underlying water oxidation kinetics are found to be almost invariant. Lower photoanode performance was found to correlate with the observation of optical signals indicative of charge accumulation in mid-gap oxygen vacancy states, indicating these states do not contribute directly to water oxidation.</p>

Sign in / Sign up

Export Citation Format

Share Document